Question about 1995 Ford Contour

Open Question

Where is the Vehicle Speed Sensor located on a 1995 Ford Contour (2.0) ? - I see a "turbine speed" connector on the side of the transmission in the manual - no VSS.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad
  • 373 Answers

SOURCE: Speed Sensor

HI..
The Speed sensor on your Honda Accord 97.
Is located on the Transmission.
If you follow the Lower Radiator hose from the rad to the engine.
The hose end on the Thermostat housing.
OK.. Just on direction of the thermostat housing .
Under the housing you Will see on the transmission the Speed sensor, with a connector of 3 wires. Is the only sensor at this
Part of the Transmission..

Ok. I hope this work on your question.
Thank you for use fixya..

Posted on Sep 09, 2008

Ad
localwonder
  • 6784 Answers

SOURCE: speedometer doesn't work and transmission wont shift

Hi, make sure you check the speed cable that runs to the engine, it may be severed. As for the tranny, you have some major gear problems that will require pulling this transmission for a deeper look. i would have a look at the transmission filter as well.

Posted on Mar 11, 2009

mecanica03
  • 917 Answers

SOURCE: P0501 Vehicle Speed Sensor (VSS) Range/Peformance Problem

ok, replace the vss , located on the transm. case, its causes others troubleshoots likes abs,brake lights

Posted on Apr 17, 2009

  • 316 Answers

SOURCE: input/turbine speed sensor circuit

Your speed sensor, is located on top of the transaxle, near the starter. To access it, remove the battery, then remove the battery tray (4 10mm bolts). You will see wires coming from the lower oxygen sensor, and they snap into the bracket that holds the speed sensor in place. The actual speed sensor has a 2 wire clip on it, and is held in place by the bracket and a 10mm bolt.

Posted on Apr 20, 2009

emissionwiz
  • 78267 Answers

SOURCE: where is the speed sensor on a 1995 Ford econoline van

the sensor is located on the driver side of the transmission case

Posted on Jun 19, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the speed sensors located on a 2001 Tahoe


Vehicle Speed Sensor (VSS) - Allison
On the left side of the transmission
Automatic Transmission Electronic Component Views in Automatic Transmission - Allison
Automatic Transmission Inline Harness Connector End View in Automatic Transmission - Allison
Vehicle Speed Sensor (VSS) - 4L60-E
On the left side of the transmission
Automatic Transmission Electronic Component Views in Automatic Transmission - 4L60-E
Automatic Transmission Related Connector End Views in Automatic Transmission - 4L60-E
Vehicle Speed Sensor (VSS) - 4L80-E
On the left side of the transmission
Automatic Transmission Electronic Component Views in Automatic Transmission - 4L80-E
Automatic Transmission Related Connector End Views in Automatic Transmission - 4L80-E
Vehicle Speed Sensor (VSS) - Transfer Case
On the top left side of the transfer case
Transfer Case Control Component Views in Transfer Case - NVG 246 - NP8 (Two Speed Automatic)
Transfer Case Control Connector End Views in Transfer Case - NVG 246 - NP8 (Two Speed Automatic)
Vehicle Speed Sensor (VSS) Adapter (4WD Only) - 4.8L,5.3L,6.0L
On the left side of the transmission
Engine Controls Component Views in Engine Controls - 4.8L,5.3L,6.0L
Engine Controls Connector End Views in Engine Controls - 4.8L,5.3L,6.0L
Vehicle Speed Sensor (VSS) Adapter (4WD Only) - 8.1L
On the left side of the transmission

Mar 07, 2016 | Cars & Trucks

1 Answer

VEHICLE SPEED SENSOR LOCATION


  1. REMOVE BATTERY
  2. REMOVE AIR CLEANER ASSEMBLY
  3. DISCONNECT INPUT TURBINE SPEED SENSOR CONNECTOR
  4. REMOVE INPUT TURBINE SPEED SENSOR
Check attached drawing.

26068087-aeck0jymi5oleu25hgksiiwr-4-0.gif

Jan 25, 2016 | Lexus RX 300 Cars & Trucks

1 Answer

O/d off light is flashing


Needed transmission oil replace. If problem came back, replace the the turbine speed sensor (or transmission speed sensor, same thing). I fixed the O/D light flashing problem, but I did it in reverse order. Hopefully it is just dirty transmission oil that cause the problem and you can save yourself from replacing the turbine speed sensor.

Jan 17, 2014 | 1996 Ford Contour

1 Answer

2000 ford explorer input turbine speed sensor. code po715 was pulled on the obd scanner.does any 1 no were this sensor is located at on my transmission, i beleiv e it has the 55r5e trans but not quit sure....


the is also known as sensoer c it is your pressure control solenoid. if you drop the transmission pan and remove the transmission filter it is on the side of the valve body. DO NOT REMOVE THE VALVE BODY PLEASE12_7_2012_2_21_36_am.gif

Dec 07, 2012 | 2000 Ford Explorer

1 Answer

Could you please tell me where the transmission speed censor is located


There are 2 speed sensors on the transmission. The input speed sensor is inside the side cover. remove the cover. disconnect electrical connector. remove retaining clip from cover. remove sensor.

The other sensor is the vehicle speed sensor. ( VSS ) on the left side of transmission, unplug the sensor. remove bolt, remove sensor. reassemble

Paul

Aug 08, 2011 | 2001 Buick Park Avenue

1 Answer

Espesific location of turbine speed sensor on transmission 1998 cadilac deville


their is no such thing as a turbine speed sensor ,as in the torque converter ,you measure the speed of this from the RPM of the engine their is no other sensor that iam aware off ,the next sensor is the road speed sensor or mph sensor which would be on the passenger side transmission shaft drive just on top right by the differential .Their is no sensor measuring the gearbox side of the torque converter speed as it will be the same as the RPM but allowing for slip which is why the torque converter is their in the first place and their is a specific graph for this sort of information with variables for vehicle weight /power /gear ratio /load .

Mar 11, 2011 | 1998 Cadillac DeVille

2 Answers

2000 windstar transmission code 715 turbine speed sensor need to replace, where is it and should I do it.


turbine speed sensor is the torque converter speed ,but where and how it works i do not know,i would buy a manual vehicle nyself at least it doesnt cost the earth when the clutch wears out

Jul 16, 2010 | 2000 Ford Windstar

2 Answers

Transmission input output speed sensors


The speed sensor is on the tailshaft of the transmission,on the passenger side of the car,it has 3 wires. The output sensors are located on the front of the transmission about mid-way up the housing & only have 2 wires. Note the output sensors are not responsible for vehicle speed. Only the output shaft speed is recorded. They are for finding the correct cvi(clutch volume index) only. If you have a cvi issue,the transmission is toast.

Jun 26, 2009 | 2001 Dodge Caravan

3 Answers

Locate Speed Sensor on 95 Honda Accord Lx


on the top side of the tans next to the motor should be strate down from the throttle body

Nov 15, 2008 | 1995 Honda Accord

1 Answer

1995 FORD Contour GL V6 AUTO ; Trans.> speed sensor prob.


The speed sensor signal goes through the speedo cluster and then to the PCM, this is the main computer that controls trans and engine functions, in order to see if the PCM is getting the speed sensor signal you need to install what we call a break out box to monitor the signal and see where it is being lost, it could be the connector ar the transmission, pull it off and make sure the wires are not broken inside the insulation near the connector plastic shell, There is no way to fix this without these checks.

Sep 11, 2008 | 1995 Ford Contour

Not finding what you are looking for?
1995 Ford Contour Logo

Related Topics:

164 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

78267 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

fordexpert

Level 3 Expert

5655 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...