Question about 1999 Chevrolet Venture

1 Answer

I need to find the location on my 1999 chevy venture van for the oil filter

Posted by Anonymous on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 5 Answers

Front of engine, must bend skid plate out of the way. Look at the front of engine just a little towards passenger side.

Posted on Jul 25, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Where is the evap solenoid located on 99 chevy venture mini van

Which EVAP solenoid , vent or purge ? The purge is under the hood on the engine an the vent is under the vehicle near the EVAP charcoal canister an the fuel tank.

Nov 10, 2017 | 1999 Chevrolet Venture

1 Answer

Where is the vacuum modulator located on a 1999Chevy Venture van

Try adjustiung the Trans pressure cable.. it attaches to the throttle body... This is something you would have removed .. and reinstalled,

May 19, 2014 | Chevrolet Venture Cars & Trucks

1 Answer

Where is the powertrain control module located in a chevy venture 2003 van?

The pcm is located inside the airbox in the drivers side front corner of the engine compartment. You need to remove the air filter, and it is an aluminum box with fins at the bottom of the box.

Aug 18, 2011 | 2003 Chevrolet Venture Passanger

1 Answer

Where is the powertrain control module located in a 2003 chevy venture van? Thank you

It is located in the air cleaner.Take off the air filter cover/air boot.\Then there are 2 8mm headed bolts on the top of the air cleaner.remove the two bolts and pull off the cover.The pcm is located behind there.

Aug 18, 2011 | 2003 Chevrolet Venture Passanger

1 Answer

How is the oil filter mount, connected to an 3.4Lt engine block, of a 1999 Chevy Venture Van? Are there O-rings, or gaskets?

Hi Friend:

Your Oil Filter is a Typical Screw on Filter with the Rubber Gasket Already On the New Oil Filter.

So just use a Oil Filter Wrenh yours is a Fairly Small Filter.So Get the Wrench and Slide it Over and Around the Oil Filter And Turn it Counter Clock-Wise. Be Sure to Have something on the Groubnd Under the Vehicle to Catch the Oil thats in the Crankcase & Filter.

Go to your Local parts store and buy a new filter and you can then see what size Oil Filter Remover wrench. you'll need.

Then just Screw new Filter back on where Old Filter came off. Becarefull not to get it on Crooked it will Strip out the Threads on the Filter and The Oil Pump which is where it comes off from.

This will get you going.

Thanks for Using FixYa From: d_hubbs

Aug 17, 2010 | 1999 Chevrolet Venture

2 Answers

Need to change in my 1999 chevy venture van fuel filter. How to do it and where is the fuel filter located

look under it on the frame rails, the filter it held to the frame about middle of van ,just follow the fuel lines from tank ,easy to change , ,hope this helps you, thanks robert b.

Jul 08, 2009 | 1999 Chevrolet Venture

2 Answers

Lights dimming and brightening on 2000 Chevy Venture

2000 chevy venture run good but my lights flickers and have to jump. After I jump the van and put my meeter on the battery its reading 14.volts at idle. I can drive around to store cut the van off come out it starts fine leave it overnite and it don't started.

Nov 21, 2008 | 1999 Chevrolet Venture

1 Answer

What is a oil sending unit on 99 chevy venture van?

easy to change u just need a special tool for removed on front of motor at right of oil filter its look like a coolant sensor or a little bottle with a connetor removed the connector and take the tool to remove

Oct 11, 2008 | 1999 Chevrolet Venture

1 Answer

Reset factory alarm 1999 Chevy Venture

passager side lock and unlock the door try it out pierre

Oct 04, 2008 | 1999 Chevrolet Venture

Not finding what you are looking for?
1999 Chevrolet Venture Logo

142 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

81400 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22359 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides