Question about 1993 Dodge Dakota

2 Answers

The steering wheel on my 1993 dodge dakota is sticky and ive tried everything i can think of to clean it with to no avail. It's almost like it permeates out from the wheel.

Posted by on


2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.


    An expert whose answer got voted for 20 times.


    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 109 Answers

It's the manufacture compounds coming out of the material, just replace it, I've seen this on trucks and cars, and I just replace it with a good used one. you don't need the air bag module if equiepped.

Posted on Jul 20, 2010

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Master
  • 4,070 Answers

The problem may be that it's leather. If so get something made for leather. Sometimes the heat in the vehicle will cause a change in it. You may just have to get a steering wheel cover.

Posted on Jul 20, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My89 dodge dakotas steering is copletely loose and wheels dont turn at all everything seems to be attached,whats the problem

where to start? any steering fluid? steering belt ok? steering wheel tight? steering pump ok? front end pitman and idler arm(s) ok? front end bushings or rod ends ok? steering box gears steipped? steering rack could be stripped. check all these first then get back to me.

If you need further help, reach me via phone at

Jun 05, 2016 | Dodge Cars & Trucks

1 Answer

Remove Steering wheel Dodge Dakota

Disconnect the negative battery cable so the air bag doesnt deplore their to are two screw on the steering wheel to remove the air bag then uses a steering wheel puller to remove steering wheel if you dont have a puller go a part store to rent one.

Jul 25, 2012 | 2001 Dodge Dakota

1 Answer

My steering wheel is locked, ive tried everything cant get it to unlock.. need to remove steering wheel, to get to a rod that must be stuck... how do i go about that...?????

Is the front wheel jammed against a curb or rock so it cant move?

If so try to move the car a couple feet and try to unlock at the same time.

Good Luck

Jul 30, 2011 | 1993 Geo Metro

1 Answer

How to remove steering wheel for 1993 dodge dakota?

undo the nut in the middle then use a special puller

Jan 13, 2011 | 1993 Dodge Dakota

1 Answer

How to change an ignition switch for a 93 dodge dakota. What tools are needed?

first you will need to remove the steering wheel, you will need a steering wheel puller, then you will need to remove the steering wheel lock plate, you will need a lock plate press. then you will need to remove the turn signal switch , you will nee a Phillips screwdriver #2 for this, then you will see a 4 tourx head screws three large and 1 small remove the small one only and slide the ignition switch out of the collum, then reverse procedure to put it back can borrow most of the tools from Auto Zone.......HAVE FUN

Dec 03, 2010 | 1993 Dodge Dakota

1 Answer

I have a 1988 Dodge Dakota 4x4 that is stuck in park

Try wiggling the steering wheel left and right as you turn the key - sometimes the steering wheel lock can stop the key from turning if there is pressure on it.

Nov 29, 2010 | 1988 Dodge Dakota

1 Answer

How do you change the ignition lock cylinder on a 1990 dodge dakota?

I just recently had to replace the ignition lock cylinder on a 1990 Dodge Dakota. If yours is anything like mine the ignition lock cylinder you need is for a 1989 Dodge Dakota. All you have to do to replace it is remove the center of the steering wheel and the steering wheel. Next you will have to remove the lock plate. After you do that you should be able to pull everything else out of the way. Then all you have to do is take a flathead screw driver and pop the old ignition out. You will need a steering wheel puller and a steering wheel lock plate remover. The best thing to do with the lock cylinder is to go to autozone or whatever store you use and match it up. Good luck

Nov 28, 2010 | 1990 Dodge Dakota

1 Answer

Hi i have a 1993 dodge dakota 2 wheel drive ext

when the 4-way flash you won't get the signal work!

Feb 27, 2010 | 1993 Dodge Dakota

1 Answer

Dakota 2001 steering wheel gizmos dead

I'm thinking the airbag clock spring is guilty. Right behind the steering wheel.

Nov 24, 2008 | 2005 Dodge Dakota

1 Answer

Power Steering pump pulley

You'll need a power steering pump puller available at most part stores. They are very easy to use and it should have directions in the package on proper use. Just think if you can do yours, you can do most of the domestics pumps out there.

Jun 10, 2008 | 2004 Dodge Dakota

Not finding what you are looking for?

Open Questions:

See all 1993 Dodge Dakota Questions

1993 Dodge Dakota Logo

Related Topics:

140 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts


Level 3 Expert

81400 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides