Question about 1996 Acura TL Series

1 Answer

How to replace a starter in a 1996 acura tl 2.5?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 2,272 Answers

  • Since the starter involved the electrical system, disconnect the negative battery terminal to avoid any electrical shorts or other issues.The starter is located on the driver's side just below the intake manifold and near the firewall. Remove the transmission dip stick, which partially obstructs the starter.Loosen the top bolt on the starter with a 14-mm wrench and loosen the bottom bolt with a 17-mm wrench a couple of turns but do not remove the bolts.After both of the bolts are loose, remove the top bolt and then the bottom bolt and pull the starter out of the transmission bell housing. You will have to angle the starter a little to remove it.Remove the wire that goes to the ignition switch. The wire should simply slide off. Use the 9-mm wrench to disconnect the nut that holds on the solenoid wire.
  • Place wires on the new or remanufactured starter and place it back in the bell housing
  • Replace the top and bottom bolts.Put transmission dipstick back in the gearbox and reconnect the battery.



  • Posted on Aug 29, 2010

    Ad

    1 Suggested Answer

    6ya6ya
    • 2 Answers

    SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

    Hi there,
    Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

    Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

    Here's a link to this great service

    Good luck!

    Posted on Jan 02, 2017

    Ad

    Add Your Answer

    Uploading: 0%

    my-video-file.mp4

    Complete. Click "Add" to insert your video. Add

    ×

    Loading...
    Loading...

    Related Questions:

    1 Answer

    1996 acura tl wont start


    charge the battery?? or jump the car.. could be a dirty battery connection, not enough power getting to starter

    Sep 12, 2012 | 1996 Acura TL Series

    1 Answer

    Where is the starter on the Acura TL 2.5 located?


    wire comeing off battery will lead you to starter dissconnect battery before changeing starter

    Feb 27, 2011 | 1996 Acura TL Series

    1 Answer

    I need to change the starter on my acura tl 3.2of the year 1996 and not find it on the engine let me know in theengine is


    starter is located at the driver side bottom of the engine; near firewall. left side wheel, driveshaft and exhaust needs to be removed to access it. not an easy job....

    Jan 23, 2011 | 1996 Acura TL Series

    2 Answers

    1996 acura 2.5tl wiring diagram


    picture diagram of blower motor resistor for 96 acura 2.5tl

    Dec 02, 2010 | 1996 Acura TL Series

    2 Answers

    Where can i find a picture of the starter on a 1996 acura 2.5tl. trying to replace it


    you can purchase a starter at an auto supply house like autozone, pepboys, etc... You can also purchase a Chilton's repair manual or some similar repair manual for the vehicle that will walk you through step by step at the supply house. When in doubt contact a professional auto mechanic.

    Hope my advice helps please do not forget to rate/vote my advice.

    Stormi

    Nov 15, 2010 | 1996 Acura TL Series

    1 Answer

    I have a '96 Acura TL 2.5, and I need to change out the starter. How do I go about doing this?


    my 96 2,5 tl starts when it wants 2 i got a new batt and the alt is good i makes a click sound around the area by the starter and if i get a jump i starts right up how do i go about changing the sterter without breaking that seal on the intake it sits up under

    Jun 24, 2009 | 1996 Acura TL Series

    1 Answer

    Where is the starter on a 1996 Acura 3.2 TL? On a


    grantgga2: I don't think this is one you are going to want to try to change out.
    It entails having to remove the left axle and part of the exhaust pipe to gain access to the starter. At that point, you have one bolt which goes in at the bottom from the starter side and bolts to the engine. The other bolt passes through the trans axle housing and bolts into the starter, pulling it up to the engine.
    SCARED YA HUH? I'D SAY FROM A 1-10 FOR A WEEK END WARRIOR, IT WOULD BE ABOUT A 6.
    Was I helpful?

    May 03, 2009 | 1996 Acura TL Series

    2 Answers

    Where is the starter located on a 1996 Acura 2.5 TL?


    it is at the rear bottom of engine, points inside the bell housing of the transmission, u will need to jack the car off the ground to see it and get at it for repAIR

    Feb 28, 2009 | 1996 Acura TL Series

    Not finding what you are looking for?
    1996 Acura TL Series Logo

    1,787 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Acura Experts

    Marvin
    Marvin

    Level 3 Expert

    83096 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22382 Answers

    Ronny Bennett Sr.
    Ronny Bennett Sr.

    Level 3 Expert

    6927 Answers

    Are you an Acura Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...