Question about Toyota Passenger

1 Answer

Left passenger door toyaota hiace electronic opener stop working.passenger try to close door manually can the problem be fixed

Posted by on

  • anthony_c484 Jul 20, 2010

    Luke could not fix my problem was passing me on to another expert but i have heard nothing

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 662 Answers

I assume that you have central locking, and the passenger side is not working..........if this is the case.....

what has probably happened is that the central door lock motor has failed.

This can be fixed by replacement only, as MOST of these lock motors are fairly cheap and they are a sealed unit (cannot open to fix them). It will be located behind the door trim.....if you are inexperinced in car repairs, I would not advise you to do it yourself, as there is a few things that could go wrong, and it would not cost that much to have it fixed anyway.

When you do have it repaired, ensure that you ask for a heavy duty motor to be installed...they cost a Little extra, but will last 2-3 times longer than the general purpose one and you will notice the difference in the strength and durability of this one compared to the others.

Dont replace all the others just yet, just one by one as needed.

Posted on Jul 20, 2010

  • 1 more comment 
  • anthony_c484 Jul 20, 2010

    its the toyota commuter . the locking mnechanism is working but the sliding gear thatn opens the door or slides it along a runner is not

  • Luke Bradford
    Luke Bradford Jul 20, 2010

    Thank you for clarifying this point, as I have not had much experince with the electric sliding mechanism, I will pass you to another expert..........I hope you are able to work it out.......

  • Luke Bradford
    Luke Bradford Jul 20, 2010

    sorry I could not it from my end, at the bottom of the page, should say that you are not satisfied with this response, and would like another expert.......sorry i did not clarify this

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Sliding door fails to latch


There is no "switch". The Sliding Doors should be manual anytime you try to open or close them. If not: then there is problem in the electronic system or the physical/mechanical side where something is jamming the door from opening or closing.

Dec 31, 2009 | 2002 Chrysler Town & Country

1 Answer

2002 toyota hiace van front wiper reservoir refill point


I have the 1990 model and just so happened to stumble on its unusual location today as I was replacing the door hinges. On the passenger side open the door and look above the step, there should be a little plastic cap with the wiper icon on it. hope this helps!

Oct 23, 2009 | 2002 Toyota Highlander

1 Answer

Automatic Sliding Door problems on 2005 Dodge Caravan


We have the same problem, just opposite doors - the passenger slider will close to 80%, but the driver still functions fine. There must be an easier solution than new wiring harness/motor??

Aug 19, 2009 | 2005 Dodge Caravan

1 Answer

Passenger sliding door motor won't close door all the way.


I just fixed my 2005 T&C sliding door. The wire in the plastic rolling chain is broken when resides right under the step pad. It took me 30 minutes to fix.

Go to this link.
http://wiki.answers.com/Q/How_do_you_replace_the_power_sliding_door_wiring_harness_on_a_2005_Town_and_Country_chrysler

Good luck!

May 27, 2009 | 2005 Chrysler Town & Country

1 Answer

Power sliding door doesn't work!


Try taking off the door, or spray some wd-40 on the rail. It sounds like its either not getting enough power or its getting caught on something.

Apr 23, 2009 | 2007 Dodge Caravan SXT Minivan New Cars

1 Answer

Chrysler T&C Power Door Problem


If it stops in roughly the same spot every time, and won't respond after it has stopped, it sounds like a broken wire. It is likely losing its electrical current to run the motor. It should be right where the track bends when the door has stopped. Check for loose or frayed wiring inside the flexible plastic track just below the door. The wires will often wear after being bent over and over again. If you find a broken bit of wire, cut out that section and splice in a new length of wire. Be sure you do a good job splicing, or you may end up with the same issue again soon. I am not a mechanic by any means, this just makes sense to me, and I'm considering buying an 01 town and country with this issue, which is why I'm on this site to begin with. Best of luck -

Jan 22, 2009 | 2008 Chrysler Town & Country

1 Answer

All doors open and close with remote except the passenger side ?


Sounds like the most likely cause is the electronic lock actuator is bad. will have to take door panel appart to check.

Jan 09, 2009 | 2000 Toyota Camry

2 Answers

The power sliding passenger door will not open even manually. At first it didn't want to close, but after I slammed it shut it didn't want to open. A few days later I was trying to get the door panel off...


I think you have a latch issue or a latch release issue, pull the door panel and try and release the door latch, pull the latch and try to see what if anything is wrong with it, also make sure the linkage going to the latch from the release handle is hooked up or not otherwise damaged.

Oct 22, 2008 | 1998 Oldsmobile Silhouette

2 Answers

Honda Odyssey doors


I read about this issue while I was looking for a fix to mine. Try the following:

Remove fuse #13 for 30 seconds or more from the passenger side fusebox. This will reset the door and the clock.

OR

1.) Disable the power door switch on the left dashboard.
2.) Remove the power door fuses located under the front passenger leg area.
3.) Manually open and close both sliding doors.
4.) Restore the power door fuses located under the front passenger leg area.
5.) Enable the power door switch on the left dashboard.
6.) Try opening the sliding doors.


http://www.topix.com/forum/autos/honda-odyssey/TD1QRDMAQ28J8EDA0

Sep 03, 2008 | 2002 Honda Odyssey

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

58 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

Marvin
Marvin

Level 3 Expert

83083 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22382 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...