Question about 1996 Ford Taurus

1 Answer

My friend went me to flush the radiator, wheres the drain plug and fill cap

Posted by on

  • Marvin
    Marvin Jul 19, 2010

    U MUST GET UNDER THE CAR TO DRAIN THE RADIATOR, THE DRAIN VALVE IS ON THE BACK SIDE OF THE DRIVER SIDE PLASTIC RADIATOR TANK

  • Marvin
    Marvin Jul 19, 2010

    has the recall been done on this for the rusty coolant problem this year has?

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 977 Answers

There may not be a drain plug,the best way to flush the radiator is to take the bottom hose off the radiator & flush it that way, the filler cap should be on the top of the radiator......hope this helps.....cheers

Posted on Jul 21, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i change the radiator fluid?


Most radiators have a drain plug on the bottom tank the engine block also has a drain plug . Remove the radiator cap ,open both drains ,let all the coolant run out, if there is no radiator plug remove the lower hose , remove the heater demister hoses, with the heater control on hot flush out all the coolant from the heater radiator. with a garden hose, till the water runs clean, tighten the radiator plug or re fit the hose,put a garden hose into the radiator and flush out till the water at the block plug runs clean ,refit the heater hoses, refit the block plug, fill the radiator from the hose leave the cap off , If it has a overflow tank clean and flush it. start and run engine for 5 minutes top up radiator if needed . stop engine and drain out all water. most important that all old coolant is drained out, only buy the best coolant you can . If you make up your own use only distilled water. keep some to top up with never mix with another brand. Fill radiator with coolant top up over flow tank, run engine top up coolant as needed, refit radiator cap run for another 10 minutes check for leaks,

Oct 14, 2014 | 2006 Chevrolet Trailblazer

1 Answer

Were is the radiator cap and drain plug in a 2005 Sunfire?


Radiator cap would where theradiator is! and the drain plug at the bottom. Make sure you add anti freeze if required in your area.

Nov 18, 2013 | 2005 Pontiac Sunfire

1 Answer

How to change my engine coolant in a 1992 ford ranger-v6 3.0 engine, with what kind of coolant and how much of it


Hello again Vicki, you can read my first post to you on type. Now for where and how. Put suitable container under radiator drain valve. Start to drain old antifreeze, you can also loosen radiator cap for faster drain, but make sure antifreeze doesn't start to spill all over your driveway or garage floor. When radiator and engine are mostly drained, I would recommend to change the thermostat. Follow the top radiator hose down to the engine. This is where you'll find the thermostat. Remove the attaching bolts and remove thermostat.If you wish to flush your engine,you can put water down the thermostat hole as well as the radiator cap hole, or you can do a fancy flush. Shut drain below, reinstall thermostat housing without thermostat, fill radiator with fancy flush cleaning solution and water replace radiator cap ,run for time stated on can of flush. Now you go back to where I began and start the draining again. Dispose off antifreeze correctly it is dangerous to animals if they ingest. Close drain,and fill engine with antifreeze thru thermostat housing, when almost to top install new thermostat and gasket. fill radiator almost to top, start engine, open inside heater and let engine warm to operating temperature. At this time the antifreeze level will drop, because thermostat will open, and you can fill some more .This should eliminate any possible air bubbles. Fill your coolant tank. I would like to know how you make out. GOOD LUCK.

Oct 11, 2011 | 1992 Ford Ranger

2 Answers

I want to learn how to drain and flush my radiator. I need help on how to do so without making as mess


well its bound to make a little mess but you should have a drain plug on the radiator at the bottom towards the engine side on one of the 2 tanks (sides of radiator ) unscrew drain plug and let drain into a pail or pan ( 2 gallon ) after it drains remove lower radiator hose. use a garden hose and fill radiator and let it flush for a little, hook lower radiator hose back, tighten drain plug and fill with a 50/50 mix new antifreeze,

Feb 07, 2011 | 1996 Ford Taurus

1 Answer

How to flush radiator? Does it have a drain plug?


Drain plug is located in lower side of radiator. While your engine is cold and off, open your radiator drain plug and filling cap. In minutes your radiator will empty.Then fill up your radiator.

Aug 13, 2010 | 2001 Chevrolet Prizm

2 Answers

How to fill radiator fluid in 2003 suburban 2500


I generally have stopped even looking for the drain...half of them don't work right even when you do find them. Far easier and faster is to remove the lower hose. If you have a closed system with no cap on the radiator then fill through the reservoir, otherwise fill through the radiator and add to bottle after you are finished. Run the heat on high while filling and wait for thermostat to open and level to drop before final fill.

Aug 01, 2009 | 2003 Chevrolet Suburban 2500

1 Answer

1997 Dodge Dakota Radiator drain plug


,m ake sure the radiator cap is off,oh or the radiator is clogged, remove lower radiator hose]and flush with garden hose

Apr 13, 2009 | 1997 Dodge Dakota

2 Answers

Where is the drain valve on 2002 dodge caravan radiator?


its a pitcock facing the cab bottom of the radiator, plastic flat. once you find the pitcock just put a bucket underneath and turn it.then refill. if you want to flush(run fluid thru to clean it out) the radiator id suggest taking it in. you dont have to flush it every time you change the coolant out.

Mar 28, 2009 | 2002 Dodge Caravan

1 Answer

Coolant drain plug on engine block


there is no drain plug on the engine block unfortunately, however taking the lower radiator hose off will drain almost all the coolant out off the block. then reconnect the lower hose and fill completely with just water and flush solution let sit for a few minutes. then take lower hose off again let it completely drain. reconnect lower hose and fill with 60/40 mix of coolant this will protect to -40 degrees F. when you have it completely full keep cap off radiator and start vehicle turn your heater on hot and the fan to high. top off with coolant and replace cap. there should be no need to bleed system of air. please rate this solution.

Aug 30, 2008 | 1997 Buick Skylark

Not finding what you are looking for?
1996 Ford Taurus Logo

Related Topics:

193 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

Marvin
Marvin

Level 3 Expert

83036 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22382 Answers

gerry bissi

Level 3 Expert

4387 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...