Question about 2007 Jeep Grand Cherokee Overland

1 Answer

I have a Jeep grand Cherokee with a diagnostic code P0513. truck is not starting and I cant find what the code location is. I think it might be the starter but I want to see if I am going in the right direction

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 102 Answers

Try your other key. i just looked up the code on a chrysler site and it lists it as a key imobilizer error. You may have to bring the keys to a dealer to get them reprogrammed.

Posted on Jul 19, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What is diagnostic code 22 for a 1994 Jeep Cherokee grand limited


That code is for the engine coolant temperature sensor. "...input above maximum acceptable voltage." I would try a new temp. sensor. If that doesn't fix it, you may need to have an engine scanner hooked up, and see what the sensor is sending to the computer, and go from there.
A bad coolant temp. sensor can cause hard starting like your symptoms.
.

Apr 25, 2014 | 1994 Jeep Grand Cherokee

1 Answer

I am getting diagnostic code 22


Error Code: 22
Description: Engine Coolant Temperature circuit malfunction.
Possible Causes:
- Wiring.
- Coolant Temperature sensor defective.
- ECM.

Apr 25, 2014 | 1993 Jeep Grand Cherokee

1 Answer

MY 97 JEEP GRAND CHEROKEE STARTED SHUTTING DOWN WHILE IN DRIVE. SCANNER SAID IT WAS MY IGNITION COIL I HAD IT REPLACED AND THE PROBLEM CONTINUED I ALSO HAD THE SPARKER IN THE DISTRIBUTER REPLACED I HAD...


What was the code ? No code tell's you to replace any part !!!! All code's have a dignostic trouble check chart for testing electrical circuit's . Your best bet ,take it to a qualified repair shop that has the knowledge an diagnostic tool's to test .

Nov 27, 2017 | 1997 Jeep Grand Cherokee

2 Answers

DIAGNOSTIC PLUGIN LOCATION


For 1995 Jeep Grand Cherokee 4WD 5.2L MFI 8cyl the OBD Diagnostic Link Connector is located: Under hood, driver side, front side of shock tower, mounted on wheelwell.

Hope helps (remember to rate this asnwer).

Oct 21, 2010 | 1995 Jeep Grand Cherokee

1 Answer

Code 463 fuel level sensory high imput, what is this and where is it located


Not sure if this helps or not, but here is information from the 1998 Jeep Grand Cherokee Service Manual, ezg_25.pdf, page 6 of 20…

Hex Code = 95
Generic Scan Tool Code = P0462
DRB Scan Tool Display = Fuel Level Sending Unit Volts Too Low
Description of Diagnostic Trouble Code = Open circuit between PCM and fuel gauge sending unit.

Hex Code = 96
Generic Scan Tool Code = P0463
DRB Scan Tool Display = Fuel Level Sending Unit Volts Too High
Description of Diagnostic Trouble Code = Circuit shorted to voltage between PCM and fuel gauge sending unit.

Hex Code = 97
Generic Scan Tool Code = P0460
DRB Scan Tool Display = Fuel Level Unit No Change Over Miles
Description of Diagnostic Trouble Code = No movement of fuel level sender detected.

for additional information on troubleshooting and resolution:
http://rapidshare.com/files/138412864/ServiceManual.Jeep.Grand.Cherokee.1998_by_Parasico.rar

Mar 01, 2010 | 1998 Jeep Grand Cherokee

2 Answers

Diagnostics "P1762 Manufac. Contrl. Transmission"


Had the same code on my 2002 Jeep Grand Cherokee. Started having shifting problems as well. Code is for governor pressure sensor on trans. Cost me about $800 for dealer to fix. No problems after part changed out.

May 22, 2009 | 2002 Jeep Grand Cherokee

1 Answer

Engine code 95 jeep grand cherokee lerado


12 is a battery disconnect within the last 50 start cycles and 55 means the end of the diagnostic cycle.  Basically the computer found nothing wrong. The 12 code may seem incorrect if you haven't disconnected the battery recently, but from my experience the 12 code shows up almost all the time regardless.

Dec 16, 2008 | 1995 Jeep Grand Cherokee

Not finding what you are looking for?
2007 Jeep Grand Cherokee Overland Logo

Related Topics:

873 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

Marvin
Marvin

Level 3 Expert

83081 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22382 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...