Question about 2007 Dodge Charger SRT8 Sedan
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
C1041 code is-Left Front Tone Wheel Performance
the speed sensor was slower then the other front one to react to something,or the left wheel spun and not the right front one,
or there is a problem in the sensor or wiring
Posted on Nov 22, 2009
When the ABS light goes on, it's likely a speed sensor that has gone bad in one of the wheels. Replacement involves changing the hub that contains the abs wheel speed sensor in many cases.
Posted on Aug 12, 2010
SOURCE: the ESP/BAS light keeps coming
Have you unhooked your battery for something? You might try making sure the stability control's steering sensor is correct...
Basically, start the car turn the wheel all the way left to the stop, all the way right, then back to center. This lets the stability control know where "center" is. Try this:
1) Disconnect your battery, wait 1 minute & just turn on the lights for a second as to remove any residual current from the computer.The lights will not come on but still turn ON.
2) Re-connect the battery, this should have cleared all of the lights except for the ESP\BAS light.
3) Start the car, center the wheels, turn all the way to the left then all the way to the right. This should clear the ESP\BAS light. ------- If still the same problem then the esp/bas module needs to be checked and reprogrammed by the dealer to turn it off. Thanks. Keep updated for any more query. You can rate this solution and show your appreciation
Posted on Sep 04, 2010
SOURCE: ESP/BAS warning light on. went
Hi, these systems are all linked together. Most commonly, one of the wheel speed sensors is not reading or is reading incorrectly. This can also occur on slippery surfaces where one or more wheel slides enough to cause the sensor to drop the signal, but not enough to meet criteria for an abs or esp episode. If the light comes back every time you turn on the ignition, there is a deeper problem.
The system has detected a fault in the electronic stability program - brake assist system. You have an electrical connection at the rear wheels secured to the inside of the brake area and are viewable from under the vehicle. It is a small wire harness running to each wheel. Grab the connector and wiggle it around, and make sure they are tight. Due to the connector being mounted low to the ground, sometimes they become dirty or corroded, not making contact. Do this on both sides and see if the lights turn off.
If the light does not turn off, you have to replace dynamics sensor, which is mounted UNDERNEATH the center console in the car. There is a "lost communication to dynamics sensor" and "low voltage to dynamics sensor supply"..
Posted on Feb 13, 2011
Tips for a great answer:
Feb 12, 2017 | Cars & Trucks
Nov 17, 2016 | Jeep Cars & Trucks
May 16, 2016 | 2008 Dodge Charger
Jun 09, 2015 | 2008 Dodge Grand Caravan
Jul 09, 2014 | 2007 Jeep Liberty Sport
Mar 20, 2014 | Dodge Charger Cars & Trucks
Oct 03, 2012 | 2008 Dodge Grand Caravan
Aug 12, 2010 | 2006 Dodge Magnum
May 27, 2009 | 2003 Volkswagen Golf
185 people viewed this question
Usually answered in minutes!