Question about 2006 Toyota Corolla

1 Answer

The maintenance req'd light is on what does this mean? i just had the oil changed on Monday

Posted by Anonymous on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 4,044 Answers

There are too many possible faults to list all the possibilities here. take the vehicle to the Local Auto Parts store and ask them to use their scanner to read the fault codes that are stored. That will tell you for sure. If it's a simple O2 Sensor you can pick the part up and special tool to replace it there are the store. You can also pick up the Haynes repair manual on your vehicle while your there to do any other repair that may be needed.

Posted on Jul 19, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How do i reset my manint req's light after an oil change on a 2003 Honda pilot


Reset oil service light Honda Pilot. From years: 2003, 2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012.
How do you reset oil service light Honda Pilot. From years: 2003, 2004, 2005.
  1. Turn off the engine. Press and hold the SELECT/RESET button in the instrument panel and turn the ignition switch to run (one position before starting).
  2. Hold the button for at least 10 seconds, until the indicator resets.
  3. Turn the ignition off and then start the engine to verify the indicator has been reset.
How to reset oil service light Honda Pilot. From years: 2006, 2007, 2008, 2009, 2010, 2011, 2012.
Resetting the Engine Oil Life Display if maintenance service is done by someone other than your dealer, reset the maintenance minder as
follows:
  1. Turn the ignition switch to the ON (II) position.
  2. Press the select/reset knob repeatedly until the engine oil life is displayed.
  3. Press the select/reset knob for about 10 seconds. The engine oil life and the maintenance item code(s) will blink.
  4. Press the select/reset knob for another 5 seconds. The maintenance item code(s) will disappear, and the engine oil life will reset to 100.
All information is taken from the Honda Pilot owners manual.

Mar 09, 2015 | 2003 Honda Pilot

1 Answer

Maint req. lite blinks 8 times then goes off and stays off when driving. cannot change it.


what this means is that you need to change your oil, it will blink then go away until the required mileage is up, then it will stay on,
change the oil, and have the person who does it clear it.

Feb 15, 2015 | 2009 Scion xB

2 Answers

Chech engine light just came on i was going to get the oil change on monday does the oil have anything to do with the light coming on


  • The light on the left side of the instrument panel is a maintenance required light. If that is the light lit up then yes this means time for an oil change.
  • If the light lit up is on the right side of the instrument panel then this is the Check Engine Light and a scan will need to be done to see what is going on with the car.
  • Hope this helps and thank you for using FixYa.

Regards, Tony

Jun 18, 2011 | 1999 Toyota Camry

1 Answer

I have a Honda 2000 Odyssesy and the maintenance required light comes on and stays on. We recently changed the oil and filter. I do not notice any problems with the runnning of the vehicle. An auto part...


The maint req. light is a mileage counter. It will turn on every 7500 miles after it has been turned off because that is the factory recommended oil change interval. To turn off the light: with key off, push and hold the trip odometer reset button in. While still holding in the button, turn the key to on but not start. Continue holding the button in until the maint. req. light goes out. Turn key to off.

Code P1456: Evaporative Emission (EVAP) Control System leakage.
Code P0740: Transmission lock up control system.

the first code can be caused by a loose or non-factory fuel cap or a leak.
The second code indicates the transmission torque converter lock-up solenoid could be faulty.

Clear the codes and drive normally for several days. See if the Check Engine light comes on again. If so, have the codes read out and prepare for some repairs. If the light stays off, you had intermittent faults which occur from time to time and nothing is probably wrong.

Feb 24, 2011 | 2000 Honda Odyssey

1 Answer

2001 Acura maintenance light is flashing after I changed the oil. How do I reset it? Also, my blower stopped working on the heat.?


I can answer the FIRST question.

A. Car is off.
B. With car off, hold down BOTH trip buttons that are to the right of the tach.
C. Start car while STILL holding the buttons down.
D. Hold buttons down until they stop blinking THEN RELEASE THEM BOTH.

Done!

Note: That Maint.Req'd light is nothing more than a "timer". It doesn't mean anything. It is supposed to go off to remind you to change oil, etc but doesn't actually measure anything.

Nov 21, 2010 | 2001 Acura 3.2TL

1 Answer

Maintenance reqd light came on at 44,000 miles...why?


It's probably your regular scheduled maintenance (oil change) light. Here's how you can reset that:

1. Turn the key to "on" so the electrical system is fired up (but engine is not running)

2. Set trip planner to "A" trip.

3. Turn key off (no electrical)

4. Hold down trip button, then turn key to "on" so the electrical system is fired up (but engine is not running).

5. "Maint Req" light will blink several times and then go off.

Good luck!

Nov 15, 2010 | 2008 Toyota Camry

1 Answer

Maint req light


That just means you're due for an oil change. they automatically come on after 5000 miles. To reset the light, put it on the odometer display in your instrument cluster. turn the key off. now push and hold the odometer/trip reset button while you turn on the key to the IGN position. You will see 5 dashes on the odometer display, which will sequencially disappear and then go back to the odometer when it's done. after your odometer shows again, you can release the odometer/trip reset button and your maintenence light should be off.

May 31, 2009 | 2005 Toyota Tacoma

1 Answer

Maint. Req. light came on and car making clicking noise from under hood


check oil, you probably have it very low. and that clicking sound you hear could be your lifters. take it to get an oil change you dont want to bust your head

Apr 20, 2009 | Honda Element Cars & Trucks

1 Answer

Maintenance light and brake lamp light what does it mean


The Maint Req Light is only a reminder light to get the Oil changed and fluids checked and what nots.. Its on a timer that must be reset.. Its no big deal if ya had it seviced recently.. Heres how to turn it off: 1) Make sure Key is Off 2) Press and Hold Mileage reset button. 3) While Holding Milelage Reset button, swicth car to run, but dont crank..4) Continue to hold button until light flashes and goes off.. then switch it off .. Start the engine to make sure it worked.. Sometimes ya gotta do it twice.. NOW.. And ur Lamp indicator.. Means you probably have a brake light or turn signal bulb out on the rear.. Get someone to help ya look for that.. Lemmie know if this works.. and Take care.. Thanx

Mar 11, 2009 | 2001 Acura 3.2TL

1 Answer

2008 Scion XD


I don't know for sure, but I'd imagine oil, oil filter, and air filter changes, tire rotation, brake and strut inspection, and maybe a cabin air filter change. Look in your owner's manual near the back - each service should be spelled out in there so you don't go in unprepared.

Aug 02, 2008 | 2008 Scion Xd

Not finding what you are looking for?
2006 Toyota Corolla Logo

73 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

Marvin
Marvin

Level 3 Expert

83096 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22382 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...