Question about 2001 Dodge Ram 3500 Truck

1 Answer

2001 Dodge V 10 8.0 3500 has propblem when driving surges has no engine codes Could it be in transmission or Sensors

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Dodge Master
  • 1,906 Answers

Check for an intake vacuum leak

Posted on Jul 19, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2001 dodge startus transmission wont shift, speedometer works, engine light is on. Need help?


Transmission is in limp mode. This enables you to drive the car to service. Anytime there is a transmission code in the computer even if nothing is wrong it will stay in limp mode until the code is erased. Most retail auto parts stores will run an obd2 diagnostic scan to determine the problem and erase existing codes, no charge (Auto Zone, Advance and others)

May 14, 2014 | 2001 Dodge Stratus

1 Answer

2001 Dodge Durango problems with rough idling and stalls.


Hello... Where to go next depends on how the Evap Gross Leak was fixed... Post it...

Thx.

Jun 16, 2010 | 2001 Dodge Durango

1 Answer

I have a 2001 dodge grandcaravan and it started surging while driving and the transmission wouldnt shift into drive or overdrive. So I had it put on a computer and the code for the output speed sensor...


I never change a PCV Valve. Wash them out,and move on, to the next thing on your list. The PCV regulates air flow,from your engines crankcase,to induction,to prevent pressure build up and remove and burn blowby gases Etc.
Why would you change the speed sensor,just because you got a code. The code is the symptom,not always the causes of the issues or problems.
You have driveability issues with the engine. Work on that first, e.g.--surging
Then go to trans issues,such as solenoid valve body.
You need professional help here. Too high tech and too much to know, to fix in your driveway.

May 09, 2010 | 2001 Dodge Caravan

1 Answer

Check engine lit on code po442,po445


I have a dodge stratus and the engine light is on and it drives and its as though someone stopped it with a grabbing sensation but its not the brakes they are not involved. i thought the pause and cut off was caused by the transmission but it not that either

Mar 29, 2010 | 2001 Dodge Stratus

1 Answer

2000 dodge grand caravan sport, the check engine light is on, but no codes found after checking with reader, speedometer is jumping all over the place, from 0 to 120 mph, when the speedometer jumps around,...


no codes found because your checking the PCM,
your problem is you need codes from the TCM,the computer for the transmission,since you replaced the speed sensor the other two things that affect a speedometer and transmission are the input and output sensors,they both screw in the transmission.

Jan 31, 2010 | 2000 Dodge Grand Caravan

1 Answer

Transmission slipping. does not appear to be shifting properly. replaced ecm. got tcm from jeep grand cherokee same engine (4.7L). notice significant burning/smoke after driving exhaust manifold. not...


U are going to need to overhaul the transmission here, the smoke is the trans overheating from excessive slippage i suspect.code for wrong gear ratio's mean the input and output shaft speed are out of symc for the gear the trans is in, the 3rd or 4th gear is the usual codes, this sometimes is caused by defective speed sensors but most times the trans is slipping and the TCM detects that and sets a code

Dec 10, 2009 | 2001 Dodge Durango

1 Answer

2000 Chevy Silverado


I would get a techie to check the throttle position sensors... this has been a problem on the Chev/GMC set up.

May 19, 2009 | 2000 Chevrolet Silverado

1 Answer

2001 Toyota Celica GT RPM surging at Idle


Certainly sounds like the o2 sensors have become contaminated and are not acting as fast as they used to , or are supposed to.

Apr 24, 2009 | 2001 Toyota Celica

1 Answer

Transmission is "Hunting"


there are so many sensors nowdays that cause the same problem.---a bad throttle position sensor causes,:transmission shift issues,bucking, jerking, idle surging, engine cut off,hesitation on take off, surge while cruising down highway. a code will not allways set for a problem.

Oct 28, 2008 | 2001 Chevrolet Malibu

2 Answers

Cummins Diesel losses accelerator mostly when weather is cold


this is referred to as a drive by wire system. meaning you have no accel cable. it uses a sensor on the gas pedal and on the pump. probably the pedal sensor going bad need to check the code and go from there

Sep 11, 2008 | 2001 Dodge Ram 2500 Truck

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

114 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

77514 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...