Question about 2000 Chrysler Grand Voyager

Open Question

Dashboard lights flash ,go out after 20 minutes

Dashboard lights( push button rear wiper and intermittant wiper) flash ,go out after 20 minutes ,whilst they are flashing the other button lights do not operate but there is no loss of the system that the buttons operate its just that two flash continuously and go out after 20 minutes after which all is well. the moment the igniton is turned off and then back on they revert to flashing etc

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 22 Answers

SOURCE: wipers

the climate control panel has come out of calibration..
to re-calibrate it you need to have
Set Blower motor ON HIGH
Set Mode position to Panel
Open all A/C outlets
Set Temperature to Cold (Both slide pots if equipped)
Depress WASH and REAR WIPER button simultaneously for 5 Seconds (Until all LED's light)

All LED's will turn on for 5 Seconds
When done REAR WIPER LED is the only LED flashing. Push Rear Wiper to exit

your a/c system must be functioning properly for it to re-calibrate.

Posted on Jan 12, 2009

Ad
  • 1 Answer

SOURCE: flashing lights

Hi, had the same problem today. Solution: Start engine, blower on max, air direction to cabin, press rear wiper and rear wash buttons simulanteously for 5 seconds (all lights now on steady). Calibration test starts and lights flsh alternately. After first test, AC and recurculation lights flash for the cool down test. If all test pass then rear wiper light blinks slowly (press to exit self test). If AC and recurculation test fails then just 2 lights stay on. To repeat this part of the test press just AC and rear wash simulanteously ( may take several attempts and usually best when engine is cold). Again exit by pressing the rear wiper button once it is the only one flashing (slow blink).

This does work but it took me 15 minutes to finally switch them off!!!

Posted on Mar 12, 2009

  • 126 Answers

SOURCE: the lights are flashing on the insturment panel on

could be a electrical surge or maybe u should take it to a shop and have them trouble code it

Posted on Sep 01, 2009

  • 593 Answers

SOURCE: a/c, wiper + intermittant (rear) recirc neons are

It sounds like the battery was not disconected long enough to fully reset the computer.
Loosen and remove the neg. battery terminal, wait about 20min and replace the terminal. Things should
return to normal. Hope this helps. Good luck

Posted on Jan 20, 2010

  • 1 Answer

SOURCE: lights flash on ac rec and rear wiper buttons. Put on new ac com

With my 1998 TC you have to start car turn to cold and fan on high. Tehn hold down the rear wiper and WASH buttons until the lights start flashing differently. Let it run through until only the rear wiper light is blinking. You should here it cycling through the different functions. When it is jsut the rear wiper blink press that button and the system is reset if there are no problems. A low voltafge problem had caused mine to act up.

Posted on Aug 28, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1998 Town & Country Dash Buttons are Flashing on and off


set it on full cold, set it to panel vents, blower motor to high. hold the wash and rear wiper buttons on the control head until all the lights come on. it will run through different tests, different lights will flash and alternate, and when it is done the rear wiper button will flash if everything passed. push it and everything will go out. if other lights still flash when it is done, you have failed the cooldown test because the a/c doesn't work right, or a door calibration did not pass.

Jun 07, 2013 | 1998 Chrysler Town & Country

1 Answer

I have a 1998 Plymouth voyager and the climate control lights are flashing. I ran a test i found on the internet and got it down to two lights flashing(the ac and the recirculate). I got it to where the...


OK got your message on the other post (About the van) I am assuming that your Voyager is equipped with Automatic Climate Control. Follow the instructions below and you will get a better idea of what is wrong with your system.

Calibration/Diagnostics
1. To enter calibration/diagnostics test, set parking brake. Start and warm engine to normal operating temperature. With engine idling, turn blower switch to high. Turn mode switch to panel. Open all outlets. Move temperature to full cold.
2. Press and hold rear wash and rear wiper buttons simultaneously for 5 seconds (Until ALL LEDs illuminate). All LEDs should illuminate for 5 seconds. Rear wiper and intermittent rear wiper button LEDs will flash alternately during calibration/diagnostics test.
3. After approximately 60 seconds, if only the rear wiper button LED is flashing, calibration is successful and the system is okay. If rear wiper and intermittent rear wiper button LEDs are flashing, Diagnostic Trouble Codes (DTCs) are present. (See "Reading Diagnostic Codes" below)
4. To exit calibration/diagnostics test at any time, press the rear window defogger button, rear wiper button, or cycle the ignition off and then on. Test will automatically terminate 15 minutes after calibration/diagnostics is entered.

Reading Diagnostic Codes
1. Perform calibration/diagnostics test. If a DTC is present after calibration/diagnostics test has been performed, system will flash rear wiper and intermittent rear wiper button LEDs in sequence. Rear wiper represents code level, and intermittent rear wiper button LED represents code value.
2. Each time the rear wash button is depressed, rear wiper button LED wil cycle to the next code level in numeric sequence. After code level 5 is reached, rear wiper button LED will cycle back to code level 1. See table below.

dttech_67.gif

May 12, 2011 | Plymouth Voyager Cars & Trucks

1 Answer

I'm having a flashing light s on the push buttons for the 2 windshield and air conditioner and air flow buttons


(copied and reposted from another person)....I had the same problem you do. What has most likely happened is that the Heater-a/c unit needs to be recalibrated. Here are the steps to do it.
With the engine running and fully warmed up, A/C has to be turned off for at least 5 minutes [don't turn it on at all] and transmission in Park do the following
1. Set the temp control all the way to cold
2. Set the mode selector to Vent [blowing in your face] so air blows out of the dash panel outlets.
3. Hold down the rear washer button [top left] and the rear wiper button [bottom left] simultaineously for about 5 seconds until most all of the heater and ac panel lights blink and then release both buttons.
6. At this point the system should go into a self calibration test which can take up to 60 seconds. While it is calibrating various control panel switch lights will blink as it goes through it's tests.
7. When the system is done calibrating then just the rear wiper light should be flashing and you can exit the test by turning off the vehicle. Wait about 10 seconds and restart the engine and it should be fine. If both the rear wiper and intermittent light are both still flashing after the calibration then there is most likely a problem with the system that will need more diagnosing. This sometimes happens with battery replacement. It sometimes takes a couple of tries to calibrate so don't give up if it doesn't work the first time.

Jan 22, 2011 | 1996 Plymouth Grand Voyager

1 Answer

Lights are flashing on the heater controles [the ac , back wiper , all buttons there ] what fixes that. on my 98 dodge caravan


push and haold in the rear wiper and rear washer butts for 5sec or until all lights flash but make sure yor motor is warm and that the ac is on high first.. wait until all lights except for the rear wiper light are off then press the rear wiper button once more..

Jun 19, 2010 | 1998 Dodge Caravan

2 Answers

Blinking panel button lights


That has to do with your computer for your body controls, such a/c, heater, wipers, etc...
Most common problem is drinks spilling into the computer which is right between the cup holder. It will eventually cause a problem with a/c most likely.

Jun 24, 2009 | 1998 Dodge Caravan

2 Answers

Blinking panel lights


To Calibrate , start and warm engine to normal operating temp. with engine idling turn blower switch to high, turn mode switch to panel, open all outlets, move temp lever to full cold.
press and hold rear wash and rear wiper buttons simultaneously for 5 seconds (untill all leds illuminate.) all leds should light up for 5 seconds, rear wiper and intermittent rear wiper button leds will flash alternatly during calibration... after 60 seconds if only rear wiper button led is flashing, cal. is complete

Jun 18, 2009 | 1998 Plymouth Voyager

1 Answer

Lights flashing on a/c and air recirulate buttons


Sounds like its gone into programming mode. All you need to do is start your van. (if you are unsure what knob or lever is which I am looking in the manual for proper terms) Then slide your temp lever all the way to the left (full cold). Then turn the Mode Control to 'panel' (the one that sends air to your face only). Then turn the 'blower switch' to all the way to full. Now go to the leftmost three buttons. Press the top one (rear wiper on constant) and the bottom one (rear wiper washer fluid). Hold these two for a few seconds. Once the lights come on solid then begin to flash you can let go. The AC will now calibrate. You will feel the air blow out of all the different zones at different intervals and see lights come on and go off. Then after a minute or two the top bottn you pressed will be slowly flashing. This means it has been completed (I actually let it run for 5 more minutes just in case something else started blinking). Press the last flashing button and you are done.

Mar 17, 2009 | 1997 Dodge Grand Caravan

2 Answers

Replaced battery,now rear wiper control lites are flashing.


The procedure for re-setting the HVAC control panel on a 1998 Dodge Grand Caravan follows:
With ignition on but not running
1. turn knob to air vents
2. turn fan knob to ON
3. temperature setting on COLD (2X) {I have dual temp controls}
4. hold top(rear wiper) and bottom (rear wiper with wash) buttons pressing down together until all the buttons cycle through (this will require 1 to 2 minutes of continuous pressing)
Hopefully, this also applies to 1997 version. I learned this from a very helpful local Dodge service adviser

Jan 21, 2009 | 1997 Dodge Caravan

4 Answers

Heating/Air conditioning Control


hi to get the lights to stop flashing this is with you have to do he reason they are on is beacuse the battery has been removed at one time ok this is the was to get them to stop flashing. first start the vanthen slide the temputer lever all the way to the right then set the mode control to panel (this is the mode that send air to your face)then put the fan speed to full power now go to the leftmost three buttons press the top one(rear wiper on constant) and the bottom one(rear wiper hold thest for a few seconds once the lights come on solid then begin to flash you can let go. the ac will now calibrate you will feel air blow out of all the vents at different intervals and see lights come on and off then after a minute or two the top button you pressed will be slowly flashing this means it has been completed but let it run for a few minutes more to make sure nothing els flashes then press the last flashing button then your done if you need more help email me rockystevenson@hotmail.com

Jun 30, 2008 | 1998 Chrysler Town & Country

Not finding what you are looking for?
2000 Chrysler Grand Voyager Logo

Related Topics:

225 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

Marvin
Marvin

Level 3 Expert

81400 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

chargerhp
chargerhp

Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...