Question about 2000 Volvo S80

Open Question

Volvo S80 2001,manual transmission, how do i

Volvo S80 2000,manual transmission, how do i adjust the clutch? The car feels like it jumps slightly when the clutch is released after selecting a gear, as if the clutch isn't fully and smoothly engaging.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

SOURCE: I have occasionally noticed a

Does your RPM's dip from about 1,000 to just a tad below 500?

If so...try cleaning out your throttle.

Be sure not to spray throttle cleaner directly into the throttle, but on a rag and wipe away. Use something to hold the throttle plate open and use a small brass brush, dip into the throttle cleaning solution, and start to scrub away some of the built up soot.

Afterwards, wipe it down till you see a rather shiny throttle.

Posted on Aug 14, 2008

Ad
repairpal
  • 128 Answers

SOURCE: mode w engaged

If you cannot turn off the flashing mode selector light, then there is a code stored in the transmission computer. ave the codes read out. Post the code here and I may be able to help out.

Bret
RepairPal.com


Posted on Dec 09, 2008

  • 4 Answers

SOURCE: 2000 volvo s40 cannot remove ignition key

The swich that you press when you want to change the gear mode("p" to "d" ) remain jam very coomon for an s40 spary silicone spary on it to remove dirt from there

Posted on Dec 10, 2008

txkjun
  • 409 Answers

SOURCE: Jump start point on 2000 Volvo S80

There should be a positve jump point under the hood. It should have a red cover with a + sign on it.

Posted on Dec 26, 2008

  • 1596 Answers

SOURCE: rover 600 1997 not engaging any gears when clutch fully depressed

Sounds like the SLave Cylinder has givin up Possible the Reli=eice Bearing I ALWAYS Replace As A PAIR . If you can put in gear by having someone rock the car front to back and it holds well its pretty Obvious that you DO have A Clutch Master Cylinder or Clutch Slave aat Releice Bearing Problem AGAIN These Parts I REPLACE AS A PAIR. Before ANything Chech Fluid Level that will tell the store IF FULL Most Probably MASTER-- If EMPTY then See where it went Look At SLAVE if wet thats the Culpret. --->> I Hope this INFO helps you and have a good Day >> Please dont forget to RATE me ok ? Thank You

Posted on Jan 16, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

TCM-P07250 / TCM-P 2733-00 / TCM-P 08960


Hi,
Verify the fluid level is full (not overfilled!) and the color and smell of the fluid. It should be light red color (usually) and not smell burnt @ all.

GL,
Td

Mar 14, 2014 | Volvo Cars & Trucks

1 Answer

My 94 Chevy sub starts right up but when put to drive it jumps then it shots off


Does it happen in drive and reverse ? Does it feel like the torque converter is engaged as if your foot is off the clutch on a manual transmission ?

Feb 25, 2014 | 2000 Chevrolet Silverado

1 Answer

I have Civic 2001 with 160,000 miles on it. i have problem when i am driving on high way on 80/mph rpm stay on 2800 and after 5 minuts rpm goes to 3500 and i feel loud noise like engine is taking more...


If the car type is manual transmission:
- Perform the clutch and pressure plate test.
PROCEDURE:
- Pull up the hand brake, shift the lever to 1st gear, rev up to 2000 rpm, release the clutch pedal at once.
- If the engine does not stall, replace the clutch, pressure plate, clutch bearing, regrind the fly wheel and pressure plate precisely.
- If the engine stalls, the clutch system is OK and do not need any clutch system repairing.
- If the clutch system is OK, check vacuum leaks through intake manifold, vacuum hoses, PCV valve and throttle control cable adjustment, MAP sensor and Throttle Plate Position sensor adjustment (9.8 percent or 0 degrees at TP sensor fully closed position).

If the car type is automatic transmission:
- Check the transmission control cable adjustment.
- Check vacuum leaks through intake manifold, vacuum hoses, PCV valve and throttle control cable adjustment, MAP sensor and Throttle Plate Position sensor adjustment (9.8 percent or 0 degrees at TP sensor fully closed position).
- Check the Automatic Transmission Fluid level in the transmission with the car on level floor, engine start, gear lever in P.
If the problem persists, contact a competent technician or service personnel.

Jan 19, 2014 | 2001 Honda Civic

1 Answer

2004 Honda Element with manual transmission is jumping out of gear. Any ideas? Sounds and feels like an adjustment issue to me. I had a new clutch put in about 50,000 miles ago. Vehicle has about...


I hate to say it but given the mileage on the car the transaxle may be going out. Usually the symptom is caused by problems with the syncro gears but only one or two. For example, if it only jumps out of 5th gear it would be the 5th gear syncro.
You could check the adjustment of the cable from the shifter to eliminate that possibility.

Aug 22, 2012 | 2004 Honda Element

1 Answer

Hard to select revers gear in a manual gearbox 1993 pajero


Your pressure plate may be loose on your transmission. That can often cause gears to slip or not quite fit. You my want to also consider checking all your bolts on the clutch as well. sometimes things just aren't snug or need a slight adjustment. Outside that, you may be looking at a rebuild or new trans/clutch combo.

Mar 25, 2012 | Cars & Trucks

1 Answer

Replace clutch cable on 1986 volvo 240.  where do I get started after getting new cable. Taken off under dashboard cover. Jacked up car. 


than next would be to release the cable from the transmission lever usually a pin or screw or clip is all that hols them on than fallow the cable to the pedal inside and un clip it the hardest part would be the adjustment you just have to adjust till it feels fine and shift smooth than your done good luck

Sep 24, 2009 | 1984 Volvo 240 Series

1 Answer

Jerking when pulling off


You could have a slipping clutch if it's a manual transmission.

Mar 23, 2009 | 2000 Volkswagen Golf

1 Answer

Automatic gearbox not transmitting enough power


possible items are clutch and band adjustments , oil pump pressures and dirty transmission oil
have it diagnosed by an accredited specialist transmission shop

Oct 24, 2017 | 1997 Volvo 960

Not finding what you are looking for?
2000 Volvo S80 Logo

Related Topics:

124 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volvo Experts

Marvin
Marvin

Level 3 Expert

81400 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Volvo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...