Question about 2004 Jeep Grand Cherokee

Open Question

2005 map sensor location jeep grand chereokee

2005 map sensor location

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: i need to replace the

The Manifold Absolute Pressure sensor is located on top of the cylinder head, right side, about 2/3 of the way back. there is one screw holding it in. You will need to take off the plastic engine cover off to access it. The sensor in the airbox is the MAF sensor.

Posted on Feb 15, 2009

Ad
  • 6982 Answers

SOURCE: where is map sensor located on 1999 jeep grand

MAP is usually on the firewall...it's about 1/2" thick by about three inches long, has a vacuum hose and several wires plugged into it.

Posted on Aug 15, 2009

  • 285 Answers

SOURCE: crankshaft sensor located 98 jeep grnd cher 4wd 6cy

it is located at the back of the engine on top of the transmission bell housing,the plug runs over to the passenger side of the engine bay and it comes out from behind the engine,you can actually get your hand on the sensor itself from under the hood on the drivers side,and i believe its a 13mm bolt holding it in,the new sensor will have a sticker on the end of it...leave it there,it is used for correct spacing between the sensor and the flywheel,hope this helps

Posted on Sep 23, 2009

Testimonial: "Everything was just like you said but as a not atleast for my jeep it is an 11mm not 13mm. Works great so far (keep fingers crossed) "

dburns60
  • 410 Answers

SOURCE: where is the map sensor located? 1994 jeep grand cherokee

Go half way between the air cleaner box and the "carburetor". Up the 4" black air pipe, a wire harness plug plugs into the MAP sensor there. Also called MAS air flow sensor.

Posted on Oct 05, 2009

  • 6982 Answers

SOURCE: location of tps and map sensor on a 02 jeep grand cherokee 4.7l

Both are attached to the throttle body. Tps is on the other end of the throttle plate shaft opposite the linkage, MAP is on the side...has small vacuum hose underneath and is flat, about 3" long. The other item on the TB is the idle air motor, next to tps.

Posted on May 08, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Location of map sensor on a cadillac sts 2005


Which engine ? 3.6 or 4.6 ?
One of them doesn't have a MAP sensor !
Manifold Absolute Pressure (MAP) Sensor (w/LH2)
Front center of the engine in the back of the throttle body
Engine Controls Component Views in Engine Controls - 4.6L

May 22, 2017 | 2005 Cadillac STS

1 Answer

Loss of power when driving


If cleaning the sensor doesn't work a replacement is about $150.
follow the link for more info
http://www.autozmagz.com/search/2005+mazda+3+map+sensor+located

Jan 07, 2015 | 2005 Mazda 3

1 Answer

WHERE IS THE MAP SENSOR LOCATED ON A 2005 LINCOLN LS


its located right behind the manifold you must remove the manifold to see it and replace it.

Oct 28, 2012 | 2000 Lincoln LS

2 Answers

Where is the MAP sensor on 2005 Pacifica Touring?


the map sensor is located at the top front of engine, it has a square plug with a wire lock, mounted at top end of intake manifold.

Feb 08, 2011 | 2005 Chrysler Pacifica

2 Answers

Where is the map sensor located on a 2005 chrysler pacifica


top front of engine, you will see a large electrical plug perhaps 8 wires that comes apart right in the front of the engine the map is right next to it.

Jan 15, 2011 | Chrysler Pacifica Cars & Trucks

1 Answer

Location of IAT sensor in the car?


For Hyundai Car 1999-05 - Intake Air Temperature (IAT) Sensor Location (check several options):

1.- The IAT sensor is located against the firewall to the left side of the engine. It is combined with the Manifold Absolute Pressure (MAP) sensor.

2.- This sensor is located in the air intake plenum assembly. On some vehicles this sensor is combined with the MAP/MAF sensor.

3.- The IAT sensor is located in the air plenum assembly. On some vehicles it is combined with the MAF sensor.

4.- This sensor is located in the air intake plenum assembly. On some vehicles this sensor is combined with the MAP/MAF sensor.

5.- This sensor is located in the air intake plenum assembly. It is combined with the Manifold Absolute Pressure (AFS) sensor.

6.- This sensor is located in the air intake plenum assembly. It is combined with the Manifold Absolute Pressure (AFS) sensor.


In the next graphic, check the position 2...

caae1be.gif

FIG : Underhood sensor locations-Elantra 2004-2005 2.0L engine


Hope this help (remember comment and rated this) TY for using Fixya.

Apr 08, 2010 | 2004 Hyundai Elantra

1 Answer

Location of maf sensor in 2005 Nissan Altima


It's a MAP (Manifold Absolute Pressure) sensor. Go to Checker, or NAPA, or PEP Boys and look at the replacement part - then you can find it under the hood. Probably mounted on the firewall. First check visually for a vacuum hose that may have fallen off (or split) on or near the MAP sensor.

Aug 19, 2009 | 2005 Nissan Altima

Not finding what you are looking for?
2004 Jeep Grand Cherokee Logo

Related Topics:

634 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

Marvin
Marvin

Level 3 Expert

81400 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...