Question about 1993 Toyota Celica
Posted by Anonymous on
Water pumps on front wheel drive toyotas are typically driven with the timing belt. You will have to support the engine weight from below and remove the upper right engine mount. The external belt driven alternator and A/C pump belts are in the way and they must be loosened and belts removed to pull off the plastic timing belt access covers. Once you pull the top cover off, you will see the water pump. Be sure to set your timing right after your pump replacement. The idler pulley tensioner often does not provide enough force to maintain tension on the timing belt, so you will have to pry on it before you tighten it's bolt. If you don't, then the belt may slip and your car will not run.
Posted on Nov 14, 2010
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: fuel pump for 2000 toyota celica
Yes, remove the rear seat cusion and then lift up the padding. Take the screws out of the cover and them you can access the top of the fuel tank and remove the pump and fuel level sending unit.
Posted on Mar 02, 2009
Start vechile, let it warm up, turn on heater, is there heat from the heater?
No? You need to bleed the system better. Jack the front of the car up, remove radiator cap, while throttle is increased add more coolant, then with throttle still increased put radiator cap back on and release throttle. Is there now heat?
Posted on Aug 23, 2010
If I am not mistaken you have to change out the timing belt also when changing it cause it runs off the timing belt. So you will have to pull the front side of the motor down. Big job did one on a accura
Posted on Sep 19, 2010
SOURCE: Changed battery in 1993 Toyota
Sounds like the security system went off, If you have the remote control shut all the doors & cycle the door locks, (lock & unlock. if that does'nt work there may be a reset button somewhere under the dash, usually with key on hold button about a second or two.
Posted on Feb 17, 2011
Tips for a great answer:
Dec 10, 2014 | 1992 Toyota Celica
Mar 28, 2013 | 1993 Toyota Celica
Dec 14, 2010 | 1993 Toyota Celica
Mar 19, 2010 | 1993 Toyota Celica
Feb 19, 2009 | 1998 Toyota Celica
Jan 01, 2009 | 1993 Toyota Celica
Dec 14, 2008 | 1991 Toyota Celica
Oct 20, 2008 | 1993 Toyota Celica
844 people viewed this question
Usually answered in minutes!