Question about 2002 Ford Excursion

1 Answer

Drivers side low beam headlight not working. its not a blown fuse

One headlight not working

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 62 Answers

The headlight bulb has burned out, replace with correct part number and it should work fine. Contact me at FixYa if you need anymore assistance. Thank you.

Posted on Sep 26, 2010

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: Driver side Headlight Replacement

I am car stupid. Just following the instructions in the owners manual, I was able to replace my low beam driver side bulb in less than a half hour. Only one tip. When it says pull straight up on the tab, definitely oil it first. I snapped the tab off and cut myself because it didn't have enough give.

Posted on Jan 19, 2009

  • 10865 Answers

SOURCE: Low beam, driver's side headlight

The low beam bulb needs to be replaced. Go to an autozone store as they will sell you the bulb, and even assist you in their parking lot with installing it.

Posted on May 06, 2009

  • 99 Answers

SOURCE: Low Beam headlight and front parking lights do not work

see for the head lamp relay fuse a few manufacturer install a typical fuses for seprately for relay so see weather the fuse are ok or not then see for wiring as far you mention that the wiring of right side went streached to the lower ball joint there is a possibality that wire's can break internally & may get shot circuited due to cross circuit & may cause this sort's of problem & if possible show it to highly experience person techanican, mechanic or an authorised dealer or service centre who can sortout you car problem untill then see you soon my friend

Posted on May 08, 2009

mcgyver468
  • 710 Answers

SOURCE: driver side low headlight beam doesn't recieve power

UNDER THE HOOD ON THE DRIVERS' SIDE YOU WILL SEE THE FUSE BOX. LOOK FOR THE FUSE DIAGRAM UNDER THE FUSEBOX COVER, TO LOCATE THE FUSE FOR THE HEADLIGHTS. SHOULD BE A 10 AMP FUSE. CHANGE IT WILL A GOOD ONE, AND LET IT SHINE. HOPE THIS HELPS. KEEP ME POSTED. THANK YOU FOR AN HONEST RATING AND FOR USING FIX-YA. GOOD LUCK

Posted on May 13, 2009

villalovos
  • 20 Answers

SOURCE: Drivers side headlight does not work on low beam

You have to trace the wire back to power. You need a volt meter with a continuity tester. Get one that makes a nosie when it makes continuity. You can look on youtube to see how to do this. Good luck.

Posted on Nov 06, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Driver side low and high beam on but dim. Passenger side low beam normal but high beam on and dim


I would check for the groundwire continuity

Driver side - dim low beams and no hi beam - Subaru Outback ...

www.subaruoutback.org > ... > General > Electrical & Electronics
Oct 11, 2014 - Hi everyone, My drivers side headlights are dim on low, (car has separate bulbs ... When the headlight switch is turned ON, but for low beams, ...

Driver-side Low beam Not Working (electrical issue not bulb ...

www.hummer4x4offroad.com/.../showthread.php?...Driver-side-Low-be...

Mar 12, 2015 - 10 posts - ‎4 authors
The high beam continues to work on both sides...I pulled the Driverside headlamp fuse and then both left and right beams lit up but very dim.

High beams ok, but not low beam - one side only - TDIClub Forums

forums.tdiclub.com > ... > VW MKIV-A4 TDIs (VE and PD)
Jan 23, 2014 - My driver's side lights are working fine - high and low beams. ... But it definitely looks like the big lamp on the driver's side gets brighter when ..... Drivers side headlight is very dim on low beam and goes out when on high beam ...

Dim driver's side headlight (low & high beam) - GrandAmGT.com Forum

www.grandamgt.com > ... > Technical Q&A

Dec 11, 2002 - 6 posts - ‎4 authors

Jan 04, 2016 | Cars & Trucks

3 Answers

I have a 2007 Chrysler sebring and drivers low beams will not work.


try the fuses or wire fuse links , the only other thing in the circuit is the wires broken or the light low switch is bad

Nov 08, 2014 | 2007 Chrysler Sebring Sedan

1 Answer

Prius headlights work only on highbeam


There should be separate fuses for high and low beams on a Prius. If one of your headlight bulbs is bad, it could have blown the low-beam fuse. Check for blown fuses behind driver's side headlight fuse panel. If new one blows, replace headlight bulbs and try again.

On 2004-2009 Prius, driver's side headlamp bulb can be replaced by removing hold down screws and folding fuse panel upward to access rear of headlight assembly. Large round cover with 3 tabs unscrews about 1/4 turn to remove. It's really tight and held by friction of large O-ring so it'll take some muscle but it will eventually give. Be careful replacing bulbs as metal clips can be easily installed incorrectly resulting in tilted headlight beam. 3-tabs must rest on flat surfaces on mounting area before spring clip can be latched in place. 3-prong plug can be wiggles sideways/up and down to remove from bulb.

Oct 24, 2013 | 2006 Toyota Prius

2 Answers

My low beam headlights do not work as daytime running lights or manually with the headlight knob pulled out . The high beam headlights however do work if I have the knob pulled out all the way with the...


Check out your fuse associate with the low beam headlight, secondly there is a relay fuse under fuse rely box under the hoos. Locate this box, and locate the relay fuse associated to the low beam. You can rotate the relay with another relay of the same spec to see if the low beam lights are coming on. I would believe that it is a fuse that is blown, check your owners manaual on the location of the fuse box. Usually it's located in the driver side kick panel.

Jan 30, 2011 | 2001 Buick Regal

1 Answer

Acura 2003 3.2TL driver side headlight low beam is out...is not the bulb ..how can this be? any idea?


most newer vehicles have individual fuses and or relays that controls each headlight separately, check the fuse panel under the hood, inside the lid there is usually a listing of what the fuses and relays do. look for drivers side low beam and take a look at the fuse, if it blown, try to replace the fuse, but there is usually a reason why it blew in the first place.
How did you test to see if the bulb was still good? ive seen dead bulbs that still look ok, try and plug the bulb from the non working side into the working side and double check.

Nov 24, 2010 | 2002 Acura 3.2TL

1 Answer

Low Beam Drivers Side doesn't work ... low voltage,


Power for the headlights on the Left side (High and low beam.) comes from the same fuse... The ORANGE wire and the ORANGE/BLACK are the same, they connect in the harness. If you only lack the 12v to make the light work connect them at the headlight assembly.

If your low beam also lacks ground the Left low beam ground is shared with the right low beam ground... Run a wire from left low beam DARK BLUE to right low beam DARK BLUE/WHITE.

If its not working now then your cursed, seek a witch doctor.

May 23, 2010 | 2004 Buick Regal

1 Answer

The drivers side low beam was out so I replaced


there is a fuse for each side of the headlights check for a blown fuse.

Jan 29, 2010 | 2001 Lexus RX 300

2 Answers

One high beam works one doesn't, gauge cluster does not light up


you say you replaced both bulbs, you mean right and left or both the high beam and the low beam on left side?could be a bad ground for the left headlight. there should be some ground wires there near the headlight, LF corner under hood. without a wiring diagram here at home,I am not much help.

Sep 26, 2009 | 2000 Honda Accord

5 Answers

I have no headlights!! parking lights, taillights,and blinkers all work fine. none of my fuses or bulbs are blown


I have a 2004 ram 2500 and all my lights work except for low beams. It is not in the switch, I haver replaced the switch with no change. This is a circuit problem with these dodge pickups. I haven't firgured out what it is but it isn't the switch. and unless the low beams and high beams are fused seperate, it isn't a fuse problem either. i have looked for a fuse and can't even find the fuse for the headlights. Im lost like you!

Jun 15, 2009 | 2001 Dodge Ram 1500 Truck 2WD

Not finding what you are looking for?
2002 Ford Excursion Logo

182 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

fordexpert

Level 3 Expert

5626 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...