Question about 2003 Lexus RX 300

Open Question

How to fix 2003 Lexus rx300 oxygen sensor Bank 1 Sensor 1

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 323 Answers

SOURCE: how to replace an oxygen sensor bank 1 and exhaust gas recirculation sensor

The EGR valve is attached to the intake manifold near the throttle body and the 1/1 O2 sensor is on the rear exhaust manifold.

Posted on May 02, 2009

Ad
ghassun
  • 499 Answers

SOURCE: check engine light is on...bank 1 sensor1 oxygen sensor

if u have one oxygen sensor then u need to take a deep look at the bottom of ur car it will be somewhere at the Exhaust pipe if u have a catalytic converter then u will have two oxygen sensors one before the catalytic converter & the other will be after the catalytic converter. Note: the catalytic converter is located at after a little bit of beginning in Exhaust pipe.

Posted on Jun 06, 2009

daves944
  • 1050 Answers

SOURCE: Where is Bank 1 Sensor 1 on an 2003 Oldsmobile Sillohuette?

"Bank one" is the bank of cylinders that starts with the #1 cylinder. In this case this will be the bank of three cylinders that is closest to the firewall. Sensor #1 refers to the O2 sensor that is between the engine and the catalytic converter. So the Bank 1, sensor 1, will be the O2 sensor that is mounted in the rear exhaust manifold or tubing just before the cat.

Posted on May 16, 2009

  • 58 Answers

SOURCE: Where is the O2 sensor located - Bank 1/sensor 1?

on the exhaust manifold

Posted on Jun 19, 2009

emissionwiz
  • 83096 Answers

SOURCE: Replacing bank 1 sensor 2 and bank 2 sensor 1 oxygen sensors

BANK ONE IS THE REAR BANK OF CYLINDERS AND TWO THE FRONT BANK

Posted on Jun 24, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

I have a 2000 Lexus rx300 with a code p1130. what is the location of the sensor causing this code ?


That code doesn't mean any sensor is defective, it can be the sensor, problems with the engine or a faulty fuel injector or the wiring or the engine control computer that triggered the fault.



P1130 Lexus Air Fuel Ratio Sensor Circuit Range Performance Malfunction...

Apr 30, 2017 | Lexus Cars & Trucks

1 Answer

What does code system to lean bank 1 mean on my 2000 lexus rx300


It could be caused by many things, but generally it means that your engine is running too lean - usually indicating a vacuum leak. It could also be that the O2 sensor is bad and giving a false reading.

Apr 10, 2014 | 2000 Lexus RX 300

1 Answer

2003 Lexus GS300 P0031 code


Yes the O2 sensor preheater problem will turn on the VSC light, see the complaint often, why? don't know
.P0031 TOYOTA - Oxygen Sensor Heater Control Circuit Low Bank 1 Sensor 1
In most cases the O2 being replaced cures the code but here is the full story.
Possible causes- Air-Fuel Ratio (A/F) Sensor Bank 1 Sensor 1 circuit open shorted to ground
- Air-Fuel Ratio (A/F) Sensor Bank 1 Sensor 1 circuit poor electrical connection
- Faulty Air-Fuel Ratio (A/F) Sensor Bank 1 Sensor 1 circuit
- Air-Fuel Ratio (A/F) Sensor Bank 1 Sensor 1 circuit fuse
- Faulty Engine Control Module (ECM)

Jun 16, 2012 | 2003 Lexus Gs 300

2 Answers

Code P0037 on Santa Fe refers to bank 1 sensor 2 oxygen sensor. Where is it located?


Bank one is the first oxygen sensor in line from the engine back. Bank 2 is the second in line.

Apr 01, 2012 | 2001 Hyundai Santa Fe

2 Answers

The engine light and VSC light are on (Vehicle Singapore 2004 Lexus RX 300. Diagnostics report Error code P0037


your o2 sensor is bad. vsc will go on for any small DTC displayed on the MIL (cel)

P0037 LEXUS P0037 LEXUS - Oxygen Sensor Heater Control Circuit Low Bank 1 Sensor 2 Symptoms - Engine Light ON (or Service Engine Soon Warning Light)
Possible causes - Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2 circuit open shorted to ground
- Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2 circuit poor electrical connection
- Faulty Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2 circuit
- Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2 circuit fuse
- Faulty Engine Control Module (ECM) When is the code detected? The P0037 is set when the ECM detects an excessively low voltage through the heated oxygen sensor heater circuit P0037 LEXUS Description Oxygen Sensors (O2S) or Heated Oxygen Sensors (HO2S) need to reach a minimum operating temperature of 750 degrees F to produce an accurate voltage signal. The faster the heated oxygen sensor reaches that temperature the faster the sensor will start sending an accurate signal to the Engine Control Module (ECM).

In order to achieve the require temperature, a heater element is included inside the heated oxygen sensor. The ECM controls the heated oxygen sensor heater element based on signals from the engine coolant temperature and engine load. The ECMcontrols the heater element circuit by allowing current flow to ground.

The ECM monitors the voltage signal received through the heater element circuit and determines the state of the circuit by comparing the voltage detected with the factory specifications.

o2_heater_circuit.gif

Mar 14, 2011 | 2004 Lexus RX 330

1 Answer

My 2003 Kia Optima check engine light keeps coming on. I was told "Bank 1 Sensor 1" needs to be replaced. Where is Bank 1 Sensor 1?


P0130 Oxygen Sensor Circuit Malfunction - Bank 1 Sensor 1.
P0131 Oxygen Sensor Circuit Low Voltage - Bank 1 Sensor 1.
P0132 Oxygen Sensor Circuit High Voltage - Bank 1 Sensor 1.
P0133 Oxygen Sensor Circuit Slow Response - Bank 1 Sensor 1.
P0134 Oxygen Sensor Circuit No Activity detected - Bank 1 Sensor 1.
P0135 Oxygen Sensor Heater Circuit Malfunction - Bank 1 Sensor 1


Jun 23, 2010 | 2003 Kia Optima

1 Answer

I have 3 codes 1) P0500 2) P0125 3) P1135 1999 Lexus RX300


The PO125 is an indication of an engine running too cold-as if the thermostat were stuck open.For some reason it often sets with the PO1135 even when the engine runs at normal temp.A scan tool will indicate exactly how hot the engine is,don't trust the dash gauge. The PO1135 is a heater circuit fault in the bank1 sensor1 air fuel ratio sensor or oxygen sensor. Bank 1 is the REAR bank on this car...that O2 sensor is not much fun.PO500 is a vehicle speed sensor fault-does the speedo work correctly?it is located in the transmission near the back of the case. once again the scan tool will read vehicle speed and can aid in further diagnosis.

Mar 30, 2010 | 1999 Lexus ES 300

1 Answer

Where is the bank1 sensor1 on Lexus RX300? I am getting P1135 error. Confused about which sensor it is.


Bank one is the side that cylinder 1 is located. Sensor 1 is in front of the cat converter, sensor 2 is behind the converter. So Sensor 1 bank 1 is the RIGHT FRONT SENSOR.

Nov 05, 2009 | 2001 Lexus RX 300

3 Answers

How to locate the oxygen sensor in a LEXUS LS430 (Bank1 Sensor1)


the O2 sensor for bank one sensor one is located between the catalytic converter and the engine in the exhaust head pipe. see photo of your engine cylinder layout, the sensor u want to replace is the one at the cylinder #1 0aa2e73.gif bank on right.

Apr 15, 2009 | 2001 Lexus LS 430

Not finding what you are looking for?
2003 Lexus RX 300 Logo

Related Topics:

961 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lexus Experts

Marvin
Marvin

Level 3 Expert

83096 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

918 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22382 Answers

Are you a Lexus Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...