Question about 1997 Jeep Wrangler

1 Answer

Hello i have a 1997 Jeep Wrangler 2.5L I will be

Hello i have a 1997 Jeep Wrangler 2.5L I will be doing some work on it this summer and need to know if replacing the valve cover gasket rusted muffler and tailpipe disk brakes and calipers and after-market intake will be difficult to complete. Will there be any tools needed that a basic mechanic set can't take care off? With these jobs are there any useful pieces of information that could be overlooked? i ordered a haynes Jeep manual but it has not arrived yet. What will it probably miss when describing these repair jobs? thanks jordan

Posted by Anonymous on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Jeep Master
  • 22,382 Answers

No just a standard socket set with regulation big hammer and a screwdriver kit will do

Posted on Jul 17, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Why will my 1997 Jeep Wrangler will start with jump but will not restart

Your battery needs to be replaced, or the terminals need to be cleaned with baking soda and water ( 1/2 cup baking soda to 1 cup of water ) or a spray can of terminal spray from an automotive outlet.


Aug 15, 2014 | 1997 Jeep Wrangler

1 Answer

How do you remove factory radio in 1997 jeep wrangler

Some of it (well most of it) just needs something flat to kind of pry off but there are a few screws (some kind of hidden) that need to be removed before prying. Below are some instructions that I hope help. Hope it does.




Jan 18, 2012 | 1997 Jeep Wrangler

1 Answer

I need to replace the cam sensor on my 97 jeep wrangler were do i find it in the motor..

For 1997 Jeep Wrangler 4WD 4.0L MFI 6cyl the Camshaft Position Sensor is located: Under hood, passenger side, front engine area, mounted on front of intake manifold

Hope helps (remember to rate this).

Oct 12, 2010 | 1997 Jeep Wrangler

1 Answer

1997 Jeep Wrangler 4wd high disengages

you might try checking the linkage on trans case shifter. may need adjusting. might not be getting fully engaged

Feb 06, 2010 | 1997 Jeep Wrangler

1 Answer

How do i get to my defroster on a 1997 jeep wrangler? it's quit working and i dont know what parts of the interior i need to remove to get to it.

its the blower motor in the dash. its on the passenger side. Go buy a chiltons or a haynes manual and it would walk you threw it. Good investment for the step by step instructions.

Nov 05, 2009 | 1997 Jeep Wrangler

1 Answer

Same problem here.

It is possible that it lost fluid so just crack the bleeder vavle till fluild comes out, once it comes out close bleeder valce and try to move pedal. if it does not move then get a second person to push pedal all the way to the floor then open bleeder valve until you get solid fluid flowing out of it. then lock the bleader valve and see if the clutch push rod will move.If it does not move then the seals on the master or slave have gone bad and recommend replacing both at the same time.

Oct 05, 2009 | 1997 Jeep Wrangler

1 Answer

Crank, no start 98 wrangler 2.5l

crank sensor likely-may be distributor sensor but my 98 sport was crank sensor situated in bell housing timed by flywheel

Sep 15, 2009 | 1997 Jeep Wrangler

4 Answers

Air conditioning???

not really i had a 1995 and the a/c was seperate. who needs a/c with a soft top anyways. so in short no they weren't tricking you it was seperate

Jun 20, 2008 | 1997 Jeep Wrangler

Not finding what you are looking for?
1997 Jeep Wrangler Logo

145 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts


Level 3 Expert

83096 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22382 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides