Question about 2004 Dodge Intrepid

1 Answer

Need instructions on how to replace the cooling

How do I replace the cooling fan assembly on a 2004 Dodge Intrepid?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Dodge Master
  • 6,826 Answers

Removal & Installation To Remove:

  1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
  2. Remove or disconnect the following:
    • Radiator upper crossmember
    • Fan motor electrical connector
  3. Drain cooling system below the level of the upper radiator hose.
  4. Remove or disconnect the following:
    • Upper radiator hose from radiator
    • Radiator fan fasteners and upper clip
    • Fan assembly by lifting upward to clear radiator
To Install:
  1. Install or connect the following:
    • Radiator fan assembly
    • Upper clip and fasteners
    • Upper radiator hose to radiator
    • Fan motor electrical connector
    • Radiator upper crossmember
  2. Fill cooling system.
Need instructions on how to replace the cooling - prev.gif next.gif

Posted on Jul 17, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My dodge intrepid over heatz when my heat dont work every few dayz


Hi David, I'm glad to help. 3 Things could be happening here. (1) There could be air trapped in the cooling system somewhere, which you can remove with thye bleeder screw near the thermostat housing. Try this first. (2) The cooling fans may be trying to go out for the radiator. The next time the problem occurs raise the hood and see if the cooling fans are working, if not replace the cooling fan module from the dealer. (3) Blown Head Gasket. This is not very likely because you say it happens ever few days and if it were a head gasket then it would happen after running a few minutes everytime. Hope this helps and have an awesome day David.

Apr 26, 2014 | 2004 Dodge Intrepid

1 Answer

Universal joint


On a 2004 Intrepid it does not have Universal Joints, you will have Constant Velocity Joints. If you have one that is rough and noisy it will either need to be rebuilt or replaced. It is usually cheaper to replace the whole half shaft assembly that is it to rebuild one CV joint, this is also much easier as the whole axle is fully assembled. You just have to pop out your worn out pieces and install new axle.

Apr 24, 2013 | 2004 Dodge Intrepid

1 Answer

Car overheat when first run turn car off and back on and car run cool


You might need to replace fan assembly and/or thermostat. Mine was overheating only when stopped at traffic lights. Only one fan was working and would cause the car to overheat. Working great after fan swap.

Jun 20, 2012 | 2002 Dodge Intrepid

2 Answers

Just yesterday my car started making an unusual noise. It is a 2004 dodge intrepid se 2.7ltr I took it to the mechanic who said it was my pass side cooling fan motor. He wanted to charge me 900 bucks to...


thats the spirit you let these crooks who try to ruin our businesses reputation 900 is way too much easy yes go to auto zone if you have one near you or o Raileys
these people are there to help you select the right part for yopur car you need more inf e=me back and i will help you through the repair

Oct 08, 2009 | 2004 Dodge Intrepid

1 Answer

How do i take out a cooling fan out of a intrepid


YOU MUST REMOVE UPPER RAD SUPPORT TO REMOVE COOLING FANS..REMOVE ALL 10MM,13MM HEADED BOLTS..REMOVE 4 HEADLAMP SCREWS..7MM HEAD..THERE ARE 2 PLASTIC RIVETS THAT MUST BE CUT OFF AS WELL..HOOD LATCH CAN STAY WITH SUPPORT,LAY BACK ON TOP OF ENGINE OR REMOVE IT..MARK LOCATION ON SUPPORT..REMOVE 4 BOLTS FROM FAN ASSEMBLY,UNPLUG IT..IT ALSO COMES OUT EASIER WITH UPPER RAD HOSE DISCONNECTED..1 CLIP ON TOP OF FAN HOUSING AS WELL

Aug 31, 2009 | 2001 Dodge Intrepid

2 Answers

2004 dodge intrepid cooling system purging valve housing


2004 dodge intrepid cooling system purging valve

Aug 10, 2009 | 2004 Dodge Intrepid

1 Answer

Radiator fan not turning on 01 intrepid


could be fan relay, thats what fixed my problem

May 31, 2009 | 2004 Dodge Intrepid

2 Answers

My 97 dodge intrepid 3.5L is running hot.


Most likely a bad fan relay, or a bad temp sensor. Does the fan come on with the A/C? If not, most likely the relay, if so, most likely the temp sensor.

Mar 13, 2009 | 1997 Dodge Intrepid

1 Answer

2004 dodge intrepid


you need a fan relay and a thermostat.

Oct 17, 2008 | 2004 Dodge Intrepid

Not finding what you are looking for?
2004 Dodge Intrepid Logo

475 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

82322 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22382 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...