Question about 2006 Pontiac G6

1 Answer

How do i change the spark plugs in a 2006 pontiac G6

Posted by Anonymous on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Pontiac Master
  • 22,326 Answers

Get your 3/8th socket set out with extra extensoins and knuckles and then work out what ones you need for accesability for each individuel plug ,

Posted on Jul 17, 2010


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 2 Answers

SOURCE: engine light 2006 pontiac g6(reset)

first be sure that its the engine light and not the "service" light. the service light will usually illuminate if its time for an oil change. if its the service light ur owners manual should tell u how to reset it. if its ur engine light then try disconnecting ur positive battery cable for 1 minute. that should reset ur ecm and get rid of the engine light. if the engine light comes back on then have a diagnostic scan done to determine whats causing it. LJ

Posted on Dec 29, 2008

  • 1986 Answers

SOURCE: What is the tirck to change the headlights on a

  1. On the back of the assembly, unplug the harness that goes to the bulb.
  2. Then pull off the rubber sealer.
  3. There's a wire clip that goes along the bottom side of the bulb to hold it in place. Push that clip in (towards the front of the car) and down to release it.
  4. Pull out the old bulb.
  5. Insert the new bulb the same way (do not touch the bulb as that will cause it to exploded later on from the oil residue. Clean with rubbing alcohol if you touch the glass)
  6. Twist it back and forth to make sure it locks into place.
  7. Replace the clip by pushing in and up until it clicks into place.
  8. Replace the rubber sealer. Push around the entire edge until it snaps into place.
  9. Replace the wire harness.

Posted on Nov 20, 2009

  • 1263 Answers

SOURCE: power steering cap location Pontiac G6 3.5L

it is located on the passengerside under the altenator closest to the firewall. make sure the vehicle is turned off reach in under the altenator and you should feel the cap.

Posted on Sep 15, 2008

  • 880 Answers

SOURCE: how do I expose the motor on a 2006 pontiac g6 to

Remove everything from the headliner and remove all of the trim holding it in place. Carefully pry the headliner out from one side and the rest will now be easily removed. Unless the car has been subject to abuse and intense heat the headliner will not come loose from the backing and can be reinstalled.

Posted on Mar 27, 2010

  • 11 Answers

SOURCE: changing rear brakes on 2006 pontiac G6 how do i

Ok! here is the solution ...
After changing the pad dont try to push back the piston the old fashioned way or you will broke the caliper casting.
This new kind of break should be only twisted clockwise to bring the piston back to its position you can use only long nose pliers to rotate the piston since there is two cavity on the piston for this use.
Also after setting the piston back to it's position take care of the seal around the piston be shure before replacing the caliper over the disk that the seal will not go between the disk and the pad...
slide the pads gently to it's position and that's it.

Posted on May 10, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How to change the rear spark plugs on a 2009 ponitac g6

follow this link for a bit of advice , i'd also remove the coil pack for the rear plugs , making sure you mark the HT leads , dont want them mixed up
3 5 V6 G6 pontiac spark plugs locations

Jul 18, 2014 | 2006 Pontiac G6

1 Answer

When do you replace spark plugs in a pontiac 2008 G6

scheduled maintenance is at 85k.use double platinum plugs!

Nov 03, 2012 | 2006 Pontiac G6

1 Answer

My g6 is running to lean

Bad O2 sensor. Need to check with scanner to make sure O2 sensor is functioning properly.

Dec 31, 2011 | 2006 Pontiac G6

1 Answer

I want to change the spark plugs in my 2006 pontiac g6, but don't know how to get to them. I'm a female trying to do this.

Best thing for you to do first is go to the library and look in a motors manual for general instructions.

Be careful, you will soon be in over your head if you are not careful ... male or female.

Thanks for using

May 01, 2010 | 2006 Pontiac G6

1 Answer

Pontiac g6 2006 2.4l codep0300,idles is good but

that code is an engine misfire. try changing the plugs and wires. if that doesnt work you may have to change the coil packs.

Feb 23, 2010 | Pontiac Torrent Cars & Trucks

1 Answer

How do you access the spark plugs on 4cyl 2006 pontiac g6

You will have to remove the cover that is located on the top of the transmission.

Oct 03, 2009 | 2006 Pontiac G6

Not finding what you are looking for?
2006 Pontiac G6 Logo

Related Topics:

1,615 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts


Level 3 Expert

81294 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides