Question about 1993 Geo Metro

Open Question

1993 geo metro no spark, replaced coil, plugs,wires, cap,

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 3 Answers

SOURCE: engine cranks ,but no spark.

ain t many more parts to electrical system left... i had same problem once n it was my ignition modulator.located under distributer.**** i can t remember,i think my car would not turn overfrom that.or only other thing could be a fuse.i 'd check every fuse too .hope this might help.

Posted on Mar 12, 2009

Ad
  • 9 Answers

SOURCE: 93 geo storm starting problem. turns over but has no spark.

make sure timing belt is good and in time

Posted on Mar 18, 2009

  • 10 Answers

SOURCE: 1993 blazer 4x4

I assume you have the 4.3 vortec. If so, check to make sure you have the spark plug wires in the right position on the distributor cap. firing order is 1,2,3,4,5,6. right side of engine is 1 front 3 middle and 5 rear. Left side of engine is 2 front, 4 middle, and 6 rear. On the distributor cap # 1 should be toward front of engine and work counter clockwise from there. Hope this is helpful. KS

Posted on Mar 20, 2009

SOURCE: spark plug gap

.045

Posted on Apr 19, 2009

blueextc3221
  • 15935 Answers

SOURCE: Whats the spark plug setting on 92 Geo Metro?

you mean the gap?
Plug gap is 0.39 thousands of an inch.

Thanks for using FixYa - a FixYa rating is appreciated for answering your FREE question

Posted on Apr 23, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

1995 geo metro humid weather starting problems 3 cylinder


Next time it doesn't start, spray your plug wires and distributor cap with WD40. If it fires right up replace your plug wires. I had the same problem with my 3 cyl 1.0L .

Feb 20, 2015 | 1995 Geo Metro

1 Answer

My 1991 geo metro turns over but wont start


spray some starterfluid in there see if ur getting gas. check ur plugs and gaps. cap, rotor if none of that it may be a coil pack or the ICM a way to check the coil pack is to remove one of the spark plug wires from the cap an rotor an hold it close but not tuching the cap and turn it over to see if there is a spark if so that means the coil is good

Dec 24, 2012 | 1995 Geo Metro

1 Answer

Geo metro no gas to TB , no spark from coil


97 geo metro no spark fron coil set the timing still no fire replace crack. sencer. no spar k . whats wrong

Jul 26, 2012 | 1997 Geo Metro

1 Answer

Were is spark plug number 1 at on my 3 cylinder geo metro


On GM inline engines,cylinder #1 is the one closest to the front(pulley)end of the engine. If you pulled the wires off the distributor/coil pack,and don't know where they go,put one wire one at a time and crank it.If it doesn't backfire,repeat until it starts.(this is only easy on 4 cylinder or smaller engines)

Jan 01, 2012 | 1992 Geo Metro

1 Answer

It put putted and then died. It has a new battery however i think it needs new spark plugs. Im not sure.


With the age of the vehicle all ignition parts are suspect and most likely need changed. IE coil/coilpacks, wires, plugs.

Jun 12, 2010 | 1993 Geo Metro

1 Answer

95 geo metro 3cyl. 1.0L no spark changed


Pull one or two sparkplugs and check them for moisture; not fuel, but for water beads.
I don't know how long your engine ran after losing coolant but there is a chance that you lost the head gasket and have gotten water into the cylinders.

Nov 26, 2009 | 1992 Geo Tracker

1 Answer

92 geo just stopped running while driving!


I would check your coil or your distributer. The easiest way to check to see if you have a spark would to pull the spark plug out then plug it back into the spark plug wire. Ground it off to the engine mount or any good gound, then have someone turn the key and see if the plug sparks. (Make sure you wear electric gloves while doing this.)

May 15, 2009 | 1993 Geo Metro

Not finding what you are looking for?
1993 Geo Metro Logo

Related Topics:

132 people viewed this question

Ask a Question

Usually answered in minutes!

Top Geo Experts

Marvin
Marvin

Level 3 Expert

81400 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Mike Gilbreath

Level 1 Expert

50 Answers

Are you a Geo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...