Question about 2000 Chevrolet S-10

1 Answer


Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 3,092 Answers

Has two, one after the cylinder head, and the other after the catilitic converter.

Posted on Jul 16, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Where the flex fuel sensor of the ford taurus 2001 is located?

You may be speaking of the Fuel Pump/Fuel Gauge Sensor located Under Car On Front Side Of Fuel Tank. I never heard of a Flex Fuel Sensor.

Feb 28, 2015 | 2001 Ford Taurus

2 Answers

2000 navigator system too lean

Too Lean on which Bank of the Motor?

To have a lean O2 Code --you could have a rich fuel
condition & the pcm drove the fuel trim lean

Next you could have a vacuum leak-in the intake or exhaust system

Third you could have a failed O2 Sensor

Front or Upstream Oxygen Sensors get replaced at 100,000 miles

The front sensors are on the exhaust pipe between the motor &
the converter.

Will need a long handled flex head O2 Sensor Wrench

Mar 17, 2014 | 2000 Lincoln LS

1 Answer

Where is the 02 sensor on a2002 lincoln continnetal

There are four sensors on the Continental cat converter. Because it is front wheel drive, the engine is rotated 90 degrees compared to a rear wheel drive. Next up is location. Front O2 sensor should be near the radiator.It will have a green connector where it is plugged into wire harness. It is called left sensor on the frt wheel drive cars. The right hand O2 sensor is downstream on the inlet pipe right above number 2 cat, the one that looks like a catchers mit, ahead of the flex pipe.Sensor 1 reads air/fuel mixture and is commonly called O2 sensor 1. remember green connector. Sensor 2 monitors the function of your catalytic converter and have a blue connector plug. Front wheel drive cars are a bit tougher because everything is 90 degrees off of diagnosis, front,rear, number 1,number 2. BTW, the sensors with blue connectors are called CMS sensors for catalytic monitor system and rarely go bad. Auto Zone scans for free and I would have it scanned before popping 40 bucks for new.

Apr 04, 2013 | 2002 Lincoln LS

1 Answer

I have a 2003 hyndai elentra an i had both 02 sensors replaced plus flex pipe and check engine light came back on with 02 sensor error

Try first to clean out the MAF sensors and the intake with tuner cleaner spray. Check also the the fuel regulator. Check also for holes and gapes from the air filter to the intake manifold. An error on the O2 sensor mean does not mean it is faulty. It may also be related to the air fuel mixture. Check also the wiring of the sensors (MAF and O2).

May 02, 2011 | Hyundai Motor 2003 Elantra

2 Answers

My 2003 ford taurus gas gauge doesnt work took it to get the emissions done and the car failed they told me it was the fuel sensor where is the sensor located and is it expensive to fix

is it a flex fuel vehicle? if so it's usually the flex fuel module, logated behind the radio and slightly to the left. get a set of radio removal tools(two u shaped wire tools and fairly cheap) remove radio and replace module (also fairly cheap)

Dec 22, 2010 | 2003 Ford Taurus

1 Answer


On almost every car, there is an O2 sensor located in the front, on the exhaust pipe, or manifold, and there is an O2 sensor located after the Catalytic converter. The front O2 sensor is the most important because it monitors the air/fuel ratio. The rear O2 sensor checks your Cat converter for proper operation and filtering.

I’m happy to help further over the phone at

Jul 10, 2010 | 2005 Pontiac Montana SV6

1 Answer

Yes it is flex fuel

Chrysler flex fuel systems use the o2 sensor to determine how much alcohol is in the fuel. When the o2 sensor goes bad it make the vehicle runs real rich because the computer thinks you are running e85 when you are running regulator unlead. Replace the o2 sensor. Unhook the battery while you are changing it. That way when you hook it back up after changing the o2 the computer will reset your fuel trims.

Apr 16, 2010 | 2001 Chrysler Town & Country

1 Answer

After the flex pipe was replaced the engine light came on and indicated the bank1 sensor2. Could the flex pipe installation have caused this and where is this sensor located?

The sensor is located behind the catylst depending on how many o2 sensors you have. make sure there are no exhaust leaks.

Jul 07, 2009 | 1999 Toyota Camry

1 Answer

O2 sensor wires

check here sir..
please click the link provided.hope this helps

Dec 27, 2008 | 2004 Chevrolet Tahoe

Not finding what you are looking for?
2000 Chevrolet S-10 Logo

Related Topics:

92 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

83054 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22382 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides