Question about 1996 Honda Passport

1 Answer

I have a 1996 honda passport V6, the car was scanned and found code p0134. the car runs but after a few minutes of warming the car stalls and backfires runs terrible what can cause those type of problems

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Honda Master
  • 17,970 Answers

This code refers to the front oxygen sensor on Bank 1. Basically the oxygen sensor is inactive.

DTC P0134 - 02 Sensor Circuit No Activity Detected (Bank I Sensor 1)

The powertrain control module (PCM) provides a baseline voltage of about 450 mV on the oxygen sensor signal circuit. When cold, the PCM detects the the internal resistance of the sensor is high. As the sensor warms up the resistance is lowered and it starts producing voltage based on the oxygen content in the exhaust. When the PCM determines that the time it took for the sensor to warm up is greater than one minute or that the voltage is inactive (not reading outside 391-491 mV it views the sensor as inactive or open and sets the P0134 code.

Potential Symptoms: One or more of the following may occur:
* Check engine light illumination
* Poorly running/engine missing
* Blowing black smoke
* Poor fuel economy
* Dying, stuttering

Causes: A code P0134 may mean that one or more of the following has happened:
* Bad O2 (oxygen) sensor
* Bad heater circuit in the O2 sensor
* Wiring or connector to the sensor frayed / broken
* Blown heater circuit fuse
* Holes in the exhaust system
* PCM failure

Possible Solutions: The most common fix is to replace the oxygen sensor. But that doesn't rule out the possibility of:
* Rusted exhaust pipe
* Inspect wiring & connector(s) for problems
* Excessive amperage blowing heater fuse (still requires replacement of sensor but also replacement of blown fuse)
* Replace PCM (only as last resort after all other possibilities are covered.


Hope helps (remember rated and comment this).

Posted on Jul 16, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1996 Honda passport lx/DX 4 door 4wd red 5 speed w/ izzuzu 32valve v6


honda/rodeo clone with the correct motor fitted
what was the question ?

The Isuzu V engine is a family of all-aluminum 75° V6 gasoline engines produced by Isuzu . ... This engine featured 175 hp from 1993-1995 and 190 hp from 1996-1997. ... in Japan, and in North America as Isuzu Rodeo and the Honda Passport . .... engine was Isuzu's newly developed 4.2L, DOHC 32 valve V8 engine, and ...








index-aelxbr5kxdhuwv0cdiipzwja-2-1.jpg

Apr 22, 2017 | Honda Cars & Trucks

1 Answer

Miss firing


USA car?
engine runs bad, gross misfiring, and stalls and idle speed all wrong>?
and of course all engines smell of unburned fuel when misfiring..so..
and gross loss of power. from engines. sure that is misfire too.
so lets work MISFIRE
fist what engine is this, sure the HONDA mistake,
its really an Isuzu engine. (abomination car) with USA axles. wow.
2.6L 120 hp (89 kW) I4
3.2L 175 hp (130 kW) V6

which engine, we cant fix engines blind. so...
so i drop to generic answsers...... no eng.
1: ever do the 60,000 mile tuneup,?? if not ?,FAIL she will..
2: are all 4 or 6 spark plugs all firing?into fresh spark plugs>?
3: is compression at or or better than 150PSI? on all cyl.
4: is it flooding?
5: is the check engine light on key on then goes out running?
if the CEL hangs up glowing running then scan the ECU.
scan it and get the DTC error codes.
use any scan tool , (OBD2) plugged into the 16pin DLC connector
near knees.
scan it and find what errors you have, i bet, P030x codes.
those are misfire, x = cylinder that is bad. 0= all.

there is a start.
fuel filter fresh. ? (if found easy near gas tank)




Feb 17, 2014 | 1996 Honda Passport

1 Answer

Stalls when trying to accelerate


I had this same problem with my 94 Passport... my mechanic replaced a catylytic converter and it ran like a dream!

Feb 10, 2013 | 1994 Honda Passport

1 Answer

Where do I hook up the scan tool on my 1996 Honda Passport


Bottom left side of dash is the plugin for the code scanner.

Jan 13, 2011 | 1996 Honda Passport

1 Answer

Honda passport 2000 3.2 l v6 eng automatic transmission the check engine light stays on i used a scan tool and it returned a code P0463 which is fuel level circuit A high input... what does this mean?


2000 Honda Passport v6 auto transmission..at time transmission did not down shift when stoping and it would stay on low grear. when going after stop it would be on low grear but pick up speed to go 45 mi. pmh but would not down shift when stoped. until maybe 3 miles and it would down shift at stop or when driving at slow speed?

Feb 08, 2010 | 2000 Honda Passport

1 Answer

1999 Honda Passport V6, transmission is slipping. How can I check the fluid?


should be a dipstick at the back of the engine on the passenger side. check wth vehicle running in neutral and warm. but if its already slipping its probably too late

Oct 03, 2009 | 1999 Honda Passport

1 Answer

Honda accord 1996 v6 2.7 liter,rpm gage jump up and down


Here is the most common cause of surges and stalls, it is the idle speed control air-bypass valve and throttle valve, they get full of gunk over the miles and cause idle issues (stalls) like yours, Get a can of intake cleaner from any local parts store, not carb spray, intake cleaner, it is made by a company called CRC, remove the air intake hose to the engine, hold the idle high so the engine won't stall, then spray the can of cleaner into the intake while keeping the engine running, use at least 1/2 the can, shut down the engine and disconnect the battery for 5 minutes, then restart and complete a number of mixed driving cycles, town, freeway, stop and go etc., after a few days the problem will go away as the system will relearn to the clean intake.

Nov 28, 2008 | 1996 Honda Accord

2 Answers

2000 Honda Passport Fuel Issue?


I have a 2000 Honda Passport. Once mine stalled, it would not restart. Sounded as if out of gas. I thought fuel pump. Took it to service station. They found a short in the electrical system. The fuse kept popping. They replaced blown fuse in coil and module. They tested misc wiring in main harness. They found and repaired bad wires in main harness for module and coils in left front inner fender. My check engine light was on for several months. Since I got it back from repair shop, it has finally gone off! I hope this helps! Good luck!

Jul 22, 2008 | 2000 Honda Passport

Not finding what you are looking for?
1996 Honda Passport Logo

707 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7711 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...