Question about 1997 Nissan Maxima

Open Question

Why do the tail lights on a 98 nissan maxima stay on

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 60 Answers

SOURCE: Nissan Maxima 2000 - no dash board lights, no tail

had same problem on my supra come to find out it was a relay switch back between the tailights

Posted on Jul 12, 2009

SOURCE: replaced tail light fuse, which turned on tail

most likely you have a short in one of the bulb connectors or the hot wire from them is pinched on medal somewhere. Or you have water intrusion shorting one out. Inspect the bulbs. Leave both bulbs out. install fuse. Press brake pedal several times and hold. Inspect fuse. if its blown its the pedal switch that's bad or a pinched wire from there. If good put one bulb in. Test again,, then the next bulb. If you see something obvious fix it.

Posted on Jul 18, 2009

bonedivers
  • 1140 Answers

SOURCE: 98 nissan frontier cant get the tail light bulb out HELP

Lower tailgate. should be screws to remove lens assy.

Posted on Sep 17, 2009

  • 2 Answers

SOURCE: 2000 Nissan Maxima. Headlights work but tail lights won't.

your dimmer switch is the proublem it is loose or just worn they wear even if you dont ever use the switch a common nissian proublem iv had the same issue

Posted on May 02, 2010

moe1986
  • 32 Answers

SOURCE: what would cause my 98 nissan maxima tail lights

check your brake light switch, which is under the bash to the top of the brake pedal

Posted on Jun 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Where is tail light relay on 1998 nissan maxima?


Is it the brake light or the running lights, are all the lights on went the ignition is in the off position and the light switch is in the off positions aswell or the brake lights are on including the third brake light?

Jun 29, 2014 | 1998 Nissan Maxima

1 Answer

What's wrong with my 96' Nissan Maxima? Bought a


I suspect you have two separate issues your lights staying on is possibly a faulty stop and tail light bulb check both , I suspect you may also have a faulty starter motor.

Jan 04, 2013 | Cars & Trucks

2 Answers

What would cause my 98 nissan maxima tail lights to stay on


check your brake light switch, which is under the bash to the top of the brake pedal

Jun 04, 2010 | 1998 Nissan Maxima

1 Answer

98 Nissan Maxima - Check Engine Light, Knock Sensor


If the car is pinging you will set a knock sensor code.'
This comes from bad gas and running lean., You really need this professionally inspected to rule out the basics. I have seen alot of nissans with the knock sensor code stored but the light is still off.
Fill up the tank with high octane chevron and some techron injector cleaner and clear the light. If it stays off for a couple days then go get it inspected. Even if the code is stored it will still pass as long as the light is still off and the monitors have run.

Jan 04, 2010 | 1998 Nissan Maxima

2 Answers

2000 Nissan Maxima. Headlights work but tail lights won't come on. How do you fix the wiring of this?I have changed the bulbs and nothing. The brake, reverse, and turn signal lights work, so the bulbs...


tail lights work on a different filament than the rest of the lights you mentioned, it is possible both bulbs are burned out for that filament. if not, check the fuses as the tail light circuit in some cars is on a seperate fuse. the remaining possibility could be bad socket contacts.

Nov 15, 2009 | 2000 Nissan Maxima

1 Answer

How do change the tail light on a 2007 nissan maxima sedan


I think it is the same as a '04 maxima. Open the trunk, from the inside remove the side trunk liner (by removing the plastic tabs the liner can be pulled back). Once the liner is pulled back you will need to remove two nuts which secure the tail light in place. Once the two nuts are removed you can start pulling the whole tail light assembly out. There are two other tabs that secure the tail light in place which may give you some resistance but the light should come out without too much force once the two nuts are removed.
Once the tail light is out you can change whatever bulbs you need to.

Jun 30, 2009 | 2007 Nissan Maxima 3.5 Sl Sedan

1 Answer

Need to change the stop light for 05 nissan maxima.


Open the trunk, from the inside remove the side trunk liner (by removing the plastic tabs the liner can be pulled back). Once the liner is pulled back you will need to remove two nuts which secure the tail light in place. Once the two nuts are removed you can start pulling the whole tail light assembly out. There are two other tabs that secure the tail light in place which may give you some resistance but the light should come out without too much force once the two nuts are removed.
Once the tail light is out you can change whatever bulbs you need to.

Jan 09, 2009 | 2004 Nissan Maxima

Not finding what you are looking for?
1997 Nissan Maxima Logo

Related Topics:

85 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...