Question about 1991 Honda Prelude

1 Answer

Where is the fuel pump on a 1991 honda prelude si

Posted by Anonymous on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Master
  • 1,623 Answers

In the fuel tank

Posted on Aug 23, 2010

6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

SOURCE: Water pump replacement

My car was overheated and my mechanic showed me the leak on the water pump..first..if you gonna replace it, u have to change the timing belt...300 dollars canadian I paid. I dk if that helps.

Posted on Aug 07, 2008

  • 3 Answers

SOURCE: honda prelude si 1991

I had the sme problem with my 1992 prelude si. The problem with mine was that the intake manifold gasket was leaking horribly. The idle would go up and down just setting there, but when I held the brake long enough it stopped. An easy way to see if it is the gasket is get WD40 or Brakleen or soemthing like that, and spary it where the intake manifols bolts to the block. If you hear a change in the idle speed (faster or slower) just change out the gasket.

Posted on Mar 31, 2009

  • 31 Answers

SOURCE: 1991 honda prelude speedometer not working,what is

your cable is either broken or can loose on your trans axle or behind your instrument cluster. Check those first. cost ????? not sure

Posted on Sep 21, 2009

SOURCE: how can you tell if a 1992 honda prelude si fuel

only way is to check the ripple waveform with a waveform scanner. your looking for a drop out of the 8 pulses indicting a potential problem. the pump may still work just fine with good pressure but a bad waveform indicates a pump that wearing out.

Posted on Sep 28, 2009

  • 11 Answers

SOURCE: freeze plugs

usually the freeze plugs are located on the engine block underneith the heads.

Posted on Mar 18, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Where is the fuel pump relay on a 1986 honda prelude 2.0 si

Not a single person answered your question, they all told you an answer that didn't relate to your question. Anyways the relays for your fuel pump are under your dash behind the fuse box.

Jul 25, 2012 | 1986 Honda Prelude

1 Answer

How can i adjust the clutch in a honda prelude si 1991

i would ck oil as break fluid in clutch cyl then bleed the have no other problems.good luck.

Feb 20, 2012 | 1991 Honda Prelude

1 Answer

Freeze plugs

usually the freeze plugs are located on the engine block underneith the heads.

Mar 18, 2010 | 1991 Honda Prelude

2 Answers


Low retail valve $1950.00
Average clean and in good condition $3100.00
High retail valve $4375.00
Hope this was very helpful

Jan 20, 2010 | 1987 Honda Prelude

2 Answers

1991 honda prelude speedometer not working,what is

Probably the Vehicle Speed Sensor (VSS). Cheap and easy to change (see ebay), once found! Probably on top of gearbox, to rear.

Aug 06, 2009 | 1991 Honda Prelude

1 Answer

Replaced in/tank fuel pump.

I have had problems with my 89 prelude. I found that the problem wasn't with the fuel pump, rather the master relay. You will have voltage at the fuel pump with the fuel pump dicconnected, but when you connect the pump and put a electrical load on the circuit, the voltage drops. check current with the pump running and see if this is the case.

Jan 26, 2009 | 1990 Honda Prelude

2 Answers

Spark plug gaping

Go to your nearest Autozone or other parts house and buy an inexpensive plug gapper. I gap the Honda plugs at .045 .

Jun 16, 2008 | 1991 Honda Prelude

Not finding what you are looking for?
1991 Honda Prelude Logo

Related Topics:

292 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts


Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7726 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides