Question about 1996 Chevrolet Monte Carlo

Open Question

I need a diagram of coil packs for a 96 monte carlo 3100

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

turbohead
  • 21 Answers

SOURCE: i need a window wiring diagram for 1984 monte carlo

you can look on ebay and find the service manual and that could help you or you can try a google search for it but that is difficult to find specific diagrams like that on google or internet search but it isnt impossible

Posted on Jul 31, 2008

  • 840 Answers

SOURCE: need serpintine belt diagram for

Call chevy parts department with vin # and they can give the schematics of the belt but their should be a label inside of the hood or radiator support showing you where it needs to go. Please rate my response than you very much

Posted on Jan 28, 2009

  • 1 Answer

SOURCE: need diagram for serpentine belt on a 2003 monte carlo

http://gsi.xw.gm.com/image_en_us/gif/000/000/043/43400.gif

Posted on Feb 03, 2009

motor1258
  • 6674 Answers

SOURCE: vacuum line diagram 98 chev monte

No sticker on underside of hood or on rad support showing that?

Posted on Mar 07, 2009

rcampsr
  • 90 Answers

SOURCE: NEED DIAGRAM FOR POWER STEERING SYSTEM

There is usually no diagram for the power steering on a vehicle. On power steering you have a pressure line and a low pressure return line. The pump is located on the front of the engine and has a line that is bolted into it, this is the pressure line coming out going to the steering gearbox where it is bolted in also. The other line has a clamp holding it in place, this is the low pressure return line coming back from the gearbox. If the gearbox is the rack and pinion steering type then you may have a couple of extra high pressure lines on it to operate the rack portion of the steering. Good Luck, RAC

Posted on Apr 18, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I have a 96 monte Carlo 3100 I was wondering what year motors interchanged with that like what years do the range in that go


96 to 99. 3.1 and 3.4 engines work. You can go higher on years, but will have to change brackets and sensors. Up to 03 I believe. Main thing you need to watch for is the crank sensor.

May 23, 2015 | 1996 Chevrolet Monte Carlo

1 Answer

HOW TO REMOVE 4T60E TRANSMISSION FROM A 96 Z34 MONTE CARLO?


You don't have to pull it to replace the TCC. Remove the pan and you can access the TCC solenoid. 40b12bb6-08f8-4f1c-b959-9bfe6f7b08fb.gif

Aug 06, 2014 | 1996 Chevrolet Monte Carlo

1 Answer

2003 monte carlo 3.4 130,000 skips on start up


I'd suspect a sticking injector--car should have set the check engine light. Read the code(s) to progress further. If the coil pack were a problem, it would not be likely to fix itself. If the codes indicate an injector problem, try an injector cleaner in the fuel--worst case, replace the bad injector. The codes should indicate which cylinder to change the injector.

Sep 09, 2012 | 2003 Chevrolet Monte Carlo

1 Answer

How to change coil pack in a 1998 monte carlo 3800 k had a tuneup did not change coil pack getting a misfire hesitation on acceleration the light flash when you accelerate


The coil pack is held on by 2 5.5mm bolts. Take the bolt's out and the coil just pulls up.
I take it the spark plug wires are good?

Feb 14, 2011 | 1998 Chevrolet Monte Carlo

2 Answers

My 96 monte carlo won't start i have a new battery and alternator in but when I turn the ignition it cranks but doesent start and I have gas in it


check fuel pump quick check spray starter fluid if starts no fuel reaching throttle body if no start or gas is present at throttle body check for spark from distributor to coil pack

Oct 07, 2009 | 1999 Chevrolet Monte Carlo

1 Answer

Timing for 96 Chevy Monte Carlo


put number 1 piston so its on top then adjust distributer rotor to that piston from there you can scink it by ear by turning the whole distributer you will be able to hear the diffrenceand smell it if you getting too lean or heavy your spark plugs will let you know also.

May 30, 2009 | 1996 Chevrolet Monte Carlo

1 Answer

96 monte carlo


I can surely help bet let me ask exactly what codes are you getting?if you have multiple codes maybe clear them and run it untill you start getting current codes,I have lots of info for you but get me the current codes Relax...we will get it fixed but keep in mind it wouldnt hurt to put a noid light on the injectors 1,3,5 because you may have a quad driver problem in the pcm.let me know have a good day DB

Feb 08, 2009 | 2001 Chevrolet Monte Carlo

Not finding what you are looking for?
1996 Chevrolet Monte Carlo Logo

Related Topics:

92 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...