Question about 1999 Oldsmobile Intrigue

1 Answer

I removed the starter on my 99 Olds Intrigue, 3.8. I can't remember what wires go where. Does anyone know?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 834 Answers

I have made a diagram to help assist you, and the starter will connect like this diagram indicates.


I removed the starter on my 99 Olds Intrigue, 3.8. - a494df4.jpg

Posted on Jul 15, 2010

Testimonial: "this answer was very helpful. Thank you."

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What will disable starter on 99 olds intrigue how to repair going crazy


Battery cables together ??
If the security light is on, the system has disabled the starter and the fuel injectors.
The problem would be a faulty chip in the key, the sensor in the lock cylinder, or the VATS module.
If the security light is not on, it could be the neutral safety switch.

Oct 08, 2012 | 1999 Oldsmobile Intrigue

1 Answer

I have 99 olds intrigue. I've changedthe MAL


may sound strange but it could be your catalyic converter- air/exhaust has no where to go

May 10, 2011 | 1999 Oldsmobile Intrigue

1 Answer

I need to change the starter


The starter on 3.5L engines is on the backside of the engine block slightly towards the drivers side.


I just changed the starter in my 2000, 3.5L, V6, Oldsmobile Intrigue. I am going from memory here but the sizes should get you fairly close. The starter is held on with 2 bolts. I used a 13mm (or maybe 11mm or 12mm) socket with a 12" extender to remove the bolts. There are 2 wires attached to the starter. I used an 8mm socket (but a deep socket, the kind of socket that is ~3" long) to remove the small wire. I used ~11mm socket (deep socket) to remove the large wire. Everything was metric. It was not an overly difficult repair. Wiggling the starter in and out of position was probably the hardest part. Remember to disconnect your battery before starting.

Mar 09, 2011 | 2000 Oldsmobile Intrigue

1 Answer

Wer can i find the crank sensors on a 99 olds intrigue 3.5 engine


The crank sensor is located below the front exhaust manifold and above the starter. To access it, you must lift the front of the vehicle, and remove the starter. Once the starter is removed the sensor is visible. Because of the poor location and poor GM engineering these sensors fail. You have excessive heat from the exhaust and oil leaking from the valve covers that short them out. Also once the sensor is replaced, it must undergo a re-learn process. Unfortunately this process can only be performed by a GM dealer via their computer system.....if you need further assistance, feel free to post them on FYa...hopefully this helps!!

May 05, 2010 | 1999 Oldsmobile Intrigue

2 Answers

99 olds intrigue with the 3.5 motor and ABS light staying on


What you will have to do is get the codes from the ABS module.This will let you know what sensor or wiring is bad.But you need the code to diagnose the problem.Yes it could be a hub but you need to know which hub bearing.It could also be wiring.Best to get codes.Hope this helps.A Good luck.

Mar 30, 2010 | 1999 Oldsmobile Intrigue

2 Answers

I ran out of gas in my 99 olds intrigue and noe I


your in tank fuel pump could have went out at the same time.

Dec 15, 2009 | 1999 Oldsmobile Intrigue

1 Answer

99 olds intrigue ignition switch problem


You have to replace the ignition system, all the 99's came with an anti theft unit built in. The ignition is built into the system, so that could be the reason why.

Jul 10, 2009 | 1999 Oldsmobile Intrigue

1 Answer

A/C BLOWER


Older cars sometimes have many difficult problems, especially the wires problem, it is very hard to find out which wire got trouble, I think your Olds wire got hot sometimes before and some wires connected together and by pass.

Olds is GMC products, the plastic sucks easy to melt, sometimes also cause the engine over heat, because the cooling fan doesn’t work right.

Good luck, my friend.

Frank

Jul 02, 2008 | 1999 Oldsmobile Intrigue

Not finding what you are looking for?
1999 Oldsmobile Intrigue Logo

Related Topics:

469 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8826 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...