Question about 2000 Chrysler 300M

1 Answer

How do i put freon in my car ac - 2000 Chrysler 300M

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 407 Answers

The best way to answer your question would be to have you buy the can of refrigerant from your local Wal-Mart or auto parts store so you have the instructions in front of you while you do it. There will be two ports on your air conditioning lines in the hood compartment, the bigger of the two is the side you service, it's usually closest to you for easier access. The can of refrigerant you buy needs to have the hose and the small gauge that you can either buy separate or together. You will need someone to help you as you will need to be in the vehicle and under the hood at the same time to do this correctly. I don't mean to just put you out or anything, but the instructions will explain in more depth and you will need the supplies anyways. Hope this helps!

Posted on Jul 15, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

Ac recharge

Connect freon cylinder with compressor suction side And slowly refill refrigerant.

Aug 07, 2016 | 2007 Honda Civic 1.8

1 Answer

03 Ram 3500 ac blowing warm put freon in now if I don't turn my truck off after putting it in AC works but if I turn it off within a few hours all of the freon has leaked out!!

If you have a major leak in your AC system, you can try a can of "leak repair" with your next try at recharging the freon, or you can take your truck to an AC repair and have it fixed.
Leaks can happen in hose connections, seals, etc.

Jun 10, 2015 | Dodge Ram 3500 Cars & Trucks

1 Answer

97 Plymouth Breeze won't blow cold air due to freon leak.

Your AC system is a closed system, so the fact you have to put more Freon in, means there is definitely a leak. I would check it out with a mechanic.

Apr 26, 2015 | Plymouth Cars & Trucks

1 Answer

Why does my mazda mpv stall when ac is on but it runs fine when the ac is dissconnected

Make sure that your drive belt and ac belts are tight. A loose belt will look like many problems. Also could be your ac compressor. They have ac compressor lubrication in a can just like the freon. You can notice the extra strain the ac puts on the engine when you turn it on and especially at idle. So 1. Make sure belts are tight and in good condition, if not replace. 2. Check freon level in ac. If freon level is okay add ac oil conditioner.

Jul 19, 2014 | 2003 Mazda MPV

1 Answer

Why wont' my a/c system blow cold air after adding freon?

Hmmmmmm, There is a lot more to AC systems sometimes.

Is the clutch on the AC compressor turning when you have the AC on? How much pressure is currently in the system? Does it have AC in the back of the vehicle?

Jul 02, 2014 | 1996 GMC Jimmy

1 Answer


check for large diameter hose, cap maybe marked with L for low pressure side, this is where refrig. must be added, follow instructions on can that comes with hose attached

Jul 15, 2012 | 1995 Lincoln Town Car

1 Answer

When putting freon in with car running freon does not go in

Your ac is controlled by the computer and once it recognizes that you are low on freon it shuts the compressor down.. You will first have to start putting a can of freon into the system without the car running . With your gauges still hooked up disconnect the the battery and reconnect it after ten seconds or more. This will reset your computer. Start your car and then turn on the ac. The compressor should come on and you should be able to continue charging your ac.

Jun 20, 2010 | 1999 Cadillac DeVille

1 Answer

AC has freon (134a) pressure is good. Compressor

Have a code reader or scanner put on the car to erase all codes,this should reset the ac system circuit.Also check the low side clutch cycle switch,it may be the problem.

May 01, 2010 | 2007 Suzuki Forenza Sedan

1 Answer

My ac blow out hot air and i want to put freon in my self and want to know how

Adding freon will not correct the problem. If you need to add freon, you have a leak, and you have moisture in the system, the leak should be located, mositure removed, then freon added. But to answer your question. Open the hood on, the left side you will see a round object called a dryer, you will see two pipes coming from it, one at the top and one at the bottom. The smaller is the high side, the larger is the low side. Obtain a can of freon either R-22 or 134a with an adapter for installing the freon. Turn the engine on, turn the AC to high. Add the freon to the ac using the low side.

Jun 30, 2009 | 1999 Saturn SL

Not finding what you are looking for?
2000 Chrysler 300M Logo

334 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts


Level 3 Expert

79186 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides