Question about Cars & Trucks

Open Question

95 toyota levin with 4age engine stops after engine warms up and wont start till cooled. Computer code 14 ignition igniter could this be the problem or is it the coolant sensor?

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 98 Answers

SOURCE: How to remove ignition cylinder from Toyota Camry 1993

Here are step-by-step instructions for the removal and re-installation of your ignition cylinder on your Toyota. Hope this sheds some light on the subject and solves your problem. Have a great day!




  1. Disconnect the negative battery cable. If equipped with an air bag, wait at least 90 seconds before working on the vehicle.
CAUTIONSome models covered by this guidemay be equipped with a Supplemental Restraint System (SRS), which uses an air bag. Whenever working near any of the SRS components, such as the impact sensors, the air bag module, steering column and instrument panel, disable the SRS, as described in .
  1. Remove the lower steering column cover. Unfasten the ignition switch connector under the instrument panel.
  2. Remove the screws which secure the upper and lower halves of the steering column cover.
  3. Turn the lock cylinder to the ACC position with the ignition key.
  4. Push the lock cylinder stop in with a small, round object (cotter pin, punch, etc.).
On some vehicles, it may be necessary to remove the steering wheel and combination switch first.
  1. Withdraw the lock cylinder from the lock housing while depressing the stop tab.
  2. To remove the ignition switch, unfasten its securing screws and withdraw the switch from the lock housing.
To install:
  1. Align the locking cam with the hole in the ignition switch and insert the switch into the lock housing.
  2. Secure the switch with its screw(s).
  3. Make sure both the lock cylinder and column lock are in the ACC position. Slide the cylinder into the lock housing until the stop tab engages the hole in the lock.
  4. Install the steering column covers.
  5. Connect the ignition switch wiring.
  6. Connect the negative battery cable.

Posted on Nov 23, 2008

Ad
deathraider
  • 64 Answers

SOURCE: 95 toyota 4runner no spark

if you dont have any fire than check the crank position sensor

Posted on Dec 01, 2008

  • 1 Answer

SOURCE: 95 Jeep Wrangler wont start

Well two things are happening here... the people saying fuel regulator, you guys are not having the same problem. the relay buzzing is the indicator that the computer is bad. The relays that are buzzing get engergized by the computer. Notice the Check Engine Light won;t come on until after the buzzing is over. Now the fuel problem is different from that becuse the computer is working fine but the pump can't build enough pressure in the first second (like it is suppose to do) during the priming before you turn the key to start. Sorry for all you with the computer problem ain't cheap...

Posted on May 01, 2009

  • 55 Answers

SOURCE: my 95 Ford Escort wont start, changed ignition

I would listen for the fuel pump(take the gas cap off and listen for the buzz when someone turns the key on), if no buzz or whine then have them crank the engine.If still no noise then take a hammer and hit the middle of the gas tank while the car is being started(make sure E-brake is applied)If it starts it's your fuel pump.

Posted on Jul 18, 2009

Molson02536
  • 3854 Answers

SOURCE: i have a 95 camaro that wont start crank sensor,

Check your fuel pressure at the shredder valve. If you don't have a fuel pressure gauge, you can get a loner tool at Auto Zone and get the proper fuel pressure readings you need for you car. I don't know which engine you have and the different engine's have different readings. Good luck and hope this helps on check the fuses, it could be a simple as that.

Posted on Nov 02, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Toyota Camry 1990 V6 2.5L obd1 codes 11 and 14 Check Engine Light on. Codes 11 and 14. Hooked up a good pulled hopefully ECU and check engine light came on again after driving 1/5 of a mile.


code 14 - ignition signal. No IGF signal to ECU 4-5 times in succession.. need check: • Ignition circuit (+B, IGT, IGF) • Igniter • ECU

Jan 03, 2017 | 1990 Toyota Camry

1 Answer

Toyota corolla 1997 engine code p1300 ignitor circuit malfunction #1 car starts after 2 minutes will stop


Error Code P1300/ 14. Igniter signal malfunction No.1
Problem Areas:
IGNITION SIGNAL--NO "IGF" SIGNAL TO ECU
--IGNITER/IGNITER CIRCUIT
--IGNITER AND IGNITION COIL/CIRCUIT
--IGNITION AMPLIFIER/ DISTRIBUTOR.
--ECU

Oct 18, 2013 | Toyota Corolla Cars & Trucks

2 Answers

When my 92 chev van Lumina gets warm it stalls and won't start till It cools down. What could the problem be.


You'll need to get more information. Find an auto parts store that offers free engine code readouts and have them tell you what the engine computer has detected. This will shorten the long list of possible causes. Post again with the results - you may get to post your own solution.
I've had a bad fuel injector driver transistor in the computer (throttle body injection) and an ignition module do this to me.

Oct 03, 2012 | 1992 Chevrolet Lumina APV

1 Answer

What is needed to fix fault codes 14 and 24 for a 1994 toyota corolla


The following is from a Haynes manual for 1993-1996 toyota corolla and geo prism:

Code 14: ignition signal. No ignition signal to the ECM. Check igniter or circuit, ignition coil, ig. switch or circuit, ECM (engine control module or "computer")

Code 24: intake air temperature sensor. Open or short in the intake air temperature sensor circuit. Check intake air temp. sensor or wiring to ECM.

Jan 27, 2011 | 1994 Toyota Corolla

1 Answer

95 toyota levin starts than stops immediately


CAR START DONT KEEP RUNNING.SYSTEM TOO LEAN NOT GETTING ENOUGH GAS.I WOULD HAVE FUEL FILTER CHANGED.CHANGE PLUGS AND WIRES.YOU COULD HAVE VACUUM LEAK AT INTAKE MANIFOLD OR VACUUM LEAKS FROM HOSES AND HAVE IDLE SPEED CHECKED.IF TOO LOW ENGINE CANT IDLE IT WILL SHUT OFF.

Jun 14, 2010 | 1998 Toyota Camry

1 Answer

I have a 1994 Toyota 4Runner with a V6 and the check engine light came on i jumped the terminals and code 14 and 26 came up. what does the codes mean?


These are the codes and possible causes taken from http://www.off-road.com/toyota/tech/codes/
Code 14 :
IGNITION SIGNAL--NO "IGF" SIGNAL TO ECU
--IGNITER/IGNITER CIRCUIT
--IGNITER AND IGNITION COIL/CIRCUIT
--ECU

Code 26 :
AIR/FUEL RATIO RICH INDICATOR
--INJECTOR FAULT(S)
--FUEL PRESSURE
--OXYGEN SENSOR
--AIRFLOW METER OR MAP SENSOR
--IGNITION
--ECU
--COLD START INJECTOR

Sep 17, 2009 | 1994 Toyota 4Runner

2 Answers

4 cyl Engine starts and idles ok...give it throttle and it dies


I need to get a clear mental picture of what exactly is happening.

With this said, you stated that the car "runs fine" until warmed up.

Q: When you start the car when cold it idles fine?
Q: If you allow the car to idle until "fully" warmed does the car stall?
Q: As the car begins to warm up, Does the RPM fluctuate abnormally?
Q: Does the car Only stall when you press on the gas pedal or does it stall just sitting and idling in addition to pressing the gas pedal?
Q: If you can drive it while cold does the car stall during acceleration when warm or only at Stop Signs / Lights?
Q: If you wait 20min or so, can you start the car again?
Q: How many miles are on the car?

Mar 27, 2009 | 1995 Toyota Camry

1 Answer

95 susuki sidekick wont start when it gets warmed up


have known ignition systems to do that. as temp. increases resistance will change

Nov 02, 2008 | 1995 Suzuki Sidekick

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

81 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...