Nissan quest p0325 - 1998 Nissan Quest

that is the knock sensor,and on your motor it is located between the 2 cylinder heads under the intake manifold. I have seen my share of bad ones

Hello

Knock Sensor is located under the intake manifold.

CAMSHAFT SENSOR BUILT IN THE DISTRIBUTOR.

On the Nissan that code means you have a short in the knock sensor circuit or you just need a new knock sensor.

first the quest, this is common for nissan, replace the knock sensor, this sensor is located under the intake manifold rear of engine, some models you can sneak sensor out without removing the intake, this will take care of that car. now the camry, im guessing this is a 4 cylinder engine, replace the air fuel sensor (oxygen sensor) thats on the exhaust manifold. this will solve that problem. hope this helped.

P0325 is for the knock sensor.

P1105 is for the manifold absolute pressure sensor (MAP).

In either case diagnostic tests need to be performed to rule out faulty sensors or if something else is causing the sensors to give the computer inaccurate information.

2001 nissan quest with new tps but still has P0120,P0325,P1705 codes

the knock sensor is located near the bottom of the engine block, it is screwed into the blocks water jacket, so make sure u drain the radiator before u change it, also it must be torqued to a specific value or it will not function correctly.

sounds like it , the sensor should be on the exhaust somewhere,whith wires on it