Question about 1996 Chevrolet Blazer

1 Answer

Engine will not start or turn over their is power to the gauges

Posted by on

  • volcompunker Jul 13, 2010

    check the battery with a voltmeter. does you lights dim when you turn the key. do you get any clicking sound?

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 102 Answers

First check your starter. If it is good make sure the wires leading to the starter are tight and not broken anywheres. If all of this is good check the ignition relay and possibly the under column switch. It really sounds like a starter issue though.

Posted on Jul 21, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

'92 Saturn Sl twin cam. Starter cranks fine but engine won't start and when you turn the key on no power to the gauges, but it cranks the engine


Spark , compression , fuel ? Which of these are missing ? Spray carb. cleaner or starting fluid into the engine , does it try to start ? Pull two plug wires at the same coil , crank engine , is there spark ? No power to gauges hasn't anything to do with no start .

Oct 30, 2016 | Saturn Cars & Trucks

2 Answers

I have a 2008 Saturn Vue, all dashboard lights work, seatbelt alarm they all work except the fuel gauge doesn't work and the engine will not turn over. It isn't the battery and has new starter.


If it is a new starter and it is not turning over the engine it has to be because it is not receiving power. Check battery connections and start solenoid and any fuses/relays in the mix.

Feb 07, 2016 | Saturn Cars & Trucks

3 Answers

Jeep will crank but no start what can my problem be


well you need to find out if it is spark or fuel giving you the problem check for spark first they have problems with the crankshaft position sensor which could be the problem not easy to get to its bolted to the bell housing with 2 bolts if you do not have spark that would be a good place to start

May 20, 2014 | Jeep Grand Cherokee Cars & Trucks

1 Answer

My Jeep won't start. I replaced the battery but the car will not start. The gauges all go crazy and I hear a ticking noise, but it seem there is no power getting to the engine.


Does the engine turn over at least? The gauges getting crazy points to a PCI data bus problem, then also the engine will crank, but not start. Could be one of the components connected to the bus. Also common is water ingress in a large connector on passenger side bulkhead, which causes the data bus to short out..

Oct 28, 2013 | 2004 Jeep Grand Cherokee

1 Answer

2001 chev monte carlo dash gauges are not recording any readings


does your car turn over or start? check for lose ground/power

Sep 13, 2012 | Chevrolet Monte Carlo Cars & Trucks

1 Answer

Why did my pntiac vibe lose power while i was driving the radio turn off the gauges stop working and the engine lost power


The battery may only be 3 1/2 years old, but the factory
batteries seem to fail early in life

Check to see if has at least 12.5 volts across the terminals

I think you lost the battery & then the computer module went down,
as you turned into the driveway

If you only have 12.2 volts, don't try and charge it,replace it

If it does start ,check voltage again with engine running
The alternator has to output over 14 volts to charge a 12 volt
battery.

Jun 08, 2012 | 2009 Pontiac Vibe

2 Answers

Had to replace fuel pump in 1994 cadillac fleetwood still want start cant get power to the pump grey wire but power going to fuel gauges


replace the oil sending pressure sensor on the engine which provides the priming of the fuel pump uopn first starting the engine

Apr 30, 2011 | 1994 Cadillac Fleetwood

1 Answer

1978 dodge fuel and oil pressure gauges are


Check the wires to the senders for grounding Those gauges have a power lead to gauge then to sender. The more the sending unit "grounds" the higher the gauge reading

Jun 01, 2010 | 1983 Dodge Pickup

1 Answer

Iginition system does not get power


did you check all the fusable links sometimes they dont break all the way maybee check all the grounds on the truck there is one on the back of the head and should be a comp. ground and of course the engine ground from bat. sometimes you have to losen them and retighten to establish a new clean ground

Aug 15, 2009 | 1995 GMC Sierra

2 Answers

Engine Starts but No Gauges or Radio


Sounds like the electrical ignition switch is going bad about an $18 part from parts store

Sep 08, 2008 | 2002 Chevrolet Cavalier Coupe

Not finding what you are looking for?
1996 Chevrolet Blazer Logo

Related Topics:

43 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8202 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...