Question about 1997 Toyota RAV4

1 Answer

Where is the water pump

Where is the water pump on my rav 4 2liter rav 4 2002

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Toyota Master
  • 6,826 Answers

Water Pump REMOVAL & INSTALLATION 5VZ-FE Engines Fig. 1: The water pump is located on the front of the engine block, behind the timing cover where  is the water pump - 93163p92.jpg
Fig. 2: Once the retainers are removed, pull the pump away from the block 93163p97.jpg
Fig. 3: Scrape any remaining gasket material from the block before installing the new pump 93163p98.jpg
Fig. 4: Water pump mountingwhere is the water pump - 93163p88.jpgons 93163p88.jpg
Fig. 5: Front viewhere is the water pump - 93163p99.jpger pump and thermostat housing 93163p99.jpg
WARNING
This procedure requires the removal of the timing belt. This is an extensive procedure requiring precision work, particularly at assembly. For more information, refer to Timing Belt Removal and Installation. Do not attempt to remove the belt without consulting the procedure; extreme engine damage may occur. Fig. 6: Apply sealant to the areas shown 86823pi7.gif
Fig. 7: A anwhere is the water pump - 86823pi8.gifations 86823pi8.gif
Fig. 8: Exploded view of thewhere is the water pump - 93163g19.gifarrangement — 5VZ-FE engine 93163g19.gif

  1. Drain the cooling system.
  2. Remove the timing belt. For additional information, please refer to the following topic(s): Timing Belt Removal and Installation.
  3. Remove the idler pulley.
  4. Remove the thermostat.
  5. Disconnect the oil cooler hose from the pump.
  6. Remove the seven bolts and the tension spring bracket and then remove the water pump. To install:
  7. Clean all parts well. It is good practice to carefully clean all threaded openings, especially those exposed to coolant to remove rust and scale so at assembly, an accurate torque reading is obtained. This is important since gasketless applications like this depend on even clamp loads from the fasteners to avoid distortion and leaks. Remove any old sealer (Toyota calls it packing) from the pump and mounting area of the engine. Keep oil off the mating areas.
  8. Apply Formed In Place Gasket (FIPG) sealer to the pump-to-block mating surface and then tighten the bolts marked A in the illustration to 13 ft. lbs. (18 Nm). Tighten those marked B to 14 ft. lbs. (20 Nm). NOTE: The parts must be installed within 5 minutes of application of the sealant. Otherwise you must remove and reapply the sealer.
  9. Connect the oil cooler hose.
  10. Install the thermostat with a new gasket.
  11. Install the idler pulley.
  12. Install the timing belt.
  13. Install the drive belts and adjust the tension.
  14. Refill the cooling system and check for leaks.
2RZ-FE and 3RZ-FE Engines
  1. Disconnect the negative battery cable.
  2. Drain the cooling system.
  3. If equipped with an air conditioning compressor or power steering pump drive belts, it may be necessary to loosen the adjusting bolt, remove the drive belt(s) and move the component(s) out of the way.
  4. Remove the fluid coupling with the fan and water pump pulley.
  5. Remove the water pump. To install:
  6. Clean the gasket mounting surfaces.
  7. Install the replacement water pump using a new gasket.
  8. Install the water pump pulley and fluid coupling with the fan.
  9. Install the removed engine drive belts.
  10. Fill the cooling system.
  11. Connect the negative battery cable. Start the engine and check for leaks.
  12. Bleed the cooling system.
1FZ-FE Engine where is the water pump - 86823pk0.gifxploded view of the water pump mounting on the 1FZ-FE engine 86823pk0.gif86823pk3.gif
where is the water pump - next.gif"http://arrc.epnet.com/autoapp/9316/9316ch03_Engine_Cooling_Fan.htm">prev.gif next.gif

Posted on Jul 13, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2002 rav 4, will only start with starter fluid, replaced battery and fuel pump does run, what else could be the problem


Key on engine off, did you use a gage and check proper fuel pressure? I've seen fuel pumps that would run, but, wouldn't make good pressure.
When you use the starter fluid are you saying it will run fine the rest of the day, or it will just run till the starter fluid is used up?
You can also check for fuel injector pulse, engine cranking.

Nov 05, 2016 | Cars & Trucks

1 Answer

What causes Toyota Rav 4 2002 have one catalytic converter overheat? Replaced the entire assembly and new sensors. when started in a couple of mins was doing the same thing as old converter running on...


You converter is not the reason for misfire,Bad spark or leaking injector will release row fuel in converter and after burn and glow red hot. remove all spark plugs an look for one is black. or wet . replase plugs with DENSO or NGK inspect the wire for burn blue marks on the side or replace the injector if fluted cylinder.
Good luck

Mar 01, 2015 | 2002 Toyota RAV4

1 Answer

2002 Toyota rav 4 no power steering Changed Pump and rack


Did you put fluid back to the proper level? Is it a rebuilt unit that may be no good?

Oct 13, 2014 | Toyota RAV4 Cars & Trucks

3 Answers

My rav 4 2002 d4 engine does not idle, what could


mon rav 4 2002 moteur D4 ne tourne pas au ralenti, ce qui pourrait

Jul 02, 2011 | 2002 Toyota RAV4

1 Answer

1996 rav 4 toyota only puts out lukewarm air at defroster


Sounds like it needs new thermostat, sounds like yours is partially open not allowing water/coolant to heat properly.

Jan 02, 2011 | 2002 Toyota RAV4

1 Answer

Is the water pump on a 2007 rav 4 internal or external


Its internal.

Here's a How To: http://www.ehow.com/how_4914451_replace-water-pump-rav.html

Jul 27, 2010 | 2007 Toyota RAV4

1 Answer

Toyota rav 4L best spark plugs for good perfomance and estimated retail price


ngk v power copper at around $2.49
part number - 2756
happy holidays

Dec 29, 2009 | 2002 Toyota RAV4

2 Answers

97 toyota rav 4 dies at accel.


most likely its your fuel pump. when the rpm's start to drop just give the gas pedal a few pumps and you should be good.

Nov 17, 2008 | 1997 Toyota RAV4

1 Answer

Water pump


It took approximately 45 minutes to remove the alternator, the belt and the water pump. it then took another 45 minutes to put everything back in place. it was extremly easy!

Nov 11, 2008 | 1997 Toyota RAV4

Not finding what you are looking for?
1997 Toyota RAV4 Logo

425 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...