Question about 1995 Chevrolet Camaro

2 Answers

Car is idle really high, when you start the engine its like you have you foot on the gas.

Posted by on

Ad

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 10,319 Answers

Replace the idle speed contril (ISC)

Posted on Jul 13, 2010

Ad
  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

You may have the senser un hooked because i just replaced the heat senser and had to unhook it and it doing the same thang

Posted on Nov 20, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Car won't stay running, starts up and then just dies off like it never had a Chance of staying idle.


Hi Johnny, Im AL the owner of Big As Auto Repair.

Johnny, here's something I want you to try. I want you to start the engine while giving it a little gas, not much, just enough to see if it will idle. If it does Idle and stays running with your foot on the gas and dies when you remove your foot. Then go and buy an 'IDLE AIR CONTROL MOTOR" It mounts on the throttle body. Put that on, there are only two screws that holds it on, very easy to replace. After installing it the idle will be real high, this is normal, just wait it will stabilize and idle normal. NOTE: if it still dies even with your foot on the gas, then you have another issue but this is a good place to start. Hope this helps and please visit my auto-repair-website at: http://www.bigasautorepair.com/

Nov 28, 2015 | Cars & Trucks

1 Answer

1996 Jeep cold start heater location


It likely has EFI (electronic fuel injection) and an idle air control valve that regulate idle speed. They can get gummed and fail to have a fast idle when cold, or get stuck the other way, and have a too fast idle all the or regularly take its time slowing down after you take your foot off the gas. An engine temp sensor can also cause a lingering high idle if it reports the engine as still being cold after warm up.

Aug 15, 2014 | 1996 Jeep Grand Cherokee

1 Answer

Engine rev high by its self


The most common causes of this are a engine vacuum leak and a sticking idle speed control air bypass valve.

Jul 15, 2017 | Cars & Trucks

1 Answer

1999 toyota 4runner, 140K miles: for 2 weeks, have problem starting when cold in morning. takes 3-4 clicks and foot on gas pedal to start. now also problem starting when warm after driving for 30mins....


Sounds like a sticky throttle if you can't keep idle. It won't hurt to try.... you can try a quick cheap trick by spraying a little carbon remover (buy at any auto store i.e. autozone, oreiley's) inside the throttle, open the valve, spray just small amount, close it back up and rev it a few times and repeat. It removes the carbon film after long use. fixed my idle issue in my cars. If its really bad you might have to clean it thoroughly but i highly doubt you have to do that.

https://www.youtube.com/watch?v=41yFXjibtLY

Sep 08, 2017 | 1999 Toyota 4Runner

1 Answer

1997 Crown Vic. Will crank, but will not idle.Have to keep foot on gas.


have a 97 crown vic,
in warm weather it idles fine and run fine
now that its cold I have to hold at high idle to have warm up
for about 10 mins.
if I just start it the engine will die with out me holding on foot on the gas

Feb 18, 2011 | 1997 Ford Crown Victoria

1 Answer

REPLACED STARTER AND BATTERY,BUT ENGINE WONT STAY RUNNING WITH OUT FOOT ON GAS?


you may need to clean the throltte body, and then start the engine and hold the rpms high for a minute, then slowly reduce the gas pedal to idle, you blanked out the memory, now it needs to learn the idle speed again.

Dec 04, 2010 | 2000 Dodge Ram 1500 Truck

1 Answer

I have a 93 ford thunderbird...yesterday it started to idle really high. when i was at the stop sign the car wanted to jump and when I took foot off of brake it picked up speed without even touching the...


ks.. it could be the AICV or the TPS (throttle position sensor).. DO you have any dash lights/service engine lights/ etc.. on??.. Stop by a O'Reilly, Autozone, Advance auto.. they should help you..

Sep 07, 2017 | 1993 Ford Thunderbird

Not finding what you are looking for?
1995 Chevrolet Camaro Logo

Related Topics:

174 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...