Question about 1995 Nissan Pickup

1 Answer

1995 nissan pickup throttle position sensor

How do you check your throttle position sensor if its good or bad on a 1995 nissan pickup the ecu read that code.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 68 Answers

Ok on a 2.4l on the black/green and white wires use ohm meter and there is no specific spec for that engine just make sure the the resistance changes and there is no dead spots. for the 3.0l black and white wires specs are 1.0-9.0k ohms im guessing the specs are the same either engine. close to full open


Posted on Jul 13, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

When starting my 95 toyota pasao it is revving really high is the throttle stuck


Could be a number of things. Yes, check throttle opening, possibly the Throttle cable is damaged due to salt corrosion and holding it open. Or possibly lack of corrosion. Could also be bad Throttle position sensor or it's equivalent or corrosion on its connectors. If you can get it under control have the Ecu codes read by local auto parts store.

Jun 07, 2015 | 1995 Toyota Paseo

2 Answers

Stalling in idle...running rough....stalling when stopping


Undo your battery overnight so the computer will reset and see if that helps.if it does not you will probably have to take it to an auto parts store and see if they can reset it

Sep 20, 2017 | 1997 Nissan Pickup

1 Answer

When I come to a stop engine shuts off


is the vehicle easy to start and run down the road ok even at acceleration? if so i would check iac valve throttle position sensor, map sensor or o2

Oct 07, 2013 | 1995 Nissan Pickup

3 Answers

Error code p2138


Here is the definition. You may need to have someone check the accelerator pedal position sensor and the circuit.

P2138 NISSAN Description The Accelerator Pedal Position (APP) sensor is installed on the upper end of the accelerator pedal assembly. The sensor detects the accelerator position and sends a signal to the Engine Control Module (ECM).
Accelerator pedal position sensor has two sensors. These sensors are a kind of potentiometers which transform the accelerator pedal position into output voltage, and emit the voltage signal to the ECM.
In addition, these sensors detect the opening and closing speed of the accelerator pedal and feed the voltage signals to the ECM. The ECM judges the current opening angle of the accelerator pedal from these signals and controls the throttle control motor based on these signals.
Idle position of the accelerator pedal is determined by the ECM receiving the signal from the accelerator pedal position sensor. The ECM uses this signal for the engine operation
such as fuel cut.
Read more: http://engine-codes.com/p2138_nissan.html#ixzz26J3D2x8s

Sep 12, 2012 | 2010 Nissan Versa 1.8

1 Answer

95 nissan pick up what would cause the motor to miss when you give it gas


check the throttle position sensor voltage and map sensor voltage.

May 23, 2012 | 1995 Nissan Pickup

1 Answer

1994 v6 Nissan pickup dies at stop lights. won't idle.


Hello, first is it carburetor or fuel injected engine? When was the last time it was tuned up?
If carbureted engine then the carburetor will need to be rebuilt or replaced with a rebuilt carb.



If fuel injected engine. low fuel pressure, faulty fuel injectors, new air cleaner, throttle position sensor might need to be replaced, air flow sensor could be faulty, broken vacuum hoses, plug fuel filter, faulty fuel pump, new spark plugs, etc. All of these things need to be checked out.



You are probably not getting very good fuel mileage. Couple of things will be needed. rebuild carburetor, new filters, and a tune up. GB...stewbison

Sep 06, 2011 | 1995 Nissan Pickup

2 Answers

I'm getting 3 codes on my ECU 21-33-51 . I have replaced my ECU , replaced all injectors and oxygen heat sensor. The new ECU is showing the same codes.


Hi Kevin, The fault codes are in relation to faults that are recorded with the management system of the vehicle, and need not be the actual faults recorded. For example, the fault read out may display 'rich mixture.' That however does not mean that the injectors are leaking, but instead, the oxygen sensor may be giving and incorrect reading and is allowing too much fuel to be injected. Have a diagnosis carried out and then the diagnostic report must be interpreted by some one who knows what they are reading!Regards Johngee10

Jul 23, 2011 | 1995 Nissan Pickup

1 Answer

1995 toyota pickup, surging at around 2000 rpms


Is the check engine light on?

A major cause of surging is either air leaks between the air flow meter and the engine intake manifold, or a bad or mis-adjusted throttle position sensor.

Feb 24, 2009 | 1995 Toyota Pickup

1 Answer

I have an 1987 nissan hardbody with a throttle body. it starts fine but floods out after running a few minutes. could this be the trottle position sensor or the fuel pressure regulator?


Have the Mass Airflow Sensor checked (it's the black, plastic box the size of a business card on the driver's side of the throttle body). It is VERY common for them to give false readings to the ECU.

Jan 13, 2009 | Nissan Hardbody Cars & Trucks

3 Answers

Engine check light


where are you located"???

Nov 17, 2008 | 1995 Nissan Pickup

Not finding what you are looking for?
1995 Nissan Pickup Logo

Related Topics:

987 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...