Question about 1999 Jeep Grand Cherokee

1 Answer

Fuel injectors code p0207 came up i was told a wire was broken but i dont know witch is injector 7

Posted by on

  • jamiesumner7
    jamiesumner7 Feb 28, 2013

    pull the injecter wires one at a time with the car runing to find the dead hol

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 2,926 Answers

Looking at the engine, right side,last injector closest to the fire wall. This is number 7 cylinder/injector. The same side runs as follows; 1,3,5,7 and are the odd cylinders located on this side, and 2,4,6,8 are on the left side, #8 is closest to the firewall. In case you need to know, the firing order is ; 1,8,4,3,6,5,7,2. Hope this helps you.

Posted on Jul 13, 2010

  • Carl W. king Oct 14, 2011

    Thank You, Just Needed to know which side.

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2004 Sorento began with code P0305, cyl #5 misfire. Inspected and replaced plugs, wires, and coil pack on cyl #2. Repair shop told me cyl #5 injector bad so they replaced. Still has misfire.I suggeste


If you had code P0305, I don't know why they would have done anything to the #2 cylinder but if they have already replaced the plugs, wires and injector; here are a few more items to check:
1) Check connections from ECM. Look for any corrosions or bent/broken pins.
2) Check the fuel line pressure
3) Check the engine compression
4) And if the above are good, then you will probably have a defective ECM

Nov 28, 2014 | Cars & Trucks

1 Answer

2002 ram van with the code p0207


This may sound odd but I've seen the TPS on these vehicles
throw a 207 code,with no code for the TPS. Seen as much as 5
volts at idle ,still no code. Just my only thought since you already
did the right stuff.

Feb 20, 2013 | Cars & Trucks

1 Answer

This 1999 dodge 1500 5.9l will start and run fine till about 1500 RPM and then misfires and pings severely. [ CHRYSLER ] Record1 -> 1998~2003 -> PCM -> ECU Information Module of year: ...


Hello.. looks like you are getting good fuel delivery. Is the fuel curve mixture on the scanner in specs? How is the timing, the timing chains on these engines will stretch and throw the timing off causing a ping and missfire -- a weak valve spring is something to consider. Also, the PCM may be faulty. I hope this helps.

Sep 27, 2011 | 1999 Dodge Ram

1 Answer

2001 misfire on cylinder #2 changed spark plugs and wires was told that you have to change ecm


check for cylinder compression; mechanical failure
check for electrical impulse at fuel injector connection; corrosion or open lead
check for fuel injector operation; clogged injector or broken coil
check for spark at plug; ignition problem

Jun 16, 2011 | Toyota Camry Cars & Trucks

2 Answers

Po261, po267, po270, po273, po276 po279


P0261 Cylinder I Injector Circuit Low P0270 Cylinder 4 Injector Circuit Low P0273 Cylinder 5 Injector Circuit Low P0276 Cylinder 6 Injector Circuit Low P0279 Cylinder 7 Injector Circuit Low this will hold true for each code you listed SymptomsPossible sumptoms of OBD code P0279
- Engine Light ON (or Service Engine Soon Warning Light) - Engine Misfire - Engine Run Rough - Low MPG CausesPossible causes of OBD code P0279
- Fuel Injector #7 - Faulty or Corroded Fuel Injector #7 Connector - Plugged #7 Fuel Injector - Dirty #7 Fuel Injector Possible Solutions- Clean Fuel Injector #7 Connector - Clean Fuel Injector #7 - Replaced Fuel Injector

May 31, 2011 | Ford F-250 Super Duty Cars & Trucks

2 Answers

Have a 2001 ford f250 super duty need to know how to check fuel injectors......truck was running fine and then the enine ran real rough and when you push the gas pedal to the floor there is little...


The fuel injectors have a resistance of between 10 to 18 ohms.Test each injector. If any of the injector readings are higher or lower than they should be, you need to replace them.
For more troubleshooting:---

Put a long screwdriver directly on the injector while the car is running. Hold the handle up to your ear. You should be able to hear a rhythmic clicking sound. If you do, your injector is good. Hearing a clunk-clunk type noise means you have found your problem. Hearing silence or unusual clicking patterns means either the injector, wires or plunger may be bad or sticking. You will either have to clean or replace them.

---------- To know more about fuel injectors and troubleshooting.Please click on the link below:---

http://www.2carpros.com/articles/how-to-test-a-fuel-injector

-------------

Many a times you get black smoke from exhaust due to faulty injectors.Check fuel injectors. Leaking injectors create an overly rich air/fuel mixture and cause black smoke. Take the valve cover off and look at the exhaust part of the injector, when it is running. Each time the injector fires, you should see oil exhausting from it. If you see oil coming out, then the injector is good. When replacing a bad injector, take the glow plug out and crank the engine to get any oil out of the cylinder.----------------- This should help.Thank you.



Jan 25, 2011 | 2001 Ford F250 Super Duty Super Cab

1 Answer

Oo dodge durango is flashing codes p0201,p0207,p0300,p0301,p0307 what is this telling me that needs to be fixed


P0201?? Injector #1 Ctrl Circ /
P0207 Injector #7 Ctrl Circ /

P0300?? Multiple Cylinder Misfire
P0301?? Cylinder #1 Misfire
P0307?? Cylinder #7 Misfire
are the codes start with the basics inspect plugs wires cap rotor and if all checks out do a compression test

Dec 31, 2010 | 2000 Dodge Durango

1 Answer

My injector dont work and i need to know why


CHECK FUEL PUMP AND FUEL INJECTOR FUSE.IF FUSE IS GOOD.YOU NEED A NOID LIGHT TO CHECK TO SEE IF INJECTORS FIRING.YOU CAN BUY A NOID LIGHT AT ANY AUTO PARTS PLACES.WHAT YOU DO DISCONNECT FUEL INJECTOR CONNECTOR.HOOK NOID LIGHT TO CONNECTOR.CRANK ENGINE TO SEE IF NOID LIGHT BLINKS.IF YES INJECTORS FIRING.IF YOU GET STEADY LIGHT.PCM NOT WORKING NOT FIRING INJECTORS.IF YOU GET NO POWER OR LIGHT DONT WORK.YOU HAVE A WIRING PROBLEM.YOU NEED A HAYNES REPAIR MANUAL LOOK AT THE ELECTRICAL WIRE DIAGRAM.TO TRACE FAULTY WIRE.

Mar 21, 2010 | 1989 Chevrolet G10

2 Answers

Trouble code 212 on a 92 ford taurus 3.0l


Hello there
According to autozone this is what they tell me about this code
212
(M)
Ignition TACH signal was erratic (module/wiring) or SPOUT circuit fault - Ignition Systems

Nov 21, 2009 | 1992 Ford Taurus

1 Answer

Po 307 misfire on #7


just because injector test ok electricly that doesnt mean its working right if the tip is plugged instead of sprayying a fine ignitable mist of gas it just drips out if this happens the gas wont ignite and you get a wet plug. you can switch injectors from one cylinder to anther or you can just replace #7 let me know how you make out with this

May 28, 2009 | 2002 Cadillac Escalade

Not finding what you are looking for?
1999 Jeep Grand Cherokee Logo

340 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...