Question about 1999 Lexus RX 300
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Lexus's have a complicated system of electronics that control the function of the transmission.Under normal operating conditions the transmission is controlled by the ecu and by a secondary system called a drivetrain control module. usually when a fault occurs it sends a code to the ecu and the check engine light comes on.
If this light does not come on then typically the electronic modulator is at fault and needs to be replaced.
If the check engine light comes on when the vehicle is hot i need this code to guide u further for the repair.
If u want to attempt the repair , be wary. its messy and takes time to do to do it right.
Posted on Apr 25, 2009
Remove 3 - 4 screws on fender cover close to side marker light. Pull fender cover out a bit for you to use your other hand to reach side marker light. By twisting on one direction and here you go the light out. Replace new bulb and replace everything on reverse order.
Posted on Aug 18, 2009
SOURCE: I have 3 codes 1) P0500
The PO125 is an indication of an engine running too cold-as if the thermostat were stuck open.For some reason it often sets with the PO1135 even when the engine runs at normal temp.A scan tool will indicate exactly how hot the engine is,don't trust the dash gauge. The PO1135 is a heater circuit fault in the bank1 sensor1 air fuel ratio sensor or oxygen sensor. Bank 1 is the REAR bank on this car...that O2 sensor is not much fun.PO500 is a vehicle speed sensor fault-does the speedo work correctly?it is located in the transmission near the back of the case. once again the scan tool will read vehicle speed and can aid in further diagnosis.
Posted on Mar 30, 2010
Is your O/D off? There should be a light under your speedometer, if it says "O/D OFF" than your car wont go to fourth gear. You can turn the overdrive back on on the knob that changes gears, theres a little button on the side. Press it and you should be good.
Posted on Apr 01, 2010
SOURCE: 1999 lexus rx300 check engine
Your 306 code means you have a misfire on cylender 6. That may be the cause of the po 125. Inspecdt the coil, spark plug wire, and spark plug on cylender 6. With the age of the car I would replace all 3 items. If you want know how to test all 3 I can tell you process of elimination is the way to do it. Do you know how to find cylender 6
Posted on Oct 15, 2010
Tips for a great answer:
Jan 13, 2015 | 2000 Lexus ES 300
Jan 08, 2015 | Lexus RX 300 Cars & Trucks
Jan 07, 2015 | 1998 Lexus Gs 300
Jan 30, 2012 | Cars & Trucks
Aug 12, 2017 | Lexus SC 300 Cars & Trucks
May 04, 2009 | 1991 Lexus LS 400
Nov 20, 2008 | 2000 Lexus ES 300
305 people viewed this question
Usually answered in minutes!