Question about 2008 Dodge Avenger

3 Answers

How to remove the center console from my 2008 dodge avenger

Posted by Anonymous on

Ad

3 Answers

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 27 Answers

Remove the trim bezel (plastic chrome) by unsnapping.at six points.
Pull up on shift knob (friction fit), then pry up on shifter bezel (snap fit).
Pry up the liner of the CD bin (again, snap fit...be careful)
Remove 6 screws, two forward, six in the bottom of the console bin.
Disconnect two wiring harnesses.
Set the parking brake (handle up as far as possible).
Remove console.
Reverse procedure to reinstall.
BE CAREFUL unsnapping the plastic parts. Inspection will reveal that these cars won't last much more than about 10 years...they're ALL PLASTIC!

Posted on Mar 15, 2015

Ad
  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 14 Answers

Try Alldata online manual. OR - If your wanting to do this you probably can't shift out of Park? If your like me, a spring most likely come loose inside the shifter assembly. Pull up on the shinny PRND outer cover to remove, the rest of the covers unsnap (use small screwdriver), pull up on shifter knob (might need to wiggle a little), Look for the pink plastic thing on the left. It should have a spring that pulls back on it when you shift into reverse. If this is missing, unbolt the four nuts that hold the assembly to the floor, look for the old spring. If it's gone you can cut a new one to size and hook it back on. If yours is like mine, the small pink hook (****) is broke and you will need to drill a small hole in it to have something to clip the new spring to. By the way, I had to do all this with the assembly in the compartment as I was unable to remove it completly. Not enough room. I removed the coin tray in front of the shifter, ParkReverseNutralDrive thing, grey cover that surrounds the coin tray(just pull out and up (it snaps in), 4 mounting nuts, and the cable that attaches to the pink piece of plastic that Chrsler should have put a little more effort into designing. ARG! Good luck.

Posted on Jul 30, 2010

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 4,044 Answers

I recommend you get a Haynes Repair Manual on your vehicle for the directions on how to remove this properly.

Posted on Jul 12, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2008 dodge avenger stuck in park but cluster reads neutral


First thing to do is check and see if the brake lights work, the brake lights power the release solenoid so you can move the gear selector from part to the desired gear.

Jul 15, 2016 | 2008 Dodge Avenger

1 Answer

How do i reset my radio for my car early 2008 dodge avenger ext with a 2.7


I just remove my batterie without removing the wheel. Turn right to have acces and when all the bolt are off turn left and you will have enough room.

Oct 03, 2014 | 2008 Dodge Avenger

1 Answer

How to remove center console from 2008 dodge caliber


Hi Rich, hope you well today here's is the fix you need.


23 - Body/Interior/CONSOLE, Center/Removal REMOVAL [img id=LOPTableImg src="https://w05.dealerconnect.chrysler.com/service/mds2002/common/images/collapse.gif"> Click to display a list of Labor Operations associated with this procedure
248438.jpg 1. Pull back on parking brake (5) to the upright position. 2. Open console door and remove two screws (1) fastening console to rear floor bracket (3). 3. Carefully pry up until the retainers (1) disengage from the center console to front floor bracket (6). 4. Disconnect center console wire connector (2) to instrument panel connector. 5. Remove from vehicle.

Hope this help and have an awesome day Rich.

May 23, 2014 | 2008 Dodge Caliber

1 Answer

How do I change the battery in my 2008 Dodge Avenger?


remove the wires from both of the terminals then there should be a bracket holding the battery assembly in with a bolt remove that and the battery should come right out.

Feb 04, 2011 | 2008 Dodge Avenger

2 Answers

Where is the battery located on my 2008 Dodge Avenger..?


To access the battery, turn the wheel fully to the right and remove the left front inner fender shield. The information is on page 379 of the owners manual

Nov 16, 2010 | 2008 Dodge Avenger

3 Answers

I have bought gear shift for 2008 avenger can you


You have to remove the whole center console which is the hard part then everthing else is pretty straight forward.

  1. Remove console bezel.See: Center Console Bezel - Removal.
  2. Remove shift knob and shift bezel See: Console Shifter Bezel - Removal.
  3. Remove two screws (8) in the front of the console.
  4. Remove four screws (5) inside the console compartment.
  5. Disconnect console housing wire connector (5) and instrument panel connector (1).
  6. Pull parking brake (3) rearward.
  7. Remove center console (7) from vehicle

May 06, 2010 | 2008 Dodge Avenger

2 Answers

I HAVE A O8 DODGE AVENGER AND IT WILL NT SHIFT OUT OF PARK WHAT COULD BE THE PROBLEM


neutral safety switch, remove center console and bypass to get going, you will need to replace it, common problem with these.

Mar 07, 2010 | 2008 Dodge Avenger

2 Answers

How do I remove and replace the stock radio in a 2008 Dodge Avenger?


I could type this all out but i found this link for you. Not from this site but is very detailed.

http://dodgeforum.com/forum/2008-dodge-avenger/127430-radio-console-removal-instructions.html

Feb 03, 2010 | 2008 Dodge Avenger

2 Answers

Where is the battery in a 2008 dodge avenger


It is in the drivers side fender well in front of the tire, it is mounted to the front frame rail. You have to remove the plastic fender lining to get to it.

Dec 13, 2009 | 2008 Dodge Avenger

1 Answer

Replace Bulbs in Headlight. 2008 Dodge Avenger


there is 2 bolts on top 1 top outer and 1 top front behind grill, u need to remove the top center black cover and 1 bottom side outer need to remove the inner finder liner to get to the 3rd bolt.
hope that helps, it is stupid

Mar 09, 2009 | 2008 Dodge Avenger

Not finding what you are looking for?
Cars & Trucks Logo

792 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...