Question about Cars & Trucks

1 Answer

My windshield wipers are stuck on how do i get them to turn off?

Posted by Anonymous on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 3,092 Answers

Don't know what kind of car or truck this is, if it's a chevy truck, replace the circuit broad on the wiper motor, if it's not I don't know, without knowing what kind it is.

Posted on Jul 12, 2010

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
emissionwiz
  • 77202 Answers

SOURCE: Windshield Wiper motor replaced, now wipers go wrong direction

This sounds like the park circuit is shorted.

Posted on Nov 25, 2008

motor1258
  • 6674 Answers

SOURCE: windshield wiper

Is there a little cap covering where it attaches to pivot at base of windshield. If so, pry/flip it up, forward from bottom or end, & you'll probably see a nut to tighten underneath it. Do it when wipers off & in parked position so you can move the arm where you remember it goes, then tighten. Don't reef too ******* it, they aren't that strong and will snap if you go too far with wrench, just real snug. Unless you've stripped spline real good, this should do it.

Posted on Dec 22, 2008

  • 85 Answers

SOURCE: windshield wipers won't work right

The windsheild wiper relay might be stuck or broken. Try tapping it with something or replace it. Could also be the the switch (lever that you control the wipers with) i hope this helps and good luck with diagnosing your problem.

Posted on Feb 21, 2009

  • 260 Answers

SOURCE: back windshield wiper stuck

Did you check the relay?
The Fuse?
After that it could be the motor.

Posted on Apr 14, 2009

Tech jk
  • 102 Answers

SOURCE: windshield wipers stuck upright when off

This is a commoon problem with what is called the "Park pawl stop". The tab is most likely bent and needs to be re-aligned, then the wipers need to be re-timed. This re-timing can be a little difficult, although the re-aligning of the tab is failry simple.

TechJK

Posted on Apr 18, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i find the right fuse that is connected to windshield wipers 2001 isuzu rodeo?


If they try to move the fuse is not the issue, You need to check the linkages, they are under the panel where the wiper spindles sit, the plastic ends can break and stop them working.

Mar 12, 2012 | 2001 Isuzu Rodeo

1 Answer

My 2003 Sante Fe drivers side windshield wiper is not working. Passenger side is OK


Remove the wiper arm by taking the nut off the end of the post coming through the base of the wiper. turn on the wipers and if the little post is turning back and forth with the other wiper, then you need a new wiper arm. the little serrations on the inside of the arm's base get stripped, usually from turning the wipers on when they are stuck to the windshield by ice. if the little post is not turning then you need a new wiper transmission. you will need a repair manual for that.

Dec 13, 2010 | 2003 Hyundai Santa Fe

1 Answer

06 cts when you turn wipers on windshield washer pump runs continually if you turn the wipers off the water shuts off. I have replaced the (D01 D6377D -) Windshield Wiper & Windshield Washer...


-I believe the switch is bad. The line to the pump might stuck at the wipe position. So every time it on. It turn both
devices on.
Check it out.

Good luck


Mai

Dec 21, 2017 | 2006 Cadillac CTS

1 Answer

I have a 2004 Trailblazer and the rear windshield wiper isn't working properly. Once you start the Windshield wiper it works fine however when you turn off the car or turn the wiper off it will not work...


The parking function is built into the motor assembly. We normally replace the assembly. If it is assembled with screws you may be able to open it and possibly repair it.

Aug 29, 2017 | 2002 Chevrolet TrailBlazer

1 Answer

Front windshield wipers turns on, it works then it


check for obstructions , check circuit breaker or relay

Sep 15, 2009 | 1999 Nissan Quest

1 Answer

Driver side windshield wiper


Hi check if the nut is is tight on the wiper handle to the linkage and also check that it did not strip before tightening good luck

Sep 02, 2009 | 2005 Saturn ION

1 Answer

Need to get a programmer dont know where its at


  • Windshield Wipers Continue to Run When Turn Signal and Windshield Wiper Switch Are Turned OFF
  • Damaged turn signal and windshield wiper switch .
  • Damaged windshield wiper motor .
  • Damaged windshield wiper control module.
7fd52e7.gif
efd7dbe.gif
Pin Number Circuit Circuit Function 1 57 (BK) Wiper Motor Ground (Park) 2 28 (BK/PK) Wiper Module to Wiper Motor (Park Switch) 3 65 (DG) Wiper Motor Power (Park Feed) 4 61 (Y/R) Wiper Motor Common (RUN) 5 56 (DB/O) Wiper Motor LO 6 58 (W) Wiper Motor HI
Windshield Wiper System The windshield wiper system consists of :
  • Windshield wiper motor (17508) (F-type).
  • Washer system.
  • Windshield wiper control module.
  • Turn signal and windshield wiper switch (13K359).
The windshield wiper control module is:
  • Located at the instrument panel fuse panel.
The windshield wiper motor is:
  • Attached to the cowl top extension (021A36) .
  • Connected to windshield wiper mounting arm and pivot shaft (17566) .
The turn signal and windshield wiper switch features a:
  • Rotary wiper switch.
  • Push type washer actuator.
OFF/Low/High Speed
  • Has a two-speed, permanent magnet, three brush electric windshield wiper motor .
  • The windshield wiper motor has a brush rigging that permits selection of low or high speed.
  • When the turn signal and windshield wiper switch is in the LO position, the common brush and the blue/orange wire brush are used, and the windshield wiper motor operates at low speed.
  • When the turn signal and windshield wiper switch is in the HI position, the common brush and the white wire brush are used.
  • In HI position, electric current will bypass a portion of the armature winding causing the windshield wiper motor to operate faster.
  • When the turn signal and windshield wiper switch is moved to the OFF position, the windshield wiper motor will continue at low speed until the park switch outer contacts open.
  • When the park switch contacts open, the windshield wiper motor stops in the park position.
Interval
When the turn signal and windshield wiper switch is in the interval position:
  • The wipers make single wipes separated by pauses.
  • The rotary switch is on the end of turn signal and windshield wiper switch .
  • The length of the pause can be set from approximately 1 to 17 seconds.
  • Length of pause decreases as the rotary switch is rotated away from off.
  • Length of pause increases as the rotary switch is rotated toward off.
While in the interval wiper mode:
  • It is normal to hear a slight click at the beginning of each on/pause cycle. NOTE: When using interval wipers, the first wipe may not occur until after a pause of up to 17 seconds.

May 27, 2009 | 1994 Ford Mustang

1 Answer

Wiper motor quit working


does the motor not run? check the operation rods connected to the arms and the motor, see if they are bent

Apr 07, 2009 | 1993 Ford Explorer Limited

1 Answer

Windshield wipers won't work right


The windsheild wiper relay might be stuck or broken. Try tapping it with something or replace it. Could also be the the switch (lever that you control the wipers with) i hope this helps and good luck with diagnosing your problem.

Feb 21, 2009 | Ford Taurus Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

80 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

77201 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...