Question about Cars & Trucks

1 Answer

Transmission was running great one day then the next it wont shift to second gear till around 4000 rpms. ?????

Posted by Anonymous on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Vice President:

    An expert whose answer gotĀ voted for 100 times.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 221 Answers

I hate to hear that but the good thing is this may not be as bad as you think. The governor, modulator, and/or throttle cable controls the shift points on non-computer (older) controlled transmissions. On computer controlled transmissions this shifting problem could be caused by a faulty sensor or a bad connection or defective solenoid pack. These types of problems can be resolved without the expense of a transmission removal. Take it to a reputable dealer for diagnosis. I always recommend a second opinion for any recommendation of needing a total rebuild. I hope this helps.

Posted on Jul 12, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why does my Yukon will not shift gears it does for first to second but will not after that rpms stay around 3000 to 4000


Most likely it is the gear shift mechanism between the lever and the box, which would be cheap to repair, alternatively it could be the internal selector shaft, which is a lot more expensive. Is it the same without the engine running?

Apr 16, 2016 | Cars & Trucks

1 Answer

Why is my rpm runs high at 55 mphr at 3500


Your transmission is not shifting make sure it is in D, if automatic

Sep 01, 2014 | 2003 Kia Spectra

1 Answer

1996 ford probe transmission/shifting problem


run fault codes and look for faulty transmission control module. Check that all the connections are clean /tight and dry

Nov 30, 2013 | Cars & Trucks

1 Answer

'03 Yukon Denali XL. Rpms go up to 3K at around


when you had the transmission filter and gasket changed. do you know if they back flushed the fluild. there is 5 to 7 shift soleniods in the transmission. when garages back flush transmission it causes the solenoids to close. are there any codes. sounds like your 1st and 2nd shift solenoid is stuck closed

Nov 28, 2012 | Cars & Trucks

1 Answer

My 92 subaru loyale runs good except it wont shift to 3rd gear. its an automatic. i drained the fluid and changed the strainer and still the same thing. and , the car jolts very hard when i put in reverse....


It sounds very much as though your transmission is faulty. The only way is to take it to a transmission repairer who will be able to properly diagnose it for you. Given the age of the car, it may not be economical to repair the transission and you may be better to source a 2nd hand one from a wrecker.

Jul 08, 2017 | Subaru Loyale Cars & Trucks

1 Answer

Transmission will not shift out of 1st gear.


Check your transmission fluid level. If the filter has never been changed, now is a good time to replace the fluid and filter.

Jul 11, 2009 | 1993 Saturn SC2

1 Answer

Transmission wont shift until about 4000rpms from 1st to 2nd gea


Have a code check done and see if speed sensor or controller is working properly. if bought from a dealer, get it back there asap...they can't sell it in that condition!!...No test drive before you ploped down your money?

Apr 16, 2009 | 2004 Jeep Grand Cherokee

1 Answer

1995 grand cherokee trans not shifting in to second gear


Check transmission fluid levels,,replace lost fluid as needed,,,if this does not work,,take the car to a mechanic,,,sorry to say,,this kind of problem almost alway's requires a transmission mechanic to repair.

Jan 13, 2009 | 1995 Jeep Grand Cherokee

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

321 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...