Question about 1997 Toyota Land Cruiser

Open Question

How to change brake pads on toyota prado model KZJ95R

How do i DIY change front and rear brake pads on toyota prado 1997 3.0L Turbo Diesel model KZJ95R with diagrams?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2 Answers

SOURCE: replace front brake pad 2003 toyota 4 runner

Diagram is unnecessry.
Pull both front wheels
Work one at a time leaving the other for reference
Find the retention spring ... its a paperclip thickness wire spring... dislodge center retention loop and undo from both ends which engage brake pad retention rods.
Pull the rods out
Pull the old pads out... laying everything on the ground
Use scrap wooden wedges to pry between the rotor and the caliper ...inside and out until the calipers are fully withdrawn. Use the new pads to measure if they are far enough back.
Note... the brake fluid will have dropped in the master cylinder over many months of wear... do not fill it. When the calipers are pushed back they will fill the reservoir again... one wheel at a time.
Be sure to identify the correct pad based on what you took out and what is on the other side (if you screwed up the layout)
Make sure to take the old antisqueek backing plate from the old pad and place it on the new pad. They don't use lubricant on these anymore.
Replace the pads... the retention rods... then the retention spring
Do the other side
Then progressively step on the brake peddle until full tension is felt
Check the master cylinder reservoir... probably needs no additional fluid.
New pads will register in existing ridges in each disc in no time at all.
You should check the discs to see if they need to be replaced during this operation...using some calipers

Posted on Mar 25, 2009

Technopro
  • 243 Answers

SOURCE: 1997 Toyota land cruiser prado Rz compass bearing, temperature setting, etc.

I've been resetting pajero's compasses but try to get to an area where you can do 360 degrees turns (empty car parks, ) press the reset button and make 2 complete 360 turns slowly and normally this should set the compass bearing.
Let us know how you get on. Cheers.

Posted on Oct 29, 2008

saailer
  • 1868 Answers

SOURCE: Toyota Prado Diesel. Electric windows do not operate

Hello! Turn the ignition switch on...Hold the master power window auto up switch for five seconds...Send a comment with results...


Guru........Saailer

Posted on Apr 11, 2010

  • 1 Answer

SOURCE: Toyota Land Cruiser Prado (LC90) Owner's Manual (free download)

hi sir/mam,i have tryed to get help from allover,can i know who can.
i have Toyota land cruiser Model GF-RZJ 95W-GKPSK-D.
Engine-3RZ-FE.
Fram-no rzj95-0047087.
This vehical does not start,Digonest code 002:-Fauity RPM Signal(no RPM,NE and crankshaft position signal trnsmitied to ECU after started for 2 secondes)
1.CKP and CMP sensors short open
2.Distibutor fault.
3.start circuit open or short.
4.module fault.
i have changed distibuteor (NEW)

Posted on Jun 26, 2010

  • 1 Answer

SOURCE: How do I reset the timing belt warning light in a

how to reset timing belt warning light in a toyota hilux model LN 145

Posted on Sep 11, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Tow ball weight, is tow ball weight included in caravan weight when attached to car I am towing with a Toyota Diesel Turbo Prado 2004. Tow ball weight 250, Caravan Weight 2620kgs


No as it is part of the car not the caravan. The weight is minimal anyway. You are measuring hitch weight, the amount of force exerted downwards (hopefully) on the rear of the vehicle.

Apr 02, 2017 | Cars & Trucks

1 Answer

My toyota prado lj78 diesel engine does not pull and does not engange gears propally,what can i do to fix this problem?


It sounds like the turbo has gone out. That will make a diesel sluggish and burn oil out the turbo. replace the turbo and it should be fine

Apr 16, 2012 | Cars & Trucks

1 Answer

How to change front and rear brake pads on 98 starlet


Go to the library and get a motors repair manual that covers your model ...

Mar 21, 2010 | Toyota Starlet Cars & Trucks

3 Answers

Brake pads


The brake pads replacement procedure is pretty much the same as on older models.

You find detailed instructions on Toyota here Front and rear brake pad change

Apr 29, 2009 | Toyota Land Cruiser Cars & Trucks

2 Answers

Toyota Landcruiser 4.2lt diesel OR 3lt turbo diesel prado


The cruiser as long as its the turbo diesel, direct injection (4.2td), be aware though that this model has inherent "sag" with the IFS suspension, so if buying secondhand then upgrade the torsion bars(and factor this into your buying price).

Sep 13, 2008 | 2004 Toyota Land Cruiser

1 Answer

Rear brakes


Did you open the brake lines to squeeze the piston back. If you did you need to bleed the brake system there is air in the system. Good Luck

Jun 21, 2008 | 1998 Toyota Land Cruiser

Not finding what you are looking for?
1997 Toyota Land Cruiser Logo

Related Topics:

1,371 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...