Question about 1998 Chrysler Sebring

1 Answer

98 Sebring 2.5 runs fine when engine is cold, starts to bog down when hot stumbles and can't get out of it's own way. When u floor it after the stumble it goes like it should slow down and starts to stumble again. New EGR, Fuel filter. Plugs and wires are in good condition,compression test is good, i'm leaning towards a bad coil any ideas?

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I am having the same problems with mine,, new EGR valve, new plugs wires, cap and rotor along with coils all tested good.

i still have my check engine light flashing on and off and the only codes the car pulls is misfire in #1 cylinder, nothing seems to fix this??? what going on?

Posted on Jul 31, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

Car bogs down unless I push pedal to the floor--sometimes

Sometimes is very ambiguous. Try to figure out what the sometimes are. Cold, hot, uphill, downhill, time the engine has run, full gas tank?

Oct 27, 2017 | Cars & Trucks

1 Answer

I have a 1996 dodge dakota 2wd took out the 5.2 and put a 5.9 in headers no cats no 02 sencers and my problem is when i start it cold idle is good but if i take it to 2,000rpm it will bog down then...

Without input from the O2's, the engine goes into fail-safe mode and runs in a full rich fuel trim. When the engine is cold the spark plugs are being "loaded up" with unburnt fuel, and engine stumbles. Hope this helps.

Mar 14, 2014 | 1996 Dodge Dakota

1 Answer

When car is cold run nice but after a few min she start to dog down

tune up time.?
or engine is going lean,
if engine shacks at bog that is flooding misfire.

the tech finds out which it is, with simple tests.
want to guess, or test?

Feb 06, 2014 | 1991 Toyota Corolla

1 Answer

Cranks and idles good but will not accellerate no codes on engine fuel pump pressure 38to41 new fuel regulator , cat conv punched out 98 Suzuki Esteem


1.6L or the 1.8L

good pressure. no melted cat.

so what engine,, (but both are MAF based systems)soooooo

low power, all the time. lits call it bogs. (3letters)

elaborate that, when does power end.

hot , cold both engine temp?

only tip-in BOG... you move foot fast , it bogs then catches up.?

or you TIP-in and its bog city all the way to WOT. ( wide open throttle)

when was the last time car was DD, a daily driver.

last week ,month or decade? key question.

bad fuel of over 6months old fuel?

here are the tests.

1: all fuses good. (always for ever and ever)

2: key on,

3: the dash lights up , oil, charge, and CEL, is the CEL on, it must be.

4: start car, CEL goes out , does it, stay out running???????

5: bogs, hot ,or cold engine block?

6: no codes, does that mean an OBD2 scan tool shows no DTCs stored, and no pendings, and all monitors complete, no it wont

with the CAT gutted,, it will show P0420x for ever. bad dead cat.

what does no code mean.

here is a oBD2 1996 scan of the G16b ENGINE,

the J18 engine would do same......

see the tests. here.

bogging with either engine, hard lasting hot bogging, is:

in no order... fate is random , in many cases...

1: low fuel pressure, (not you) stated for full correct.

2: clogged injectors.

3: bad fuel.

4: weak maf, ECU cant tell weak , only dead. or just a dirty maf. ask.!

one way to prove a WEAK maf, is to unplug it

the ECU then see that and creates a virtual simulated MAF.

it will not have full power, but will have lots.

it will run in suzuki limphome mode, with retarded timing, and low power and limted RPM.

it will suck fuel.

i never do it because i have the outputs logged. i use a voltmeter

Jan 22, 2014 | 1998 Suzuki Esteem

1 Answer

98 Corolla stalls or stumbles when cold

It sounds like you may have picked up some small debris from the bottom of the gas tank when you ran it empty. You may need to run a fuel/injector cleaning solution through the next tank of gas to clear the debris and consider changing your fuel filter too. Sea Foam is a great fuel additive and I recomment trying it full strength. Hope this helps!

Oct 06, 2009 | 2001 Toyota Corolla

3 Answers

First few minutes now that weather is cooler engine boggs and buc

did you go with a free flow or cat back system. The wrngler needs back pressure to run properly

Sep 12, 2009 | 1999 Jeep Wrangler

2 Answers

2001 Hyundai Sonata Bogs down

My Son's 01 Sonata displayed the exact same systems and it was his catalytic converter. The metallic sounds were the converter guts disintegrating.

Mar 09, 2009 | 2001 Hyundai Sonata

1 Answer

2004 sebring 2.7 engine, will strt when cold but not when warm

more than likely a bad crank sensor but not knowing if there are codes might also be a cam sensor,it is deffently a electrical componet problem hot soak of the motor will break down bad electrical sensors,

Jan 23, 2009 | 2004 Chrysler Sebring

1 Answer

Starting Problem

Look on the distributor. There is a module on it that, when too hot, will cause miss/stall/no re-start situations.

Jul 28, 2008 | 1998 Ford Escort

Not finding what you are looking for?
1998 Chrysler Sebring Logo

317 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts


Level 3 Expert

83772 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22413 Answers


Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides