Question about 2003 GMC Envoy

1 Answer

How do I reset the change engine oil light on this vehicle after changing the oil?

Posted by on

  • daleruhland2 Jul 11, 2010

    Still need help for this 2003 GMC Envoy. I tried using the radio controls per the instructions given by mistavp05 but the radio would not go into settings mode. Any suggestions would be helpful. Thanks.

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sniper:

    An expert who has posted more than 50 answers, of which 90% or more were rated as helpful.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 78 Answers

Go into the vehicle settings with the radio controls. With the key turned to ACC, hold DISP on the radio for about 6 seconds and it should go into settings mode. Press DISP until you see oil life in all caps, then use Prev. & Next to scroll to reset oil life mon., then push DISP again. you should here a beep and the display should read Done. Scroll to Exit and press DISP again. Good luck

Posted on Jul 11, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How to reset change oil soon light


Oil Life Monitor Resetting (KD, KE)
Description
The engine oil life monitor will indicate when to change the engine oil and the engine oil filter - usually between 5 000 km (3,000 miles) and 12 500 km (7,500 miles) since the last oil change. Under severe conditions, the CHANGE OIL message may be displayed before 5 000 km (3,000 miles). The vehicle must not be driven more than 12 500 km (7,500 miles) or 12 months without an oil change.
The engine oil life monitor will not detect dust in the oil. If the vehicle is driven in a dusty area, be sure to change the oil every 5 000 km (3,000 miles) or sooner if the CHANGE ENGINE OIL message is displayed.
Reset the oil life monitor when the oil has been changed.
Resetting Procedure
Press the INFORMATION SKIP button on the DIC control panel in order to display the OIL LIFE LEFT message.
Press and hold the RESET NO button until the display shows 100% ENGINE OIL LIFE.

Jan 29, 2016 | 1999 Cadillac DeVille

3 Answers

Reset oil change milage


GM OIL LIFE SYSTEM - RESETTING
The engine oil life monitor will indicate when to change the engine oil - usually between 5 000 km (3,000 miles) and 16 000 km (10,000 miles) since the last oil change. Under severe conditions, the "CHANGE OIL SOON" light may be displayed before 5 000 km (3,000 miles). The vehicle must not be driven more than 16 000 km (10,000 miles) or 12 months without an oil change.

Reset the oil life monitor when the oil has been changed, use the following procedure:
  1. Turn the ignition key to the RUN position.
  2. Fully push and release the accelerator pedal 3 times within 5 seconds.
  3. If the Change Oil Soon light flashes, the system is resetting.
  4. Start the vehicle.
  5. The oil life will change to 100%.
  6. If the Change Oil Soon light comes back on, the system has not reset. Repeat the procedure.

Mar 06, 2011 | 2004 GMC Sierra 1500 Crew Cab

1 Answer

How do i reset the change oil light?


Turn the ignition to ON without starting the engine. Fully press and release the accelerator pedal three times within five seconds. If the CHANGE OIL SOON indicator flashes two times, the system is resetting. Turn the key off after the the light has finished flashing, then start the vehicle. If the CHANGE OIL SOON indictor comes back on, the engine oil life monitor has not reset. Repeat the procedure again. If the vehicle is equipped with the U20 option code, the vehicle as an oil life low indicator. The oil life low indicator shows an estimate of the oil's remaining useful life. When the oil life index is less than 10 percent, the display will show OIL LIFE LOW. To reset the oil life monitor, press and hold the MODE button until the light appears next to OIL LIFE. Press and hold the trip RESET button until the oil life percentage changes to 99 percent.

Nov 28, 2010 | 2000 Oldsmobile Intrigue

2 Answers

How to do I reset the maintenance service light on my 2007 Chevy Trail Blazer


there is no light for emissions testing on this vehicle. there is a ses light that can come on, indicationg a problem with the engine or transmission electronic system. this will require a scan tool to pull trouble codes. there is another light called oil life monitoring that needs to be reset after oil changes, which I suspect is what you are seeing. here is a picture of the light and the instructions for resetting.,

The Engine Oil Life System calculates when to change your engine oil and filter based on vehicle use. Anytime your oil is changed, reset the system so it can calculate when the next oil change is required. If a situation occurs where you change your oil prior to a CHANGE OIL SOON message being turned on, reset the system.
After changing the engine oil, the system must be reset as follows:
  1. Turn the ignition to RUN, with the engine OFF.
  2. Press the information and reset buttons on the Driver Information Center (DIC) at the same time to enter the personalization menu.
  3. Press the information button to scroll through the available personalization menu modes until the DIC display shows OIL LIFE RESET.
  4. Press and hold the reset button until the DIC display shows ACKNOWLEDGED. This will tell you the system has been reset.
  5. Turn the key to LOCK.
If the CHANGE ENGINE OIL message comes back on when you start the vehicle, the Engine Oil Life System has not reset. Repeat the reset procedure.



485d3b2.gif

Sep 09, 2010 | 2007 Chevrolet TrailBlazer SS

1 Answer

How do you reset the "Change Oil" light?


How to Reset the CHANGE OIL Light:
1. With the ignition key in ON but the engine off, fully push and realse the accelerator pedal slowly three times within five seconds.
2. If the CHANGE OIL light flashes, the system is resetting.
3. TUrn the key to OFF, then start the vehicle. If the CHANGE OIL light comes back on, the engine oil life monitor has not reset. Repeat the procedure.

Jun 24, 2010 | 1998 Oldsmobile Intrigue

1 Answer

How do i reset the service the service vehicle soon light? I have changed the oil


Turn the ignition to ON, with the engine off. Fully depress and release the accelerator pedal slowly three times within five seconds. The reset is complete when you hear the chimes and the “CHANGE OIL” light goes out. If the light stays on and no chime is heard, you will need to repeat the reset procedure. Turn the key to OFF. If the “CHANGE ENGINE OIL” message comes back on when you start your vehicle, the engine oil life system has not reset. Repeat the procedure.

Mar 30, 2010 | 1998 Oldsmobile Intrigue

3 Answers

Change oil light came on


In your owners manual there is a procedure listed for resetting thr oil change reminder/maintenance light. Some vehicles you turn key on..do not start it.. step on gas pedal all the way to the floor 3 times... then key off. others haver u hold the trip odometer reset button when u turn key on.
It varies from manufacture to manufacturer.

Jul 10, 2009 | 2006 Isuzu Ascender

1 Answer

I can't reset the engine oil life in a 2007 H3 it did work in the past, all I can do now is change the language. I called the dealer they are no help at all.


try
Resetting the Change Engine Oil light System
On some vehicles it is possible to reset the Engine Oil life with Tech 2 (in Engine) otherwise the following procedure can be used.
1. Turn the ignition key to the ON position
2. Fully depress and release the accelerator pedal three times within five seconds.
3. The Change Engine Oil light will flash while the system is resetting.
4. When the light stops flashing, turn the key to LOCK/OFF. If the Change Engine Oil light comes back on and stays on when the vehicle is started, the system has not reset. Repeat the Reset procedure.

Jul 07, 2009 | 2001 Hummer H3

2 Answers

How it reset service engine light


Is it the "oil change req." light? Your owners manual will have the process for reseting the oil change light.
If it is "service engine soon" light, the vehicle will need to be scanned with a professional scanner.

Jun 20, 2009 | 1996 Dodge Caravan

1 Answer

I have a 2005 Venture and have not been able to reset the change engine oil light. After repeatedly pressing the trip/reset button for 2 minutes the message center was still flashing change engine oil and...


Notes ENGINE OIL LIFE SYSTEM

HOW TO RESET THE ENGINE OIL LIFE SYSTEM
The Engine Oil Life System calculates when to change your engine oil and filter based on vehicle use. Anytime your oil is changed, reset the system so it can calculate when the next oil change is required. If a situation occurs where you change your oil prior to a "CHANGE ENGINE OIL" message being turned on, reset the system.

  1. With the ignition key in "RUN" but the engine off, repeatedly push the trip/reset button until "OIL" is displayed on the Driver Information Center (DIC).
  2. Once "OIL" is displayed, push and hold the trip/reset button for five seconds. The number will disappear and be replaced by 100 (indicating 100% oil life remaining).
  3. Turn the key to "OFF". If the "CHANGE ENGINE OIL" message comes back on when you start your vehicle, the engine oil life system has not reset. Repeat the procedure.
If this does not work you may have a problem with your instrument cluster.

Mar 22, 2009 | 2005 Chevrolet Venture

Not finding what you are looking for?
2003 GMC Envoy Logo

140 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...