Question about 2000 Chevrolet Blazer

1 Answer

Need radiator flush

How do i empty radiator?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 38 Answers

Open petcock at bottom rear of radiator. if not petcock, remove lower radiator hose.

Posted on Jul 11, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to flush a heater core


When you flush your radiator, the heater core gets flushed as well. You will have to run the vehicle untill the heater is blowing hot air during the flush, that way its going through the thermostat. Empty the radiator as per normal and thats it.

Jan 08, 2015 | 1991 Chevrolet S-10 Blazer

1 Answer

Water reserve bottle is emptying and engine is getting how


flushing a radiator is a waste of time and money as blocked cores do not flush. Have a pressure test done on the coolant system and check for external leaks. have a compression test done to check for head gasket and cracked head. Have a flow test done on the radiator and if shows signs of blockage replace the radiator .. Always fill the radiator at the radiator cap and not the reserve bottle. The reserve bottle water will not go down until the engine coolant starts to cool so if it is going down when the engine is hot then you have a bad leak in the reservoir bottle.

Jan 07, 2014 | 2000 Oldsmobile Intrigue

1 Answer

How do i drain my radiator for my lexus ls400


To drain,remove bottom radiator hose.After empty,run clean water through radiator.Then use a flush on it.

Dec 13, 2012 | Cars & Trucks

1 Answer

I have 260K on my 2004 2.7 santa fe. A little steam escapes from the top of the radiator when it is up to temp. It has never overheated (yet), but I am worried that I need a new radiator. I have never...


Well i suggest to never use stop leak because it will clog up cooling ports not only in the radiator but the engine also. I would flush the whole system you can purchase a flush kit at a local parts store. it is usually a cleaner that you run threw the system let the engine get up to temp for a while then drain everything after it cools down and take the thermostat out of the system usually i will leave the hose disconnected at the thermostat instead and stick a water hose in the radiator turn on and let it flush sometimes you have to start your vehicle but make sure you don't over heat it. If you can tell that there is a crack in the radiator i would replace it stop leak in my line of work is a no no it causes more issues that solves. If you have any more questions pleas let me know and leave good feedback please.

Jun 23, 2011 | Hyundai Santa Fe Cars & Trucks

1 Answer

Yes it is normal just no hot air


1. When setting the temperature to MAX, blower level to FULL and outside air Vent CLOSED, no hot air comes out after 2-5 minutes?
If YES, when did you last flushed your radiator and is it full?
2. if more than 5 years ago, flush radiator system, instructions are usually in Owners manual. Use a bottle of Radiator cleaner, run egine hot for about 10-15 minutes, carefully open petcock in bottom of radiator to flush out radiator, WARNING, careful as flushed coolant would be boiling hot. As sson petcock is open and water start to flow out, carefully open radiator cap to enhance flushing flow. Use garden hose to fill radiator while flushing until water coming out from petcock is cold and clear.
Once clear, start engine, turn heter full and blower full blast and keep hose in radiator flowing full, leave petcock open until clear water flows out again. Once clear waters comes out, turn off engine,turn off garden hose and let water drain empty radiator. Once it stops flowing out, close petcock snug and put radiator cap on, pull off radiator coolant catch bottle, clean bottle for any debris and dirt. Drain any water, leave bottle empty and put it back onto its place.
3. Fill radiator with 1 gallon (4L) of concentrated coolant, top up radiator until full, fill catch bottle with concentrated coolant, start engine and keep it overflowing until no bubbles comes out and the radiator is fully hot. Once it is flowing good, close and connect everything. Drive with it and keep catch bottle filled as necessarry.
Good luck. Give as vote and good comment if this advise solve youor problem. Thank you.

Jan 05, 2011 | 2000 Chevrolet Suburban

1 Answer

Im trying to flush my radiator on my 99 pontiac grand am and when I turn the petcock nothing comes out. Does that mean my radiator is completely empty, or should I take the lower hose off, or run water...


yup it might be m/t.or the petcock is ruined.i've seen that happen.someone turns it the wrong way and its stripped or it was seized and when you try to turn it it breaks.just get a flush and fill kit from the parts store and you can flush your rrad real easy

Nov 20, 2010 | 2001 Pontiac Grand Am SE

1 Answer

Where is the engine coolant drain valve located? and what is the best procedure to change the coolant and flush the radiator? thanks


1.) the drain valve is a bolt type device under the radiator..

2.) different flush has different methods usually buy the flush and follow the instructions.. usually
empty radiator by loosening valve underneath
tighten back valve when drained
pour in flush and top up with water
start car and allow to run for 15 minutes (with cap off)
cut off
let cool and then drain..

add coolant .. your done..

Oct 29, 2010 | 1996 Oldsmobile Cutlass Supreme Coupe

1 Answer

How to flush radiator? Does it have a drain plug?


Drain plug is located in lower side of radiator. While your engine is cold and off, open your radiator drain plug and filling cap. In minutes your radiator will empty.Then fill up your radiator.

Aug 13, 2010 | 2001 Chevrolet Prizm

2 Answers

I have two questions. I have a 1990 4.2 liter Jeep Wrangler. It was sitting for 2 years and would jump but not charge. I replaced the alternator. Now it will charge but only to about 8-10 on the gauge....


well if u didnt yet buy a new battery. Batteries can only be charged so many times. With new alternator and battery it should be fine. Now with it sitting for 2 years im sure the radiator needs to be flushed. Change belt. Then empty the radiator fluid and run fresh water though it. I usually leave the drain plug out stick the garden hose in and let the water run with engine off till it comes out clean. But what you should do is empty it. put drain plug back in.Fill it with just plain water run it for a little while 20-25 min. let it cool. empty it again and it should clean it out. then fill it the 50/50 way. They also sell radiator cleaner. Water pump usually leaks when its bad.

Sep 25, 2009 | 1990 Jeep Wrangler

1 Answer

Overheating 2001 pontiac aztek


remove coolant.remove thermostat remove bottom radiator hose to water pump.put a empty container under the radiator.take a water hose put it where thermostat goes flush out the rust in block.watch the water as it come out the water pump .if stream water is small keep flushing until you get a study sream of clear water. also flush out radiator. lower water pressure dont flush radiator it with high water pressure you could burst it. make clean the over flow jug .make sure it not stopped up.put in a new thermostat and radiator pressure cap. fill radiator with half antifreeze and half water.bleed the coolant system.

Apr 05, 2009 | 2001 Pontiac Aztek

Not finding what you are looking for?
2000 Chevrolet Blazer Logo

Related Topics:

139 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7710 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...