Question about 2006 Ford Focus

2 Answers

Stereo Wiring Colours

I need to know how to hook up my aftermarket headunit up to the car. I have pulled out the old head unit and set up everything for the new headunit to go in i just need to hook the wires up. But as i dont know what the wires in the car hook up to its a bit hard. If somebody could please help me with these codes that would be extremly helpful.

Posted by on

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Ford Master
  • 1,940 Answers

2006 Ford Focus Car Stereo Wire Color Codes
Car Radio Battery Constant 12v+ Wire: Yellow/Green
Car Radio Accessory Switched 12v+ Wire: Orange/Black
Car Radio Ground Wire: Black/Green
Car Radio Illumination Wire: Orange/Black
Car Stereo Dimmer Wire: N/A
Car Stereo Antenna Trigger Wire: N/A
Car Stereo Amp Trigger Wire: N/A
Car Stereo Amplifier Location: N/A
Car Audio Front Speakers Size: N/A
Car Audio Front Speakers Location: N/A
Left Front Speaker Positive Wire (+): White/Black
Left Front Speaker Negative Wire (-): Gray/Black
Right Front Speaker Positive Wire (+): White/Red
Right Front Speaker Negative Wire (-): Gray/Red
Car Audio Rear Speakers Size: N/A
Car Audio Rear Speakers Location: N/A
Left Rear Speaker Positive Wire (+): White/Green
Left Rear Speaker Negative Wire (-): Gray/White
Right Rear Speaker Positive Wire (+): White
Right Rear Speaker Negative Wire (-): Gray

Posted on Jul 11, 2010

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 176 Answers

I would just buy a harness at walmart, autozone or best buy or anystore like that. its worth the money, you can order it cheaper through ebay if you can wait.

Posted on Jul 11, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

88 vette aftermarket head unit stereo wireing diagram


Might be able to get an adaptor that plugs straight in painlessly.
Failing that it's the standard trace and identify method that eats time like crazy.

Apr 16, 2017 | Cars & Trucks

1 Answer

How do I make the power antenna go up when the radio turns on after installing a new aftermarket headunit?


the instructions of the new power aerial will explain how to wire up the unit
some are wire for wire and others some wires are used and others the wires are different
talk with a radio installer for suggestions of the wiring

Aug 08, 2016 | 1995 Jeep Cherokee

3 Answers

Trying to match my aftermarket radio with factory speaker wires.. BROWN YELLOW GREEN VIOLET / WHITE STRIPE LT BLUE LT BLUE / BLACK STRIPE WHITE /RED STRIPE WHITE / RED STRIPE


Greg, Check the attached links,instruction and guides stereo and speaker wiring, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."


WIRE COLOR CODES FOR CAR INSTALLATION

Car Stereo Wiring Diagrams and Car Radio Wiring Diagrams

https://www.installdr.com/quickwiring.asp

Car Stereo Wiring Diagrams Director

Apr 03, 2016 | Cars & Trucks

1 Answer

Can i hook up a parakeet model number PWM 16 to my factory stereo in a 98 Ford Expedition


About 3,970 results (0.89 seconds) Search Results

    Ford Bluetooth® Wiring Harness - Crutchfield

    www.crutchfield.com/.../Ford-Bluetooth-Wiring-...

    Crutchfield Corporation
    Rating: 4.5 - ‎16 reviews - ‎$19.99 - ‎In stock
    Reinstall the factory radio and mount the Bluetooth kit, and you're ready to go. ... 16Reviews ... harness so that I could hook up an aftermarket amp to my factory radio.... works like it's suppose to. says it doesn't work on an 09 Escape but had no .... I purchased this harness to install a parrot ck3100 in my 07 Ford Edge.Missing: pwm

    70-5521 wiring harness for ford with 6 CD premium sub amp ...

    ? 4:30
    https://www.youtube.com/watch?v=0jqNafnki0o
    Aug 9, 2013 - Uploaded by codieraji
    Metra 70-5521 Radio Wiring Harness for Ford 03-Up Amp FordPremium stereo radio 6 CD changer with sub amp inputs. ...16:47. How to wire an aftermarket radio / I Demo install with metra harness and antenna ... How to hook up stock amp/sub to aftermarket head unit "ford sport trac" - Duration: 3:01. Pat.Missing: parakeet ‎pwm ‎98

    Car Stereo Wire Harnesses - Radio Wires for all Car Audio ...

    www.installer.com/main.php?page=harness
    Car Stereo Wire Harnesses - Car Stereo Installation Wiring - Stereo Harness ... If you

Feb 09, 2016 | Ford Cars & Trucks

1 Answer

How do I add the security code for the stereo unit after changing over to a different unit?


To help further we need to know what make and model of vehicle you have also what radio you have, but usually after you replace the factory headunit in your vehicle with an aftermarket one ie. Gm -> alpine you will no longer need a code because the aftermarket head unit does not have a security system like the factory one

Dec 23, 2014 | Cars & Trucks

1 Answer

Change out the factory stero for an aftermarket head unit


Once you remove the screws to the console panel and remove console, you will see 4 scews that hold the stereo in tact, remove them, pull stereo, disconnect wiring harness and antennae. If you need a wiring diagram you can go to 12volt dot com or installer dot come. I suggest using the quick connect wiring harness adapter

Jun 09, 2012 | 2002 GMC Yukon

1 Answer

My 03 cavalier stereo fuse keeps blowing


The remote circuit in your amp is probably shorted

Mar 07, 2012 | 2003 Chevrolet Cavalier

3 Answers

I need the radio operating manual for a Jeep Patriot 2009 model. Where can I down load it from as the local dealer cannot seem to find a hard copy for me.


following is the procedure. u can also check ehow for more details.
  • Twist the negative cable off the terminal on the vehicle battery, using an adjustable wrench.
  • Remove the factory issue stereo. Pry off the radio trim bezel with a flat head screwdriver. Remove the four bolts on each corner of the radio. Pull the radio out the dashboard. Unplug the thick black radio antenna cable. Disconnect the wire harnesses from the rear of the stereo. Place the old stereo to one side.
  • Prepare the dashboard for the new stereo. Fit the radio installation sleeve provided with the aftermarket stereo to the radio installation kit. Feed the sleeve through the portal of the radio installation kit and bend the tabs on the sides of the sleeve to secure it in place. Feed the audio wiring of the Jeep and the radio antenna cable through the portal of the assembly and slide the assembly into the dashboard. Secure it in place with the bolts removed earlier.
  • Wire the new stereo. Connect the wiring of the stereo to the audio wiring of the Patriot, using a custom wire harness adapter. Push the connections together until they snap into place and test the connection by tugging gently on either end.
  • Plug the radio antenna cable into the alloted port on the rear of the aftermarket head unit.
  • Slide the connected aftermarket stereo into the prepared housing in the Patriot's dashboard. Click it into place in the radio installation sleeve, taking care not to trap any wiring.



  • Jan 03, 2011 | 2009 Jeep Patriot

    1 Answer

    How do you take of the dash paneling to install a new aftermarket cd player?


  • Disconnect the negative battery cable from the Jeep Cherokee battery with the 10 mm wrench.
  • 2 Remove the five screws on the top edge of the dash panel with a Phillips-head screwdriver.
  • 3 Pry the trim panels surrounding the climate control knobs away from the dashboard with the trim panel removal tool.
  • 4 Remove the trim panel that surrounds the headlamp switches (located to the left of the steering column) with a trim panel removal tool.
  • 5 Remove the two screws behind the trim panel that surrounds the headlamp controls with a Phillips-head screwdriver.
  • 6 Pull the dash panel that surrounds the stereo and covers the instrument panel of the Cherokee, away from the dashboard by hand.
  • 7 Remove the two screws from the stereo mounting bracket. One screw is on the bottom left corner, the other screw is on the top right corner. Each screw can be removed with the 10 mm socket and drive.
  • 8 Pull the factory stereo from the stereo mounting dock.
  • 9 Disconnect the stereo wiring from the back of the factory unit.
  • 10 Connect the Jeep Cherokee factory stereo wiring to a wiring harness adapter. Connect the wiring harness adapter leads to an aftermarket stereo. Slide the aftermarket stereo into the stereo mounting bracket and replaced two screws at the opposite corners with the 10 mm socket and drive.
  • 11 Replace dash panel that stretches across the top of the steering column.
  • 12 Replace the two screws at the top of the headlamp control switch. Replace the trim panel around the headlamp switch.
  • 13 Replace the trim panel that surrounds the climate control knobs.
  • 14 Replace the five screws on the top edge of the dashboard with a Phillips-head screwdriver.
  • 15 Replace the negative battery cable over the negative battery terminal and tighten the cable to the negative lead post with the 10 mm wrench



  • Dec 24, 2010 | 2006 Jeep Grand Cherokee

    1 Answer

    Radio connection


    if he had an aftermarket stereo in the vehical then he had to cut the origional harness out of the way. the only solution for this would be to replace with another aftermarket stereo. I know this becaus ei had a ***** of a time trying to install my aftermarket.

    Jun 24, 2008 | 1990 Pontiac Sunbird

    Not finding what you are looking for?
    2006 Ford Focus Logo

    409 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Ford Experts

    yadayada
    yadayada

    Level 3 Expert

    75822 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22156 Answers

    fordexpert

    Level 3 Expert

    5501 Answers

    Are you a Ford Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...