Question about 2001 BMW 330

1 Answer

2001 330i BMW hazard lights & central locking in car won't work

2001 330i BMW hazard lights and central locking system buttons in the car stopped working ... both buttons are stuck and do not move up or down when you push them. Car doors will lock and unlock with the remote ignition key. Note: I can not use the hazard lights at all. What's wrong with the buttons in the car? How much to fix problem?
2001 330i BMW hazard lights & central locking in car won't work

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I'm having the same problem have you fixed yours?

Posted on Apr 13, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

jasonrwagner
  • 14 Answers

SOURCE: 2001 BMW 330i..Fan for AC/vent not working?

The problem is the ac resistor located on the passenger side of the center console. It's a little difficult to get to but not impossible. If i remember correctly it cost about 100.00$ from your BMW dealer. If you do a internet search for problems with BMW a/c you will find many post and fixes. BMW has made 3 revisions to this resistor over the past few years. If replacing this parts does not fix it then the only other cause will be the climate control module located in your climate control display. This is a very expensive part.Remove the plastic cover behind the glove box (passenger side) look toward the drivers side close to the bulkhead and it will be there, disconnect the plug, release the clip and pull back gentally (don't break the clips!) it's pretty easy.
Good Luck

Posted on Jul 13, 2008

emissionwiz
  • 75822 Answers

SOURCE: 2001 BMW 330i clutch vibration

u have a worn out clutch pressure plate release bearing, that is what u feel and hear..

Posted on Dec 22, 2008

  • 51 Answers

SOURCE: 2001 BMW 330i..Fan for AC/vent not working?

it's either a fuse or it's a bad blower motor, it could be a bad blower motor resistor but usually you'll get either high or low only, so if you have nothing on any speed, high low etc, and all the fuses are ok chances are it's your blower motor.

Posted on Jan 16, 2009

onyeredson
  • 404 Answers

SOURCE: Central Locking not working

Hi Craig,
I'm running a E34 Tds Touring with a similar problem, my rear doors and tailgate have dropped of the central locking circuit.
I have been told it is the Central locking Module a large black box under the dash that is faulty, apparently a common problem.
Hope this points you in the right direction,
Please remember to rate my effort!
Paul 'W'
Onyer~EDson(:0) {#><U.K.

Posted on Jan 19, 2009

  • 51 Answers

SOURCE: BMW Power Locks don't work, how much to repair?

Before you bring it to a garage and pay good money check the fuses. Usually its as simple as that (located near the battery in the engine bay)

Hope this helps.

Posted on Apr 30, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Audi a6 avant door


If all else fails you may need to change the central lock system control module. You need to supply dealer with Vin #

Apr 01, 2014 | 2003 Audi A6

1 Answer

How do i reset central locking on a micra 04 reg


Try the following:

"KEY FOB PROGRAMMING
NISSAN
SYSTEM DESCRIPTION
The Central Door locking is controlled by the Multi-Remote Control system which controls
the door locking, door super locking and hazard reminder. When the doors are locked and
unlocked the unit flashes the hazard lights once for lock and twice for unlock.
A maximum of four remote controls are allowed to be programmed.
ALMERA
ALMERA TINO
PRIMERA
MAXIMA
MICRA
SERENA
VANETTE CARGO
TERANO II
Ensure all the doors have been unlocked, either by using a good transponder key or remote
control plip key.
Procedure
1. Turn the ignition switch from Position 0 to ON 6 times within 10 seconds.
2. Then turn ignition switch to OFF position. Leave key in ignition switch.
3. After 2 seconds, the system will enter programming mode and will flash the warning
lights twice.
4. Press and HOLD the unlock button on the Plip.
5. While pressing the unlock button, press the lock button 3 times.
6. Release the unlock button.
7. The warning lights will flash once to indicate successful programming.
8. Repeat procedure 4 to 7 for up to 4 plip key?s.
9. When completed turn ignition ON, and the warning lights will flash 2 times.
10. Remove key, and check all plip key?s for operation.
NOTE : The programming mode will stop when either the ignition is switch ON, 4 plip keys
have been programmed or no input signal either from the switch or plip keys has been received
for 120 seconds."

Mar 12, 2012 | Nissan Cars & Trucks

1 Answer

My bmw 320d remote wont lock car however does lock the car with the key its a 55 reg


1
Programming
When
Key batteries completely discharged. Key batteries not replaced within 60 seconds. Key added or replaced. DO NOT press remote control buttons during battery replacement.
How
Unlock vehicle. Enter vehicle. Close driver's door. Switch ignition ON and OFF. Remove ignition key. Press and hold unlock button Fig. 1 [1]. Press lock button Fig. 1 [2] briefly 3 times within 10 seconds keeping unlock button [1] depressed. Release unlock button Fig. 1 [1]. Some models: LED Fig. 1 [3] flashes slowly for 10 seconds. Some models: Central locking system locks and unlocks rapidly to indicate correct programming. Some models: Repeat above procedure if central locking system does not work and LED does not flash or LED flashes continuously
Later keys with bmw badge on key. Battery can not be replaced
Battery in key charges while driving

Dec 22, 2010 | BMW 3 Series Cars & Trucks

1 Answer

Hazard warning lights won't stop flashing


this sounds like the alarm system is going off,try unlocking from the pass/side door and if lights dont flash then you have a bad lock switch in the door.

Jun 18, 2010 | 1994 BMW 3 Series

2 Answers

2002 bmw 530i key does not (remotely) unlock doors or trunk but they work fine manually.


Unlock vehicle. Enter vehicle. Close driver's door. Switch ignition ON and OFF. Remove ignition key. Press and hold unlock button. Press lock button briefly 3 times within 10 seconds keeping unlock button depressed. Release unlock button. Some models: LED flashes slowly for 10 seconds. Some models: Central locking system locks and unlocks rapidly to indicate correct programming. Repeat above procedure if central locking system does not work and LED does not flash or LED flashes continuously.

Mar 09, 2010 | 2002 BMW 5 Series

2 Answers

I have BMW 330ci, the central locking does not work. Bmw fixed it in a matter of seconds last time it happened but it is expensive. Can i reset the key fob myself ?


put the key in the ign cyl and turn car on and off, remove key and hold unlock while pressing the lock button 3x,the locks will lock and then unlock if you have a second key do the same thing immediatly following except do not cycle key in ign just press the buttons int he same sequence

Dec 21, 2009 | 2001 BMW 330

2 Answers

E36 BMW 318I CENTRAL LOCKING A. I bought a 2nd hand 1995 BMW 318I in South Africa. Good condition. No owner?s manual. Everything worked ok for a few months. Then the batteries of the remote key transmitter...


try locking and unlocking the car with the key 3 times slowly ,other than that i have no idea ?? another trick is to disconnect battery and join the cables together for a few minutes to discharge any capacitors that may be holding a charge in the computer..Only other thing i can think of is the main dealers who have the right connectors and software to re set it all .sorry i havent been of any help

Aug 04, 2009 | BMW 318 Cars & Trucks

1 Answer

Central door lock and emergency button


i had this problem. I took the hazard and lock buttons out and took the white case inside out. One of the clips were broken so i taped it.

Jun 28, 2009 | 2000 BMW 3 Series

2 Answers

Hazard button and door lock button not working 325i 02


Your vehicle only has fuses behind the glove box. But since your central lock button is also inop. The your solution is to replace the switch assembly, it comes with both the hazard switch and the lock/unlock button. The removal of the switch assembly is pretty simple. it just pops up with some plastic body tool to pry on it.

Apr 01, 2009 | 2002 BMW 3 Series

1 Answer

I have a bmw 316ti compact on a 52 reg. The central locking gave up working 3mths ago and we was useing the key to lock and unlock the car,then all ov a sudden we couldnt start the car.when you put the...


with any BMW they have their problems, one is the central locking/immobilizer, the central locking is linked into the immobilizer and vice versa, the immobilizer takes it signal to disarm from the central locking and the ignition key ring. (chip in the key) if one of these starts to play up it has loads of consequences this being one of them. they all need to work together for the system to work properly. you would need to read the alarm and immobiliser codes using an ob2 tool that can detect them, and find the fault some problems it can be the drivers door sensor in the lock this is the main door as its drivers side and it controls all other doors on the central locking. if the switch is worn in any of it movements the system will not know the door has been opened, this does not work on the interior light as that is a switch in the door frame. the door lock is lock unlock and deadlock with key with remote fob its also arm disarm alarm and immobiliser. i have seen in some models there is a sensor auto lock so when you walk away with the key the doors lock automatically all lease parts work together. any one having a problem can cause no signal to be sent to the others in the system to start engine .

Jun 22, 2017 | BMW 318 Cars & Trucks

Not finding what you are looking for?
2001 BMW 330 Logo

660 people viewed this question

Ask a Question

Usually answered in minutes!

Top BMW Experts

Frankie B

Level 2 Expert

65 Answers

Fred Sops

Level 2 Expert

272 Answers

Doberman

Level 2 Expert

254 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...