Question about 1985 Oldsmobile Cutlass Supreme

Open Question

Have 1985 olds cutlass when at an idle engine stalls any solutions-thanks

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

csmock132
  • 4669 Answers

SOURCE: Can I install a 1985 Olds. Engine in an '87 Olds Salon?

Yes, it will go right in.

Posted on Mar 12, 2009

rad64us
  • 45 Answers

SOURCE: engine light is on for 1985 olds cutlass supreme.

Just find someone with the older type scanner it will tell you the code..I have them But I know that dosent help sorry

Posted on Jun 22, 2009

  • 2 Answers

SOURCE: My 1988 2.8L olds cutlass ciera stalls without

1- check for codes with scanner to see why check light coming on. 2 unbolt exhaust before caterlic convertor. Run car to see if still does it.If it does not the caterlic converter is the problem.the car temp should not go over 220 degrees. if car is getting to hot it will shut off,check cooling system and cooling fans to make sure they are comming on. Also if water is flowing through thermastat.Map sensor when gets hot could cut out. some places to look. doug

Posted on Aug 28, 2009

Testimonial: "It gave me something else to look at other the info I had. Thanks"

  • 1 Answer

SOURCE: unsteady idle rpm

i don't have a solution but have the same problem, stalls at traffic lights, replaced head gasket (blown) idles high to start, go to stop and if slow too quickly, stallsssssssssss

Posted on Jan 30, 2010

  • 1 Answer

SOURCE: 1990 Olds cutlass supreme 6cyl 3.1 engine; motor starter works ok

It is located at the back of the engine near the firewall.you will have to pull the engine forward to gain excess,Just disconnect the motor mount at the front of the engine and use some straps to bring it forward so that you will have room to reach it.I just replace the one i had on my 1990 olds cutlass supreme just last week.
Good Luck.

Posted on Feb 02, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Have 1999 olds intrigue idles fine but put it in gear and hit gas wants to stall untils you let of gas pedal then idles fine


Is the check engine light on ?
It could be a vac leak, faulty throttle position sensor, low fuel pressure, or other cause.

Aug 11, 2013 | 1991 Oldsmobile Cutlass Calais

2 Answers

My 93 olds cutlass ciera keeps misfiring and stalling, i have change the spark plugs, fuel filter, o2 sensor, maf sensor, and still stalls and misfires any ideas?


For engine misfiring problem check the help links mentioned below. Click the link below to go through the troubleshooting procedure :---- Engine misses and truck jumps? Hard to down shift? Issue with high gear only? http://technoanswers.blogspot.in/2012/02/engine-miss-and-truck-jumps-hard-to.html

-----------
Bad miss at idle?

http://technoanswers.blogspot.com/2012/01/bad-miss-at-idle.html

-----------
While stop engine idles like cylinder missing?

http://schematicsdiagram.blogspot.com/2012/01/while-stop-engine-idles-like-cylinder.html

------------
Engine Misfire codes for car?

http://schematicsdiagram.blogspot.com/2011/12/engine-misfire-codes-on-chevrolet.html
Engine Misfire codes?

http://schematicsdiagram.blogspot.com/2011/12/engine-misfire-codes-on-chevrolet.html

--------------
Misfire on cylinder 4?

http://schematicsdiagram.blogspot.com/2011/12/misfire-on-cylinder-4.html

-----------
Oil on spark plugs and car misfires?

http://technoanswers.blogspot.in/2012/02/oil-on-spark-plugs-and-car-misfires.html

----------

This will help.

Thanks.

Feb 14, 2012 | 1993 Oldsmobile Cutlass Ciera

2 Answers

My Oldsmobile Cutlass Ciera with the 2.5 will not stay running


What you should do when it stalls is check to see if your loosing spark at the plugs.If you are then you probably have a bad ignition module.It is located in the rear of the motor.The ignition coils are mounted on it.One other possibility is the pcm.It is located under the dash on the passengers side.You can get a used one at most salvage yards.You will need to get the number from the old pcm.You will also have to remove the old prom from the old pcm and install it in the one you get for replacement.Hope this helps.Good luck.

Jun 08, 2010 | 1989 Oldsmobile Cutlass Ciera

1 Answer

1991 Olds Cutlass Engine stalls and hesitates when pressing on the peddle. Sometimes will not crankover I'm thinkinking maf or egr First (not sure if that year has egr)


I might be able to help you on this. I will you two options
1.Sounds like your fuel mixture is too lean or breather pipes from inlet manifold are leaking or idle sensor valve faulty.
2. check your clutch sensor. It might be disconnected. this also leads to engine stalling problem

May 08, 2010 | Cars & Trucks

1 Answer

My 1993 cutlas supreme stalls randomly while idling or driving , but restart right away


You will need to change the crank position sensor first and see if it corrects the problem. It is located behind the engine near the firewall. It's a bit tricky to get to it, you would need to rotate the engine forward then look under the exhaust manifold and under the cylinder closest to the drivers side. Use a 10 mm deep socket to loosen bolt. After replacement and it is still stalling then you will need to replace the ECM (vehicle computer). If it turns out to be the computer, go to your local junkyard to get an inexpensive replacement Click on the link below to view the CPS, it is around $22

http://www.partstrain.com/store/?N=0&Nr=AND(make:Oldsmobile,model:Cutlass+Supreme,year:1993,brand:Delphi,part:Crank+Position+Sensor)&ptc=S1171391678W45d204bec356b&ptid=ptc45891f6tnywz&id=Olqtv7cphi





Olds-Cutlass-Ciera.htm">http://en.allexperts.com/q/Oldsmobile-Buick-Repair-826/f/1992-Olds-Cutlass-Ciera.htm

Apr 12, 2010 | 1993 Oldsmobile Cutlass Supreme

2 Answers

Unsteady idle rpm


the timing is problably off. you need a timing light and you need to get the correct specs and time it accordingly

Dec 20, 2009 | 1988 Oldsmobile Cutlass Ciera

3 Answers

Will a faulty E.G.R.valve on a 1988 Olds.Cut.Sup.FWD cause a hot engine to stall when stopping at corners?


well it will casue it to stall if the egr is stuck open and you stop at a light or stop sign,due to it beinge stuck open the open egr valve acts like a vacum leak,,,,ive also seen bad fuel pumps and fule filter to cause a stall while hot and cornering

Oct 07, 2009 | 1988 Oldsmobile Cutlass Supreme

4 Answers

1990 Olds cutlass supreme 6cyl 3.1 engine; motor starter works ok


1990 OLDSMOBILE 3.1 6 CYLINDER ENGINE I WOULD LIKE TO KNOW LOCATION ON ENGINE WHARE CRANKSHAFT POSITION SENSOR IS LOCATED

Jun 12, 2009 | 1990 Oldsmobile Cutlass Supreme Conv

Not finding what you are looking for?
1985 Oldsmobile Cutlass Supreme Logo

Related Topics:

60 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...