Question about 1995 Buick Century

1 Answer

RADDATOR BOTTLE REMOVAL

I NEED TO REPLACE MY RESERVOL BOTTLE FROM THE RAIDATOR TO ENGINE. tOP PLASTIC PART IS CRACKED.hOW DO i TAKE OFF THIS PART?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 10,865 Answers

Hello. Look carefully and you will see that it is bolted to the frame. J.

Posted on Jul 10, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

What is the best way to refill a sealed radiator unit for 1998 ford f150


When engine cold, Unscrew the radiator cap on the expansion bottle and top up the coolant level to the minimum level marker, then replace the radiator cap.

Nov 22, 2015 | 1998 Ford Contour

1 Answer

Have a 2004 KIA sedona blows warm air but not hot squeese the lower raidator hose and heat gets better for short time then goes back to just warm air what could problem be


As you have tried topping up, I would suggest WHEN the engine is cold you open the water cap that is on the engine block near the back left hand side, DO NOT OPEN WHEN HOT (it probably says that on the cap) try filling the system here, because this is a place where the system can airlock which could be your problem, it might take a bit to fill it because it will go down if your pipes are empty, (you cant circulate air with a water pump) squeeze the pipes at the same time, this needs to be full to the top, while you have this open you can start the engine and watch to see if there is any circulation, top up again if needed, watch your header bottle level. if the water is circulating then it should heat up ok. When full put the cap back on quickly and make sure you have water in your header bottle. if it doesn't heat up after this, then it is quite possibly your water pump, although if the engine is not overheating then I doubt that it is this. Other than that I would be checking for blocked heater pipes or radiator. You haven't said if you are losing water or not, but if you are then I would be checking the pipework that runs from the bulkhead all the way to the rear heater as they rot. I hope I have helped you a little.

Feb 11, 2015 | 2004 Kia Sedona

1 Answer

I have a porsche cayenne 2005.. it start, idle, shake and turn off.


I had what seems to be the exact problem. It sounds like the spark plugs need replacing or the coils over the spark plugs have cracked. Don't try to replace just one and while you're in the process of removing them you might as well replace the plugs too. If you've already done this, I'm not sure what your next step would be, slight of putting it on a montor. You need to remove the plastic shrouds around the engine. Undo the engine mount so the silver plastic covers can be removed on both sides. You'll also have to remove the black plastic covers over the wiring harness on top of the engine at te front. They just snap off. Each coil has a small screw holding them in place. Good luck.

Oct 17, 2014 | 2005 Porsche Cayenne

1 Answer

I have a obsolete but modern-ish Whirlpool water cooler. The white plastic ring the 5 gallon water bottle sits on is cracked, and chunks are coming off. Whirlpool doesn't stock parts for old model


The collar is only there to keep the bottle at the correct height in relation to the water in the cooler. The principle is that when the vacuum inside the bottle is not being release by the water clearing the opening no more water will run out. To understand what I mean fill up a bottle ( any old bottle) right to the top. Fill up the sink and with you finger over the top of the bottle place the bottle upside down in the water. Take you finger from the hole and it will glug once maybe twice then no more water will run out until you lift the bottle out of the sink water. To stop more running out simply put the neck of the bottle bac in the sink. It is the same with you water cooler bottle. So all you need to do now is to to cover the foam with a piece of vinyle and it will be fixed.

Mar 08, 2013 | Cars & Trucks

2 Answers

How do i bleed my thermostat on a 2002 buick century custom


RUN ENGINE FILL WITH ANTIFREEZE AND THERE IS A BLEEDER SCREW ON BYPASS LINE/HOSE ON TOP OF ENGINE NEAR BELT. THERE MAY ALSO BE A BLEEDER ON THE THERMOSTATE HOUSING. CRACK OPEN BLEEDERS UNTIL ALL AIR COMES OUT.

Dec 19, 2010 | 2002 Buick Century

1 Answer

How do you remove the headlight bulb


  • Take the keys out of the ignition and switch the headlights off. Then, open the hood using the primary and auxiliary release latches.
  • 2 Use a socket wrench to remove the two 10mm bolts holding the coolant overflow bottle in place. Pull the bottle out of the engine compartment and set it on the ground (passenger's side bulb replacement only.)
  • 3 Undo the bolt at the top of the air filter box, lift the top open and remove the filter from the engine compartment. Then, undo the fasteners holding the air dam in place and remove it from the filter box (driver's side bulb replacement only.)
  • 4 Pull the entire air box out of the car to access the backside of the headlight assembly.
  • 5 Turn the bulb socket counterclockwise to remove it from the assembly. Then, release the retaining spring, undo the electrical connector and carefully remove the old bulb from the socket.
  • 6 Hold the new bulb by its plastic base and insert it into the socket. Reattach the electrical connector and replace the retaining spring.
  • 7 Switch the headlights on to test the new bulb. If it works, reinstall the air box or coolant bottle and close the hood



  • Dec 04, 2010 | 2000 Nissan Altima

    2 Answers

    2002 LS: aHow do I fill radiator in my V8 Lincoln LS...


    First- to drain ,you can reach the drain valve,from the pass side,if you lay on the ground and reach up to the radiator. You do not even have to raise the vehicle up
    Second- mix Yellow GO5 Coolant about 50/50 or 60/40. Do not use Green in a Ford or Orange GM
    To Fill- Remove the front two plastic screw type buttons,from the engine cover
    -Remove the cover
    The radiator cap is on the front of engine,on top,it is plastic
    Remove cap and that is your fill point
    Run engine to warm and get thermostat open,as you would with any vehicle
    Top off coolant,replace cap
    VERY IMPORTANT-next to the Power Brake Booster,and just under it,is a BLEEDER HOSE;to let air out of system. Turn screw slot ,only a little,DO NOT REMOVE SCREW. When coolant runs out close.
    Fill-Degas Bottle,to full line,with coolant.
    Check the next couple days on resevoir level ( Degas Bottle)

    May 06, 2010 | 2002 Lincoln LS

    1 Answer

    Radiator leak


    I would check the plastic overfull bottle on the passenger side fender well for cracks. Those are know for the plastic bottle to crack. Replacements run as low as $30.00. Also check below the water pump and any hoses for leaks.

    Apr 27, 2010 | 1999 Ford Taurus

    1 Answer

    WHERE DO I PLACE THE ANTI FREEZE OR COOLANT


    There is a raidator cap that can be unscrewed when the engine is cold fill this to the top then there will be an overflow bottle and it will say engine coolant on the cap, fill this to the full mark and you should be on your way :)

    Apr 07, 2010 | 2001 GMC Sonoma Extended Cab

    1 Answer

    Windsheild wash tank leaks. had frozen. probably cracked. how to remove?


    no need to replace save money sand round the crack cover with plastic from a bottle then seal using an external mastic

    Feb 27, 2010 | 1999 Chevrolet Silverado 1500

    Not finding what you are looking for?
    1995 Buick Century Logo

    Related Topics:

    24 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Buick Experts

    yadayada
    yadayada

    Level 3 Expert

    75822 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22156 Answers

    Jeff Turcotte
    Jeff Turcotte

    Level 3 Expert

    8202 Answers

    Are you a Buick Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...