Question about Jeep Grand Cherokee

1 Answer

Gages and window inop starts and stall right out

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Expert
  • 4,070 Answers

Hi! May I ask if the battery is good? WHen the battery is weak this can cause power failure like windows is hard to go up that when forced other electrical accesories will fail including the gauges and radio. Please try swapping the battery and observe how it goes. Hope this helps and have a good one!

Posted on Jul 18, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 09 Ford Focus 2.0 it starts fine but after 3 sec it stalls and dies,I have checked the fuel pump,coils,crank sensor. Do you have any ideas


Hook up a fuel pressure gage to the fuel pressure test port on the engine (rent or borrow, make sure you get the right test gage), see if the fuel pressure shuts off when the engine starts to stall. Also do an OBD2 fault code test on the engine control module, it requires a code reader or if you have a nearby Autozone they will read the codes for free.

May 17, 2017 | Ford Cars & Trucks

1 Answer

Honda problem


03 honda, no engine sizes stated, OUCH!
nice guessing , and never needed on those 2 sensors the PCM tells you at all times if they are good or bad with an y OBD2 scan tool made.
this is a STALLS post.
so can your right foot save the stall.? yes/no.?????
this is the #1 top best free test, that works on all cars.
#1

stalls are caused by 2 things.
1: engines is misfiring badly, the PCM will try hard to prevent the stall, if it fails to do that it means its very very sick.
2: ISC stuck closed or inop, or just dirty.

#1 has 50 causes.. and about 1 to 10 tests top find them
do you want to guess 48 more times. (2 down)
???/

or Test?
its your choice.

Jul 14, 2014 | 2003 Honda Civic

1 Answer

Fuel gage fuse


The fuel gage shares the same fuse as all the gages, so if the fuel gage is inop and all other gages are working then you have another problem. The most common cause is that the sending unit for the fuel gage inside the fuel tank is defective, that is true 99% of the time in my 35 years of repair work.

Jan 20, 2012 | Ford F-250 Cars & Trucks

1 Answer

"Check Gages" light on, no speedo or tach operation.


pull the shifter down to first when you stop then put shifter back into drive when you start to move...

Dec 24, 2009 | 1998 Chevrolet C1500

1 Answer

Car stalls


sounds like water in the fuel line. HEET water remover or STP fuel injector cleaner on your next fill up should solve this problem

Sep 07, 2009 | 2005 Audi A4

2 Answers

Fuel gage jumping around and truck stalling out


go to the battery follow the cable that dose not go to the starter the other cable will go to hard piont that is the feed for the fuse box check that connection

Jan 23, 2009 | 1997 GMC Jimmy

1 Answer

Stalling on 1990 Caprice


THERE IS A TEMP SENSIBLE DEVICE IN AIR INTAKE THAT SWITCH FOR TAKE AIR FROM THE EXHAUST AMNIFOLD BECAUSE IS A LITTLE HOTTER. THIS VALVE MUST BE INOPERATIVE

Dec 26, 2008 | 2004 Pontiac Grand Am

1 Answer

Honda accord 1996 v6 2.7 liter,rpm gage jump up and down


Here is the most common cause of surges and stalls, it is the idle speed control air-bypass valve and throttle valve, they get full of gunk over the miles and cause idle issues (stalls) like yours, Get a can of intake cleaner from any local parts store, not carb spray, intake cleaner, it is made by a company called CRC, remove the air intake hose to the engine, hold the idle high so the engine won't stall, then spray the can of cleaner into the intake while keeping the engine running, use at least 1/2 the can, shut down the engine and disconnect the battery for 5 minutes, then restart and complete a number of mixed driving cycles, town, freeway, stop and go etc., after a few days the problem will go away as the system will relearn to the clean intake.

Nov 28, 2008 | 1996 Honda Accord

1 Answer

97 s-10 turns over, but won't start


yeah that definitely sounds like the ignition switch went out. Had almost the same thing happen, along with alot of transmission error codes. I replaced the ignition switch harness and she purred like a kitten.

Jul 08, 2008 | 1997 Chevrolet S-10 Pickup

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...