Question about 1994 Buick Park Avenue

1 Answer

All my body mouns are gone can i replace - 1994 Buick Park Avenue

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Master
  • 10,319 Answers

They can be purchased at any General Motors pARTS DEPARTMENT

Posted on Jul 10, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

C200 CDI 2004 diesel Have fault no. P1408 diagnosed but dont know what it is

p1408 is==manufacture control auxiliary emission controls which means that it refers to egr system, it may be a loose wire or it needs taken off and cleaned or replaced. if taken off and cleaned make sure carbon is removed at engine where it moun ts. have a good day !! check for egr vacuum hose break etc.

Nov 01, 2010 | 2007 Mercedes-Benz C230 Sedan

1 Answer


the fan clutch is electronic and has most likely gone bad we replace them at work on a regular basis also this vehicle is bad for throttle body coking large amount of carbon build up at the throttle plate and should be cleaned good replacing the fan clutch and a throttle body service will take care of your problems

Oct 19, 2010 | 2003 GMC Envoy

1 Answer

The car shiuts off during mid drive completly then starts back up after a few minutes. Beore it shuts off you can not accelerate then it shuts off and lose power steering

In this situation, we start with the easy solutions which is to check each fuse in the fuse box is installed tight. Also with the engine on, wiggle each fuse and see if it affects engine in any way. If it does the fuse may not be tight in its socket. Do the same with the relays located in underer the hood in a platic box at the driver's side. Make sure they are tight in their socket and wiggle them with the engine running. Do the same for any wiriing harness connections you see. Wear gloves, no jewelry, or loose clothing when you do this. If everything is okay, then it is most likely your fuel filter. You can do fuel pressure test to verify you are getting enough pressure.

To change the fuel filter, you will either have to disconnect the fuel pump relay or the fuel pump harness to depressurize the fuel system. Under the driver side door underneath the car, you will find the fuel pump clamped to the body. Remove the mouning blots and unscrew the clips from the fuel line. Keep note of the arrow direction and replace with a new fuel pump. Thanks for using Fixya.

Aug 27, 2010 | Lincoln Navigator Cars & Trucks

1 Answer

The idle has an intermittant stumble

Your Idle Air Control (IAC) valve may be dirty with carbon, simple fix with throttle body cleaner through the IAC passageway through the throttle body. Make sure it's throttle body cleaner and not carburetor cleaner, the carb cleaner is to corrosive to the gaskets used on the throttle body.
If cleaning the IAC does not help, then it's a good chance that the IAC is to far gone and will need to be replaced.
Good luck and thank you for using fixya

Jun 01, 2010 | 2002 Saturn L-Series

1 Answer

My 1998 vw is getting less mileage per gallon, and my check engine light is on. I scanned it and the code came up that the throttle body control module needs fixed or replaced. Oh yes and the oil light...

yes it will!! you have issues with the tps and air flow valve on the throttle body also you may have to use a code tool to reset all that once the unit is replaced to insure proper throttle response and speed controll through the ECM to the new unit

Jan 15, 2010 | 1998 Volkswagen Jetta

1 Answer

Mi s 10 96 star only wen put a little moun of gas in the carburator (i change the cranck sensor and the gas pump) but no work

well that is not a carb but a fuel injection throttle body. have you changed the fuel filter? also check for any codes in the computer by having it scanned. this will help in diagnosing the problem.give me a shout back thanks

Oct 31, 2009 | 1996 Chevrolet S-10 Pickup

1 Answer

Wont start

check the ignition switch. pull covering off of the column and check switches wires,
reds - should have +12 battery power
white - Ignition output
pink - ignition output
yellow - starter output

these wires are needed to start car.

from the switch the starter wire goes to and neutral position switch. located on transmission. yellow is starter in purple is starter output. if all that is good change the relay moun about the radiator. good luck

Sep 24, 2009 | 1998 Chevrolet Cavalier

2 Answers

Dodge Dynasty Motor mount?????

You need to be looking for lower transmission mounts NOT rear engine mounts. (tell the a**hole mechs to ... well you know).

Jun 19, 2009 | 1989 Dodge Dynasty

1 Answer

Rear stut moun

2 nuts and the big one is the center , dont loosen that one

Jul 21, 2008 | 2002 Chrysler Sebring

Not finding what you are looking for?
1994 Buick Park Avenue Logo

Related Topics:

19 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts


Level 3 Expert

76673 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides