Question about 2005 Ford Explorer Sport Trac
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Above is correct, some body panels are interchangeable some aren't...Headlights, front fenders, hood yes. Doors unsure, bed and back no (obviously). The underpinnings (suspension) are similar, but not exact...and depending on the year, the Explorer went to independent rear suspension, while the sport trac kept the solid axle differential.
Posted on May 15, 2008
You may want to check the relay that goes to the primary window. This will provide support to all the other windows. However, it may not just be the window relay, it could possibly be that between your window relay and your main switch there is a short or cut wire that is causing this problem. Unfortunately, you may need to visit your Ford Dealership to run a diagnostic on your wire or if you know an electronic shop that can run one to see if it is receiving and sending power. Have them check the main door fuse and window assembly to see that you are getting power.
Posted on Mar 19, 2009
Press and hold the SELECT/RESET
control switch to select SYSTEM
CHECK when “SYSTEM CHECK /
HOLD RESET” is displayed in the
message center. Selecting this
function from the SETUP MENU
causes the message center to cycle through each of the systems being
monitored. For each of the monitored systems, the message center will
indicate either an OK message or a warning message for two seconds.
Pressing the SELECT/RESET control switch cycles the message center
through each of the systems being monitored.
The sequence of the system check report and how it appears in the
message center is as follows:
1. OIL LIFE RESET
2. CHARGING SYSTEM
3. WASHER FLUID
4. DOOR AJAR
5. EXTERIOR LAMP
6. BRAKE SYSTEM
7. PARK BRAKE
8. MILES TO EMPTY
9. FUEL LEVEL LOW (will only display if 50 miles or less to empty)
To reset the oil monitoring system to 100% after each oil change
[approximately 5,000 miles (8,000 km) or 180 days] perform the
1. Enter SYSTEM CHECK to display
“OIL XXX% RESET IF NEW”.
2. Press SELECT/RESET control
switch to display “HOLD RESET IF
3. Press and hold the
SELECT/RESET control switch for
more than 2 seconds. Oil life is set
to 100% and “OIL CHANGE SET TO
100%” is displayed.
Posted on Apr 02, 2009
It is a very plain code it has something to do withthe drivers side seat belt buckle. Either out of range short to power or ground etc. Need a more specfic code to pnpoint exact problem but I can tell ya it is in your drivers seat belt connection somewhere
Posted on Apr 11, 2009
They will not loan you the tools.....how else will they continue to rip off the average garage junkie and make lots of money?
Posted on Nov 18, 2009
Tips for a great answer:
Mar 09, 2018 | Ford Cars & Trucks
Jan 10, 2016 | 2001 Ford Explorer Sport
Jul 24, 2012 | 2005 Ford Explorer Sport Trac
Feb 13, 2012 | 2005 Ford Explorer Sport Trac
Apr 30, 2011 | 2005 Ford Explorer Sport Trac
Apr 01, 2010 | 2005 Ford Explorer Sport Trac
Feb 21, 2010 | 2005 Ford Explorer Sport Trac
Sep 24, 2009 | 2005 Ford Explorer Sport Trac
133 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: