Question about 2005 Dodge Dakota
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
To change the sparks on a 2005 4.7L Dodge Dakota you will need the following:
Note you will have to remove the air intake located at the top of the engine, and will have to move some of the coolant lines out of the way.
At the top of the engine there are 4 sparks on each side. The coils are held in place with a 10mm bolt. Undo the 10mm bolt and unclip the coil. Next pull out the coil.
Insert the socket, with extension into the spark plug hole.
Remove spark plug.
Check the gap on new spark plug, it should match stock.
tighten to approximately 25ft.lbs. (check spark-plug packaging for exact torque requirements).
repeat this process with all other sparks.
be sure that no dirt gets into the spark plug holes.
Posted on May 11, 2009
Remove independent coil from each spark hole,and then remove sparkplugs with a socket with extention.
Posted on Jun 09, 2008
SOURCE: changing spark plugs
look under hood..you will see wires coming from distributor cap on top into your motor..if its an 8 cylinder there will be 4 in the back and 4 in the front.6 cylinder-3 in front 3 in back.get a 5/16 spark plug wrench and socket.you will need extension to reach back ones.if you bought new wires from parts store it will be even easier to find where plugs are located because you can compare the ones you bought and easier find the wires under the hood.the wire gets fatter as it goes into the motor.grab the fat part firmly and pull it off.boom theres your spark plugs.use your spark plug socket(5/16) with extension/ratchet and turn the plug until it comes out.do not break the plug or it will not come out.when you put a new one in screw it hand tight then 1 crank tight with the ratchet.when you change your wires do them one at a time as to avoid switching the wires up.on top of the distributor cap(where the wires lead to) there will be numbers as to what wire is for what cylinder...change plugs/wires 1 at a time dont take off more than 1 wire at a time!hope this helped!
Posted on May 29, 2009
Tips for a great answer:
Oct 28, 2015 | 2000 Dodge Dakota Quad Cab
Mar 11, 2010 | 2005 Dodge Dakota
Feb 26, 2010 | 2005 Dodge Dakota
Jun 24, 2008 | 2005 Dodge Dakota
Jun 04, 2008 | 2004 Dodge Dakota
285 people viewed this question
Usually answered in minutes!